A Plug-and-Play High-Pressure ESI Source with an Emitter at Ground Potential and Its Application to High-Temperature Capillary LC-MS

Generation of Ions from Aqueous Taylor Cones near the Minimum Flow Rate: "True Nanoelectrospray" without Narrow Capillary

Generating ultrafine charged droplets using electrospray is crucial for attaining high ionization efficiency for mass spectrometry. The size of the precursor charged droplets depends on the spray flow rate, and conventional wisdom holds that an electrospray of a nL/min flow rate (nanoelectrospray) is only possible using narrow capillaries with an inner diameter of ∼1 μm or smaller. Here, the electrospray of aqueous solutions with high electric conductivities generated from a large off-line capillary of 0.4 mm i.d. has been performed using a high-pressure ion source. The electric discharge is avoided by operating the ion source at 2.5 bar gauge pressure. The highly stable Taylor cone can be tuned to a near-hydrostatic state that exhibits the "true nanoelectrospray" properties, i.e., high salt tolerance and minimal ion suppression. The Q^1/2 scaling law describing the electrospray current I and flow rate Q is found to be valid down to the nanoflow regime under a condition that is free of electric discharge. For a given solution, the flow rate and the size of the initial droplets and ionization species can be controlled with the spray current as the indicator for the instantaneous flow rate without changing the emitter capillary of different sizes. In regard to the application, the nanoelectrospray with a large micropipette tip is easy to use, free of clogging when dealing with viscous and high-salt buffer solutions, and with reduced surface interaction with the emitter inner surface. An acquisition of very clean mass spectra of proteins from concentrated solutions of nonvolatile salts such as phosphate-buffered saline is demonstrated.

Electrospray Ionization Inside the Ion Inlet Tube: Multijet Mode Operation

We investigated the electrospray ionization inside the narrow channel of the ion inlet tube. An insulating emitter capillary made of fused silica with a 0.2 mm outer diameter was inserted into the ion inlet tubes with a 0.5 and 0.6 mm inner diameter to aspirate all the charged droplets. A custom-made ion inlet tube with two side holes near its entrance is used to observe the spraying condition. The spray current is measured and monitored during the MS acquisition using isolation amplifiers. Because the emitter is cylindrically surrounded in close proximity by the metallic inner wall, it is difficult to obtain a stable and symmetric Taylor cone with its apex at the center of the emitter. Instead, a stable operation under a flow rate of 1-4 μL/min is found to be in the form of a multicone-jet mode with two or more Taylor cones anchoring around the rim of the emitter. The emitted charged droplet jets are dragged from hitting the wall by the fast-flowing air inside the inlet tube. Comparison with the typical cone-jet and multijet mode operated several millimeters outside the inlet capillary shows signal enhancements for protein standards.

High-pressure ESI-MS made easy using a plug-and-play ion source and its application to highly conductive aqueous solutions

The performance of a compact high-pressure electrospray ionization (HP-ESI) source that can be readily used for commercial atmospheric pressure ionization (API) mass spectrometers is reported. The ion source employs a converging-diverging outlet nozzle, and ions/droplets generated inside the high-pressure compartment are carried by the high-velocity air jet toward the mass spectrometry (MS) ion inlet placed under the atmospheric pressure. With the use of a shielding electrode, the HP-ESI can also be operated with its emitter held at ground potential. This feature prevents the flow of current from the emitter to other electrically grounded components and facilitates the connection of ion source to liquid chromatography (LC) columns or capillary electrophoresis. Sensitive detection of proteins from highly conductive aqueous solutions such as 0.1% trifluoroacetic acid (TFA) solution and the prevention of electrochemical artifacts by the grounded emitter operation are demonstrated.