Miniaturized String Sampling Probe and Electrospray Extraction/Ionization within the Ion Inlet Tube for Mass Spectrometric Endoscopy

Miniature mass spectrometers and their potential for clinical point-of-care analysis

Mass spectrometry (MS) has become a powerful technique for clinical applications with high sensitivity and specificity. Different from conventional MS diagnosis in laboratory, point-of-care (POC) analyses in clinics require mass spectrometers and analytical procedures to be friendly for novice users and applicable for on-site clinical diagnosis. The recent decades have seen the progress in the development of miniature mass spectrometers, providing a promising solution for clinical POC applications. In this review, we report recent advances of miniature mass spectrometers and their exploration in clinical applications, mainly including the rapid analysis of illegal drugs, on-site monitoring of therapeutic drugs, and detection of biomarkers. With improved analytical performance, miniature mass spectrometers are also expected to apply to more and more clinical applications. Some promising POC analyses that can be performed by miniature mass spectrometers in the future are discussed. Lastly, we also provide our perspectives on the challenges in technical development of miniature mass spectrometers for clinical POC analysis.

Performing 2D-1D-2D Mass Spectrometry Imaging Using Strings

The mass spectrometry imaging (MSI) technique is widely used in several fields due to its ability to provide spatial information of samples. However, for existing MSI methods, the sample is typically placed on a two-dimensional (2D) platform and is scanned back and forth. As a result, the platform size limits the imaging size. This paper proposes a new MSI method that involves the initial imprinting of chemicals on a two-dimensional string plane area. The string plane was then unraveled to a one-dimensional (1D) string, and the chemicals imprinted on it were ionized using a lab-made ion source. Finally, a 2D MSI image was reconstructed through data processing (2D-1D-2D mass imaging). Compared with traditional MSI methods, the imaging size is no longer limited by the platform size, making it possible to perform the MSI of large samples. As proof of concept, this method was used to image an intact seedling of Broussonetia papyrifera. As a result, clear and overall MS images were obtained, demonstrating the ability of this method to analyze large samples.

Electrospray Ionization Inside the Ion Inlet Tube: Multijet Mode Operation

We investigated the electrospray ionization inside the narrow channel of the ion inlet tube. An insulating emitter capillary made of fused silica with a 0.2 mm outer diameter was inserted into the ion inlet tubes with a 0.5 and 0.6 mm inner diameter to aspirate all the charged droplets. A custom-made ion inlet tube with two side holes near its entrance is used to observe the spraying condition. The spray current is measured and monitored during the MS acquisition using isolation amplifiers. Because the emitter is cylindrically surrounded in close proximity by the metallic inner wall, it is difficult to obtain a stable and symmetric Taylor cone with its apex at the center of the emitter. Instead, a stable operation under a flow rate of 1-4 μL/min is found to be in the form of a multicone-jet mode with two or more Taylor cones anchoring around the rim of the emitter. The emitted charged droplet jets are dragged from hitting the wall by the fast-flowing air inside the inlet tube. Comparison with the typical cone-jet and multijet mode operated several millimeters outside the inlet capillary shows signal enhancements for protein standards.