HAI-RTP determination of carbaryl pesticide in different irrigation water samples of south Spain

Determination of carbaryl in natural water samples by a surface plasmon resonance flow-through immunosensor

The analysis of carbaryl in natural water samples was accomplished using a portable immunosensor based on surface plasmon resonance (SPR) technology. The assay was based on a binding inhibition immunoassay format with the analyte derivative covalently immobilized on the sensor surface. An alkanethiol self-assembled monolayer (SAM) was formed onto the gold-coated sensor surface to allow the reusability of the same sensing surface during 220 regeneration cycles. Reproducibility was evaluated by performing three independent assays in triplicate on 3 different days. The batch-assay variability was also calculated using three different gold-coated sensor surfaces. The intra- and inter-day relative standard deviation were 8.6 and 15.3%, respectively, whilst a variation of 7.4% in assay sensitivity was obtained by employing different sensor chips. The lowest detection limit, calculated as the concentration providing a 10% decrease of the blank signal, was of 1.38 microg L(-1). Matrix effects were also evaluated in different water types, showing I50 values (carbaryl concentrations that produced a 50% decrease of the blank signal) within the range of carbaryl standard curves in distilled water (2.78-3.55 microg L(-1)). The carbaryl immunoassay performance was validated with respect to conventional high-performance liquid chromatography-mass spectrometry (HPLC-MS). The correlation between methods was in good agreement (r2 = 0.998, 0.999 and 0.999) for the three types of natural water samples tested. A complete assay cycle, including regeneration, is accomplished in 20 min. All measurements were carried out with the SPR sensor system (beta-SPR) commercialised by the company SENSIA, SL (Spain). The small size and low-time of response of the beta-SPR platform would allow its utilization in real contaminated locations.

Comparison of properties on non-protected fluid room temperature phosphorescence of some tetra-ring aromatic hydrocarbons

A comparative study of the photoluminescence properties of three kinds of tetra-ring aromatic hydrocarbon (1-sodium pyrenesulphonate, benz[alpha]anthracene and chrysene) solution in the absence of any protecting medium is described. It was found that a room temperature phosphorescence signal with different intensities can be induced for these solutions, using only TlNO3 or KI as a heavy atom perturber (HAP) and Na2SO3 as a deoxygenator. An appropriate amount of organic solvent added to the systems of pyrene, benz[alpha]anthracene and chrysene is necessary for increasing the solubility and phosphorescence intensity, and the preferable solvent is acetonitrile. For the pyrene, pyrenesulphonate and chrysene systems, a delayed excimer fluorescence accompanied with the room temperature phosphorescence (RTP) emission can be observed, but that for benz[alpha]anthracene cannot. The ratio of delayed excimer fluorescence and phosphorescence signals for pyrene, pyrenesulphonate and chrysene systems can be controlled by adjusting the concentration of luminophor, kinds and amount of both organic solvents and HAP. Under the optimal conditions, the RTP signals are proportional to the concentration of the four aromatic hydrocarbons, which means that the RTP properties of the four tetra-ring aromatic hydrocarbons can be used for quantitative analysis.

Simple determination of the herbicide napropamide in water and soil samples by room temperature phosphorescence

A new, simple, rapid and selective phosphorimetric method for determining napropamide is proposed which demonstrates the applicability of heavy-atom-induced room-temperature phosphorescence for analyzing pesticides in real samples. The phosphorescence signals are a consequence of intermolecular protection and are found exclusively with analytes in the presence of heavy atom salts. Sodium sulfite was used as an oxygen scavenger to minimize room-temperature phosphorescence quenching. The determination was performed in 1 M potassium iodide and 6 mM sodium sulfite at 20 degrees C. The phosphorescence intensity was measured at 520 nm with excitation at 290 nm. Phosphorescence was easily developed, with a linear relation to concentration between 3.2 and 600.0 ng ml(-1) and a detection limit of 3.2 ng ml(-1). The method has been successfully applied to the analysis of napropamide in water and soil samples and an exhaustive interference study was also carried out to display the selectivity of the proposed method.

Highly sensitive and selective room-temperature phosphorescence determination of thiabendazole by the supramolecular interaction of thiabendazole/β-cyclodextrin/triton X-100

A strong and stable room temperature phosphorescence (RTP) signal (lambda(ex)/lambda(em) = 298/481 nm) resulting from a 1:1:1 beta-cyclodextrin (beta-CD)/thiabendazole (TBZ)/triton X-100 (TX-100) supramolecular ternary inclusion complex was induced by KI as a heavy atom perturber. Based on the heavy-atom induced RTP, a new phosphorescence method for TBZ determination was established. The analytical curve of TBZ gave a linear range of 20-820 ng mL(-1) with a detection limit and relative standard deviation of 2.1 ng mL(-1) and 1.9%, respectively. The interference of 46 coexisting substances was studied. Compared with the method using a chemical oxygen scavenger, this method is simpler as deoxygenation of the solution is not required. The detection limit and the heavy-atom concentration of the proposed method were decreased about 8 and 4 times, respectively. The lifetime of the phosphorescence was prolonged 9 times and the pH range was greatly broadened. The proposed method has been successfully applied to the determination of TBZ in tap water, lake water and pineapples.

Simple determination of propranolol in pharmaceutical preparations by heavy atom induced room temperature phosphorescence

The applicability of heavy atom induced room temperature phosphorescence in real samples is demonstrated in this work. In this methodology only two reagents, potassium iodide as heavy atom salt and sodium sulphite as oxygen scavenger, were used to obtain phosphorescent signal of propranolol in solution. Thus a new simple, rapid and selective phosphorimetric method is proposed for propranolol determination in pharmaceutical preparations. The phosphorescence intensity was measured at 492 nm exciting at 294 nm. Phosphorescence was fully developed instantly, obtaining a linear concentration range between 0 and 500 ng ml(-1) with a detection limit of 14.4 ng ml(-1), an analytical sensitivity of 6.7 ng ml(-1) and a standard deviation of 1.4% at a 300 ng ml(-1) concentration level. The method has been successfully applied to the analysis of propranolol in an antidepressive pharmaceutical preparation and it was validated using standard addition methodology.