Polymer-assisted solution-phase library synthesis and crystal structure of alpha-ketothiazoles as tissue factor VIIa inhibitors

Immobilized Carbodiimide Assisted Flow Combinatorial Protocol to Facilitate Amide Coupling and Lactamization

Through a screen of over one hundred and 30 permutations of reaction temperatures, solvents, carbodiimide resins, and carbodiimide molar equivalences, in the presence, absence, or combination of diisopropylamine and benzotriazole additives, a convenient and first reported carbodiimide polymer-assisted flow approach to effect amide coupling and lactamization was developed. The protocol entails injecting a single solution (1:9 dimethylformamide: dichloromethane) containing a carboxylic acid and an amine or linear peptide sequence into a continuous stream of dichloromethane. The protocol remained viable in the absence of base, did not require carboxylate preactivation which, and in concert with minimal workup requirements, enabled the isolation of products in high yields. Compared to the utilization of untethered carbodiimide reagents, the flow procedure was also observed to provide a degree of racemization safety.

Immobilized coupling reagents: synthesis of amides/peptides

The primary idea of using immobilized reagents in organic synthetic chemistry is to simplify the downstream process, product workup and isolation, and therefore avoiding time-consuming and expensive chromatographic separations, which are intrinsic to every synthetic process. Numerous polymer-bounded reagents are commercially available and applicable to almost all kinds of synthetic chemistry conversions. Herein, we have covered all known supported-coupling reagents and bases which have had a great impact in amide/peptide bond formation. These coupling reagents have been used for the activation of a carboxyl moiety; thus generating an active acylating species that is ready to couple with an amine nucleophile liberating the amide/peptide and polymeric support which can be regenerated for reuse. This also addresses a large variety of anchored coupling reagents, additives, and bases that have only been employed in amide/peptide syntheses during the last six decades.

Discovery methodology for the development of direct factor VIIa inhibitors

INTRODUCTION

Heparin and warfarin have historically been the only antithrombotics available. Recently, however, newer anticoagulants have been developed. Factor VIIa (fVIIa) inhibitors represent one of the new and potentially exciting classes of anticoagulants currently under development. Indeed, several methodologies have been used to develop fVIIa inhibitors.

AREAS COVERED

The authors highlight some of the methologies applied for the discovery of fVIIa inhibitors including phage display, isolation of endogenous peptides from hematophagous animals and the use of the 1,5-benzothiazepine molecular scaffolds and screens of large chemical libraries previously used to identify other serine protease inhibitors. Although these screens were intended to identify thrombin and factor Xa inhibitors, the compounds often had concomitant fVIIa activity. The authors also discuss the utilization of medical chemistry techniques for the discovery of these compounds.

EXPERT OPINION

FVIIa inhibitors represent a viable option for the development of new anticoagulants. There are theoretical advantages that fVIIa inhibitors may possess over existing anticoagulants and highly specific inhibitors that possess oral bioavailability and low bleeding risk may succeed.

Design, synthesis, and biological evaluation of pyrazinones containing novel P1 needles as inhibitors of TF/VIIa

Herein is described the design, synthesis, and enzymatic activity of a series of substituted pyrazinones as inhibitors of the TF/VIIa complex. These inhibitors were designed to explore replacement and variation of the P1 amidine described previously [J. Med. Chem.2003, 46, 4050]. The P1 needle replacements were selected based upon their reduced basicity compared to the parent phenyl amidine (pKa approximately 12). A contributing factor towards the oral bioavailability of a compound is the ionization state of the compound in the intestinal tract. The desired outcome of the study was to identify an orally bioavailable TF-VIIa inhibitor.

Dose-dependent antithrombotic activity of an orally active tissue factor/factor VIIa inhibitor without concomitant enhancement of bleeding propensity

The discovery of a highly potent and selective tissue factor/factor VIIa inhibitor is described. Upon oral administration of its double prodrug in the guinea pig, a dose-dependent antithrombotic effect is observed in an established model of arterial thrombosis without prolonging bleeding time. The pharmacodynamic properties of this selective inhibitor are compared to the behaviour of a mixed factor VIIa/factor Xa inhibitor.

Factor VIIa inhibitors: chemical optimization, preclinical pharmacokinetics, pharmacodynamics, and efficacy in an arterial baboon thrombosis model

Highly selective and potent factor VIIa-tissue factor (fVIIa.TF) complex inhibitors were generated through structure-based design. The pharmacokinetic properties of an optimized analog (9) were characterized in several preclinical species, demonstrating pharmacokinetic characteristics suitable for once-a-day dosing in humans. Analog 9 inhibited platelet and fibrin deposition in a dose-dependent manner after intravenous administration in a baboon thrombosis model, and a pharmacodynamic concentration-response model was developed to describe the platelet deposition data. Results for heparin and enoxaparin (Lovenox) in the baboon model are also presented.

Selective and orally bioavailable phenylglycine tissue factor/factor VIIa inhibitors

We describe the structure-based design and synthesis of highly potent, orally bioavailable tissue factor/factor VIIa inhibitors which interfere with the coagulation cascade by selective inhibition of the extrinsic pathway.

Structure-based design and synthesis of pyrazinones containing novel P1 ‘side pocket’ moieties as inhibitors of TF/VIIa

We describe the structure-based design, synthesis, and enzymatic activity of a series of substituted pyrazinones as inhibitors of the TF/VIIa complex. These inhibitors contain substituents meta to the P(1) amidine designed to explore additional interactions with the VIIa residues in the so-called 'S(1) side pocket'. A crystal structure of the designed inhibitors demonstrates the ability of the P(1) side pocket moiety to engage Lys192 and main chain of Gly216 via hydrogen bond interactions, thus, providing additional possibility for chemical modification to improve selectivity and/or physical properties of inhibitors.

Design of selective phenylglycine amide tissue factor/factor VIIa inhibitors

Proof of concept experiments have shown that tissue factor/factor VIIa inhibitors have antithrombotic activity without enhancing bleeding propensity. Starting from lead compounds generated by a biased combinatorial approach, phenylglycine amide tissue factor/factor VIIa inhibitors with low nanomolar affinity and good selectivity against other serine proteases of the coagulation cascade were designed, using the guidance of X-ray structural analysis and molecular modelling.

Crystal structure of human factor VIIa/tissue factor in complex with peptide mimetic inhibitor

The 3D structure of human factor VIIa/soluble tissue factor in complex with a peptide mimetic inhibitor, propylsulfonamide-D-Thr-Met-p-aminobenzamidine, is determined by X-ray crystallography. As compared with the interactions between thrombin and thrombin inhibitors, the interactions at S2 and S3 sites characteristic of factor VIIa and factor VIIa inhibitors are revealed. The S2 site has a small pocket, which is filled by the hydrophobic methionine side chain in P2. The small S3 site fits the small size residue, D-threonine in P3. The structural data and SAR data of the peptide mimetic inhibitor show that these interactions in the S2 and S3 sites play an important role for the improvement of selectivity versus thrombin. The results will provide valuable information for the structure-based drug design of specific inhibitors for FVIIa/TF.

Dissecting and Designing Inhibitor Selectivity Determinants at the S1 Site Using an Artificial Ala190 Protease (Ala190 uPA)

A site-directed mutant of the serine protease urokinase-type plasminogen activator (uPA), was produced to assess the contribution of the Ser190 side-chain to the affinity and selectivity of lead uPA inhibitors in the absence of other differences present in comparisons of natural proteases. Crystallography and enzymology involving WT and Ala190 uPA were used to calculate free energy binding contributions of hydrogen bonds involving the Ser190 hydroxyl group (O(gamma)(Ser190)) responsible for the remarkable selectivity of 6-halo-5-amidinoindole and 6-halo-5-amidinobenzimidazole inhibitors toward uPA and against natural Ala190 protease anti-targets. Crystal structures of uPA complexes of novel, active site-directed arylguanidine and 2-aminobenzimidazole inhibitors of WT uPA, together with associated K(i) values for WT and Ala190 uPA, also indicate a significant role of Ser190 in the binding of these classes of uPA inhibitors. Structures and associated K(i) values for a lead inhibitor (CA-11) bound to uPA and to five other proteases, as well as for other leads bound to multiple proteases, help reveal the features responsible for the potency (K(i)=11nM) and selectivity of the remarkably small inhibitor, CA-11. The 6-fluoro-5-amidinobenzimidzole, CA-11, is more than 1000-fold selective against natural Ala190 protease anti-targets, and more than 100-fold selective against other Ser190 anti-targets.