Capillary Condensation from Vapors of n -Hexane/Perfluoro- n -hexane Mixtures

Nanoscale Phase Measurement for the Shale Challenge: Multicomponent Fluids in Multiscale Volumes

Hydrocarbon recovery from shale reservoirs provides an increasing share of world energy. These resources are multicomponent fluid mixtures within multiscale geometries, and understanding their associated phase-change thermodynamics presents an array of challenges for experimentalists, theorists, operators, and policy makers. Here, we quantify hydrocarbon mixture phase behavior via direct imaging of connected channels spanning 4 orders of magnitude (10 nm to 10 μm) with supporting density functional theory. The methane/propane mixture dew point shifts, with early condensation of heavy components in nanopores because of a combination of capillarity and competitive surface adsorption. The bubble point in nanoconfinement is found to be deeply suppressed (∼3-fold), to below the bulk dew point of the original mixture, because of the exchange of mixture components with larger connected volumes. The trapping of the heaviest components of hydrocarbon mixtures within the smallest connected pores has implications for shale operations, reserve estimation, and ultimately energy security.

Capillary Condensation of Binary and Ternary Mixtures of n-Pentane-Isopentane-CO2 in Nanopores: An Experimental Study on the Effects of Composition and Equilibrium

Confinement in nanopores can significantly impact the chemical and physical behavior of fluids. While some quantitative understanding is available for how pure fluids behave in nanopores, there is little such insight for mixtures. This study aims to shed light on how nanoporosity impacts the phase behavior and composition of confined mixtures through comparison of the effects of static and dynamic equilibrium on experimentally measured isotherms and chromatographic analysis of the experimental fluids. To this end, a novel gravimetric apparatus is introduced and validated. Unlike apparatuses that have been previously used to study the confinement-induced phase behavior of fluids, this apparatus employs a gravimetric technique capable of discerning phase transitions in a wide variety of nanoporous media under both static and dynamic conditions. The apparatus was successfully validated against data in the literature for pure carbon dioxide and n-pentane. Then, isotherms were generated for binary mixtures of carbon dioxide and n-pentane using static and flow-through methods. Finally, two ternary mixtures of carbon dioxide, n-pentane, and isopentane were measured using the static method. While the equilibrium time was found important for determination of confined phase transitions, flow rate in the dynamic method was not found to affect the confined phase behavior. For all measurements, the results indicate qualitative transferability of the bulk phase behavior to the confined fluid.

Condensation in One-Dimensional Dead-End Nanochannels

Phase change at the nanoscale is at the heart of many biological and geological phenomena. The recent emergence and global implications of unconventional oil and gas production from nanoporous shale further necessitate a higher understanding of phase behavior at these scales. Here, we directly observe condensation and condensate growth of a light hydrocarbon (propane) in discrete sub-100 nm (∼70 nm) channels. Two different condensation mechanisms at this nanoscale are distinguished, continuous growth and discontinuous growth due to liquid bridging ahead of the meniscus, both leading to similar net growth rates. The growth rates agree well with those predicted by a suitably defined thermofluid resistance model. In contrast to phase change at larger scales (∼220 and ∼1000 nm cases), the rate of liquid condensate growth in channels of sub-100 nm size is found to be limited mainly by vapor flow resistance (∼70% of the total resistance here), with interface resistance making up the difference. The condensation-induced vapor flow is in the transitional flow regime (Knudsen flow accounting for up to 13% of total resistance here). Collectively, these results demonstrate that with confinement at sub-100 nm scales, such as is commonly found in porous shale and other applications, condensation conditions deviate from the microscale and larger bulk conditions chiefly due to vapor flow and interface resistances.

Normal capillary forces

A liquid meniscus between two lyophilic solid surfaces causes an attractive force, the capillary force. The meniscus can form by capillary condensation or by accumulation of adsorbed liquid. Under ambient conditions and between hydrophilic surfaces, capillary forces usually dominate over other surface forces. They are relevant in many processes occurring in nature and technical applications, for example the flow of granular materials and friction between surfaces. Here we review normal capillary forces, focusing on a quantitative description with continuum theory. After introducing the capillary force between spherical surfaces, we extend the discussion to other regular and irregular surfaces. The influence of surface roughness is considered. In addition to capillary forces at equilibrium, we also describe the process of meniscus formation. Assumptions, limits, and perspectives for future work are discussed.

Effect of contact angle hysteresis on the measurement of capillary forces

We conduct experimental investigations of macroscopic capillary forces between two flat rigid substrates characterized by their advancing and receding contact angles with water. Our results exhibit excellent agreement with theoretical predictions obtained by the numerical solution of the capillary equation. On the basis of this comparison, we use the measurements of the capillary force to investigate the phenomenon of contact angle hysteresis. We present examples of force measurements for surfaces that display low, moderate, and high contact angle hysteresis and compare results for a larger variety of substrates. Finally, we show that for the case of water, the role of viscosity is insignificant within the range of force and velocity measured in the present work.

Local structure of a phase-separating binary mixture in a mesoporous glass matrix studied by small-angle neutron scattering

The mesoscopic structure of the binary system isobutyric acid + heavy water (D(2)O) confined in a porous glass (controlled-pore silica glass, mean pore width ca. 10 nm) was studied by small-angle neutron scattering at off-critical compositions in a temperature range above and below the upper critical solution point. The scattering data were analyzed in terms of a structure factor model similar to that proposed by Formisano and Teixeira [Eur. Phys. J. E 1, 1 (2000)], but allowing for both Ornstein-Zernike-type composition fluctuations and domainlike structures in the microphase-separated state of the pore liquid. The results indicate that the phase separation in the pores is shifted by ca. 10 K and spread out in temperature. Microphase separation is pictured as a transition from partial segregation at high temperature, due to the strong preferential adsorption of water at the pore wall, to a tube or capsule configuration of the two phases at low temperatures, depending on the overall composition of the pore liquid. Results for samples in which the composition of the pore liquid can vary with temperature due to equilibration with extra-pore liquid are consistent with this picture.

Phase behavior and local structure of a binary mixture in pores: Mean-field lattice model calculations for analyzing neutron scattering data

We investigate the phase behavior of an asymmetric binary liquid A-W mixture confined between two planar homogenous substrates (slit pore). Molecules of species W interact preferentially with the solid walls via a long-range potential. Assuming nearest-neighbor attractions between the liquid molecules, we employ a lattice-gas model and a mean-field approximation for the grand potential. Minimization of this potential yields the density profiles of thermodynamically stable phases for fixed temperature, chemical potentials of both species, pore width and strengths of attraction. This model is used to analyze experimental small-angle neutron-scattering (SANS) data on the microscopic structure of the binary system isobutyric acid (iBA)+heavy water (D2O) inside a mesoscopic porous matrix (controlled-pore glass of about 10 nm mean pore width). Confinement-independent model parameters are adjusted so that the theoretical liquid-liquid coexistence curve in the bulk matches its experimental counterpart. By choosing appropriate values of the pore width and the attraction strength between substrates and water we analyze the effect of confinement on the phase diagram. In addition to a depression of the liquid-liquid critical point we observe surface induced phase transitions as well as water-film adsorption near the walls. The temperature dependence of the structure of water-rich and iBA-rich phases of constant composition are discussed in detail. The theoretical predictions are consistent with results of the SANS study and assist their interpretation.

Adsorption from alkane+perfluoroalkane mixtures at fluorophobic and fluorophilic surfaces. II. Crossover from critical adsorption to complete wetting

Using neutron reflectometry, adsorption from an equimolar mixture of hexane + perfluorohexane to a fluorophobic, octadecyl-coated, silicon substrate has been investigated as a function of temperature in the one-phase region upon approach to liquid-liquid coexistence. The composition of the investigated mixture, x(F) = 0.50, is well removed from the critical composition of x(F) = 0.36, where x(F) is the perfluorohexane mole fraction. To aid the modeling, mixtures with three different neutron refractive index contrasts have been used: namely, mixtures of C(6)H(14) + C(6)F(14) (H-F), C(6)D(14) + C(6)F(14) (D-F), and a mixture of C(6)H(14) + C(6)D(14) + C(6)F(14) which has been adjusted to have the same refractive index as silicon (CMSi). For all three contrasts, the principal features of the composition profile normal to the interface follow similar trends as the temperature T is reduced towards T(0), the coexistence temperature. These features consist of: (i) a hexane-rich primary adsorption layer appended to the octadecyl coupled layer. This primary layer is 22 +/- 5 A thick and becomes increasingly enriched in hexane as T(0) is approached. (ii) A tail that decays exponentially towards the bulk composition with a characteristic decay length zeta. As T(0) is approached, zeta increases. The scattering length density profiles have been converted to volume fraction profiles and the surface excess of hexane Gamma has been determined as a function of temperature for all three contrasts. As T(0) is approached Gamma increases, and its behavior can be represented using the scaling law Gamma approximately |T - T(0)|(-m). The resulting values of m are 0.71 +/- 0.09, 0.68 +/- 0.04, and 0.68 +/- 0.06 for the D-F, H-F, and CMSi contrasts, respectively. The behavior of Gamma with temperature does not adhere to the Gamma approximately |T - T(0)|(-1/3) law expected for complete wetting in systems with van der Waals interactions nor does it correspond to Gamma approximately |T - T(c)|(-0.305) expected for critical adsorption. The magnitude of the exponent m indicates that the adsorption resides in the crossover region between critical adsorption and complete wetting.