Adsorption of benzaldehyde at the surface of ice, studied by experimental method and computer simulation

Adsorption study of benzaldehyde on ice surfaces is performed by combining experimental and theoretical approaches. The experiments are conducted over the temperature range 233-253 K using a coated wall flow tube coupled to a mass spectrometric detector. Besides the experimental way, the adsorption isotherm is also determined by performing a set of grand canonical Monte Carlo simulations at 233 K. The experimental and calculated adsorption isotherms show a very good agreement within the corresponding errors. Besides, both experimental and theoretical studies permit us to derive the enthalpy of adsorption of benzaldehyde on ice surfaces DeltaH(ads), which are in excellent agreement: DeltaH(ads) = -61.4 +/- 9.7 kJ/mol (experimental) and DeltaH(ads) = -59.4 +/- 5.1 kJ/mol (simulation). The obtained results indicate a much stronger ability of benzaldehyde of being adsorbed at the surface of ice than that of small aliphatic aldehydes, such as formaldehyde or acetaldehyde. At low surface coverages the adsorbed molecules exclusively lie parallel with the ice surface. With increasing surface coverage, however, the increasing competition of the adsorbed molecules for the surface area to be occupied leads to the appearance of two different perpendicular orientations relative to the surface. In the first orientation, the benzaldehyde molecule turns its aldehyde group toward the ice phase, and, similarly to the molecules in the lying orientation, forms a hydrogen bond with a surface water molecule. In the other perpendicular orientation the aldehyde group turns to the vapor phase, and its O atom interacts with the delocalized pi system of the benzene ring of a nearby lying benzaldehyde molecule of the second molecular layer. In accordance with this observed scenario, the saturated adsorption layer, being stable in a roughly 1 kJ/mol broad range of chemical potentials, contains, besides the first molecular layer, also traces of the second molecular layer of adsorbed benzaldehyde.

Uptake Measurements of Ethanol on Ice Surfaces and on Supercooled Aqueous Solutions Doped with Nitric Acid between 213 and 243 K

Uptake of ethanol either on pure frozen ice surfaces or supercooled solutions doped with HNO3 (0.63 and 2.49 wt %) has been investigated using a coated wall flow tube coupled to a mass spectrometric detection. The experiments were conducted over the temperature range of 213-243 K. Uptake of ethanol on these surfaces was always found to be totally reversible whatever were the experimental conditions. The number of ethanol molecules adsorbed per surface unit was conventionally plotted as a function of ethanol concentration in the gas phase and subsequently analyzed using Langmuir's model. The amount of ethanol molecules taken up on nitric acid doped-ice surfaces was found to increase largely with increasing nitric acid concentrations. For example at 223 K, and for an ethanol gas-phase concentration of 1x10(13) molecules cm3, the number of adsorbed molecules are (in units of molecules cm-2): approximately 1.3x10(14) on pure ice; approximately 1.4x10(15) on ice doped with HNO3 0.63 wt %; approximately 7.5x10(15) on ice doped with HNO3, 2.49 wt %, i.e. 60 times larger than on pure ice. Since, according to the shape of the isotherms, the adsorption did not proceed beyond monolayer coverage, the enormous increase of ethanol uptake was explained by considering its dissolution in either a supercooled liquid layer (T<230 K) or a liquid solution (T>230 K). The formation of both was indeed favored by the presence of the HNO3. Our experimental results suggest that the amount of ethanol dissolved in such supercooled solutions follows Henry's law and that the Henry's law constants at low temperatures, i.e., 223-243 K, can be estimated by extrapolation from higher temperatures. Such supercooled solutions which exist in the troposphere either in deep convective clouds or in mixed clouds for temperature above 233 K, might be responsible for the scavenging of large amounts of soluble species, such as nitric and sulfuric acids, oxygenated VOCs including alcohols, carboxylic acids, and formaldehyde.