Atomic-scale viscoplasticity mechanisms revealed in high ductility metallic glass films

Evolution of the Structural and Magnetic Properties of Bulk Fe61Co10B20W1Y8-XPtx Alloys through the Partial Substitution of Pt for Y

This paper presents the results of an investigation into rapidly quenched Fe-based alloys with the chemical formula: Fe61Co10B20W1Y8-xPtx (where x = 3, 4, 5). In these alloys, a small quantity of Pt was added, and the Y content was reduced concurrently. Samples of the aforementioned alloys were injection-cast in the form of plates with the dimensions: 0.5 mm × 10 mm × 10 mm. The resulting structure was examined using X-ray diffractometry (XRD), Mössbauer spectroscopy and scanning electron microscopy (SEM). The results of the structural research reveal that, with a small addition of Pt, areas rich in Pt and Y are created-in which Fe-Pt and Pt-Y compounds, with different crystallographic systems, are formed. It has also been shown that an increase in Pt content, at the expense of Y, contributed to the formation of fewer crystalline phases, i.e., it allowed a material with a more homogeneous structure to be obtained. Magnetic properties of the Fe61Co10B20W1Y8-xPtx (where x = 3, 4, 5) alloy samples were tested using a vibrating sample magnetometer (VSM). The magnetic properties of the investigated materials revealed that the saturation magnetisation increased with increasing Pt content, at the expense of Y. This effect is due to the occurrence of different proportions of crystalline magnetic phases within the volume of each alloy.

Size Effect on Mechanical Properties and Deformation Behavior of Pure Copper Wires Considering Free Surface Grains

The size (grain size and specimen size) effect makes traditional macroscopic forming technology unsuitable for a microscopic forming process. In order to investigate the size effect on mechanical properties and deformation behavior, pure copper wires (diameters range from 50 μm to 500 μm) were annealed at different temperatures to obtain different grain sizes. The results show that a decrease in wire diameter leads to a reduction in tensile strength, and this change is pronounced for large grains. The elongation of the material is in linear correlation to size factor D/d (diameter/grain size), i.e., at the same wire diameter, more grains in the section bring better plasticity. This phenomenon is in relationship with the ratio of free surface grains. A surface model combined with the theory of single crystal and polycrystal is established, based on the relationship between specimen/grain size and tensile property. The simulated results show that the flow stress in micro-scale is in the middle of the single crystal model (lower critical value) and the polycrystalline model (upper critical value). Moreover, the simulation results of the hybrid model calculations presented in this paper are in good agreement with the experimental results.