Contribution of Fe3O4 nanoparticles to the fouling of ultrafiltration with coagulation pre-treatment

Predicting the flocculation kinetics of fine particles in a turbulent flow using a Budyko-type model

Through an analogy with the Budyko curves in catchment hydrology science, this study defines the supply and demand limits for the flocculation system of cohesive particles (the supply limit can be represented by the potential floc size growth, whereas the demand limit can be represented by the steady-state floc size) and attempts to adopt Budyko-type models to estimate the temporal evolution of floc size during flocculation. Seventeen experimental datasets are collected to test the accuracy of the Budyko model with an average high correlation coefficient of 0.9784 and average low relative error and root mean squared error values of 0.1304 and 0.0605, respectively. Either the potential floc size growth or the steady-state floc size is a monotonic function of the flow shear rate, and a simple empiric power law function can be used to describe them. Other Budyko-type models are also found to show good prediction accuracies against the experimental datasets. This study indicates that Budyko-type models have potential as a good addition to existing flocculation models for predicting the temporal variation in the size population of flocs in a turbulent flow, provided that some coefficients have been calibrated by limited data points prior.

Development of a nanocomposite ultrafiltration membrane based on polyphenylsulfone blended with graphene oxide

In the present study, graphene oxide (GO) was incorporated as a nanoadditive into a polyphenylsulfone (PPSU) to develop a PPSU/GO nanocomposite membrane with enhanced antifouling properties. A series of membranes containing different concentrations (0.2, 0.5 and 1.0 wt.%) of GO were fabricated via the phase inversion method, using N-methyl pyrrolidone (NMP) as the solvent, deionized water as the non-solvent, and polyvinylpyrrolidone (PVP) as a pore forming agent. The prepared nanocomposite membranes were characterized using scanning electron microscopy (SEM) and atomic force microscopy (AFM), and were also characterized with respect to contact angle, zeta potential and porosity, mean pore radius, tortuosity and molecular weight cut-off (MWCO). Thermogravimetric analysis (TGA) and tensile testing were used to measure thermal and mechanical properties. The membrane performance was evaluated by volumetric flux and rejection of proteins, and antifouling properties. According to the results, the optimum addition of 0.5 wt% GO resulted in a membrane with an increased flux of 171 ± 3 Lm⁻²h⁻¹ with a MWCO of ~40 kDa. In addition, the GO incorporation efficiently inhibited the interaction between proteins and the membrane surface, thereby improving the fouling resistance ability by approximately 58 ± 3%. Also, the resulting membranes showed a significant improvement in mechanical and thermal properties.

Application of pulsed UV-irradiation and pre-coagulation to control ultrafiltration membrane fouling in the treatment of micro-polluted surface water

A major cause of ultrafiltration (UF) membrane fouling is the accumulation of microorganisms and their associated soluble products. To mitigate fouling the application of pulsed short-wavelength ultraviolet (UVC) light (around 254 nm) within the membrane tank together with pre-coagulation was investigated. In mini-pilot-scale tests carried out in parallel with conventional pre-treatment (CUF), the impact of pulsed UV (CUF-UV) at different UV irradiances and fluxes on the increase of trans-membrane pressure (TMP) was evaluated and explained in terms of the quantity and nature of membrane deposits in the membrane cake layer and pores. The results indicated that at a flux of 20 L m^-2 h^-1, the pulsed UV (1 min within 31 min cycle) at 3.17 × 10^-2 W/cm² prevented any measureable increase in TMP over a period of 32 days, while there was a fourfold increase in TMP for the conventional pre-treatment. For the CUF-UV system the concentration of bacteria and soluble microbial products was much less than the conventional CUF system, and the cake layer was thinner and contained less biopolymers (proteins and polysaccharides). In addition, the pores of the CUF-UV membrane appeared to have less organic deposits, and particularly fractions with a high molecular weight (>10 kDa). At a lower UV irradiance (1.08 × 10^-2 W/cm²), or higher flux (40 L m^-2 h^-1) with the same UV irradiance, there was a measurable increase in TMP, indicating some fouling of the CUF-UV membrane, but the rate of TMP development was significantly lower (∼50%) than the conventional CUF membrane system. Overall, the results show the potential advantages of applying intermittent (pulsed) UVC irradiation with coagulation to control UF membrane fouling.