A comparative study on PVC based sensors in determination of

The proposed work described the synthesis of neutral ionophores; 4,8-diaza-3,3,10,10-tetramethyl-1,2-dithiacyclodecane (S1), 5,8-diaza-3,3,10,10-tetramethyl-1,2 dithiacyclodecane-N,N''-diacetic acid (S2) and N,N''-bis(2,2-dimethyl-2-mercaptoethyl)ethylenediamine-N,N-diacetic acid (S3) used for comparative analysis in determination of molybdenum(v) as PVC-based membrane sensors. The best result was obtained with sensor no. 7 based on S3 ionophore with membrane composition (w/w, mg%); 5.0(S) : 30.0(PVC) : 5.0(KTpClPB) : 60.0(o-NPOE) showing a working range of 2.3 × 10-7-1.0 × 10-2 M with a detection limit of 1.2 × 10-7 M and a toleration of non-aqueous media up to 15% with slope of 11.7 mV/decade of activity. The sensor no. 7 can also be used to assess the Mo(v) concentration in different natural samples (water bodies, soils, root nodules and urine samples) with comparative analysis of ETAAS and spectrophotometric methods. The proposed sensor no. 7 can be used 2.5 months without any distortion in results after that leaching of ionophore was observed from the membrane phase in aqueous solutions of Mo(v). The proposed sensor has shown a good dynamic response time of 11 s.

Kinetic Spectrophotometric Determination of Traces of Molybdenum(VI) by Its Inhibitory Effect on the Oxidation of 4-Hydroxycoumarine by Potassium Permanganate

The present paper describes a simple, selective and sensitive kinetic method for the determination of trace amounts of molybdenum(VI) based on its inhibitory effect on the reaction oxidation of 4-hydroxycoumarine by KMnO(4) in the presence of hydrochloric acid, at pH 1.75 at 25 degrees C. The rate of the indicator reaction was followed spectrophotometrically by measuring the decrease in the absorbance of KMnO(4) at 525 nm. The development method includes optimization of the reagent concentration and temperature. The calibration graph was linear in the range of concentrations from 20 to 200 ng/cm(3) of molybdenum(VI). The probable relative error was in the interval 3.10 - 10.52% for the concentration range of 200 - 20 ng/cm(3) molybdenum(VI), respectively. The interference effects of the foreign ions were determined to assess the selectivity of the method. The developed method was found to have relatively good selectivity, sensitivity, simplicity and rapidity. The proposed method was applied to the determination of molybdenum(VI) in a particular type of steel and alloy (hastelloy).