Determination of trace elements in a marine reference material of lobster hepatopancreas (TORT-1) using inductively coupled plasma mass spectrometry

Analysis of total mercury in human tissues prepared by microwave decomposition using a hydride generator system coupled to an atomic absorption spectrometer

A fast and efficient procedure has been developed for the analysis of total mercury in human tissues and blood using a hydride vapor generator system coupled to an atomic absorption spectrometer (HVG-AA). Tissue and blood samples were digested in a pressurized microwave decomposition system and the digest diluted prior to formation of free mercury vapor and analysis by atomic absorption. Recovery studies performed on 10 spiked/unspiked pairs of human liver and on 10 spiked/unspiked pairs of human blood samples yielded average recoveries of 99.7% (CV=0.4%) and 101.2% (CV=0.5%), respectively. The method detection limit for liver and blood was 50 microg Hg/kg and 12.5 microg Hg/l, respectively. The "normal" concentrations of mercury in human liver and blood are 33-490 microg Hg/kg and 0.6-59 microg Hg/l, respectively [1]. This method is able to determine mercury poisoning levels and may also be applied to detect mercury near the lower levels of these "normal" ranges, using the standard addition method approach.

Direct determination of selenium and other trace elements in serum samples by ICP-MS

Selenium belongs to a group of trace elements of special interest in biological samples for clinical diagnosis. Selenium has antioxidizing functions and is essential for providing the organism with triiodothyronine produced from thyroxine. Among several analytical techniques used to determine the Se concentration in serum, Inductively Coupled Plasma Mass Spectrometry (ICP-MS) has been used in the past because of its high sensitivity. Interference problems originating from different ions on the major Se isotopes have been described to be a limiting factor for the direct determination of Se in these matrices. Standard addition calibration or isotope dilution is often required to overcome carbon-enhanced ionisation effects in biological sample matrices. In most cases, the typical serum sample volume which is available for the analysis is limited to 0.5 ml or less, making multiple sample preparation for standard addition calibration impractical. Isotope dilution requires enriched isotopes and substantial sample preparation. Furthermore, the approximate Se concentration in every sample has to be known to adjust the appropriate amount of spike to each sample. Matrix matching with methanol has been described to overcome ionisation effects but we found limiting factors of this application when other trace elements are also determined within one sample run. This paper describes an effective sample preparation method which allows the direct determination of Se in serum without limiting the analytical capabilities for the additional determination of Al, Cu, Ni, Co, Cd, Mn and Zn in a single sample run by ICP-MS. Optimization procedures are presented and results of the analysis of reference samples are discussed, with a comparison of more than 150 serum data with those obtained by the GF-AAS method.

Isotope-specific analysis of Ni by ICP-MS: applications of stable isotope tracers to biokinetic studies

Inductively coupled plasma mass spectrometry (ICP-MS) offers excellent detection limits and isotopic analysis of Ni in aqueous standards, but is prone to interferences--mainly from Ca-containing polyatomics--when biological matrices are analyzed for Ni. We have used multivariate calibration with principal components analysis (PCA) to correct for mass overlaps in serum digests. The resulting detection limit for Ni is below 1 microgram/l and the within-run imprecision is 6% at 1.46 micrograms Ni/l. In urine, the higher Ca content renders routine application of PCA problematic. We evaluated several methods of pre-concentration, and have developed a method of Ca oxalate precipitation that allows direct analysis of Ni in the diluted supernatant. The stable isotope 62Ni and the radiosotope 63Ni were co-administered i.v. to rats and the serum and urinary clearances were determined by liquid scintillation counting and ICP-MS. Ni measurements by both methods were in excellent agreement, and serum clearance fit a double exponential decay consistent with the two-compartment model of Onkelinx et al. [24]. A human volunteer ingested 61Ni (20 micrograms Ni/kg body wt.) in water after an overnight fast. Identical serum levels, peaking near 35 micrograms/l at 2 h, were measured by electrothermal atomic absorption spectrometry and ICP-MS with PCA. Urinary excretion of 61Ni measured by ICP-MS demonstrated absorption of 30% of the administered dose. We conclude that Ni isotopes can be measured in body fluids by ICP-MS at levels that allow stable isotope tracer studies in humans.