An automated injection system for sub-micron sized channels used in shear-driven-chromatography

Rail configuration for lateral particle transport across intact co-flows: effect of wall and rail geometry on liquid and particle transport

Layer-by-Layer coating technology is of great importance for many applications of microparticles whereby exposure of the particles to various reagents is needed. Mutual contamination of the reagents during this process is a key challenge, and this undesired effect should be avoided. Here we introduce a device that provides subsequent exposure of particles to various liquids and minimizes mixing of the liquids at the same time. The key element of the device is a rail (groove) at the bottom of a microfluidic channel. The rail forms an angle (between 0 and 90 degrees) and thus enables passive transport of particles through the intact co-flows of the different fluids. To avoid the undesirable effect of reagent stream mixing, internal walls are introduced to separate the different flows. Various designs of the proposed device are considered, and their performance is experimentally analyzed.

Force applied to a single molecule at a single nanogate molecule filter

We have investigated the origin of molecule filtering system based on a chemical potential barrier produced by thermodynamically driven molecular flow in a nanoscopic space at nanogates. Single molecule tracking experiments prove that the highly localized potential barrier allows for selective manipulation of the target molecule. We propose the presence of a force, a few fN per molecule, to decelerate the molecule's movement at the nanogate, which is comparable to or larger than the force applied by conventional electrophoretic operation. The present force can be tuned by changing the nanogate width at the nanometre level. These findings allow us to propose an accurate design of novel devices for molecular manipulation on an ultra small scale using a very small number of molecules without any external biases.

Pressure-driven reverse-phase liquid chromatography separations in ordered nonporous pillar array columns

Building upon the micromachined column idea proposed by the group of Regnier in 1998, we report on the first high-resolution reversed-phase separations in micromachined pillar array columns under pressure-driven LC conditions. A three component mixture could be separated in 3 s using arrays of nonporous silicon pillars with a diameter of approximately 4.3 microm and an external porosity of 55%. Under slightly retained component conditions (retention factor k' = 0.65-1.2), plate heights of about H = 4 microm were obtained at a mobile phase velocity around u = 0.5 mm/s. In reduced terms, such plate heights are as low as hmin = 1. Also, since the flow resistance of the column is much smaller than in a packed column (mainly because of the higher external porosity of the pillar array), the separation impedance of the array was as small as E = 150, i.e., of the same order as the best currently existing monolithic columns. At pH = 3, yielding very low retention factors (k' = 0.13 and 0.23), plate heights as low as H = 2 microm were realized, yielding a separation of the three component mixture with an efficiency of N = 4000-5000 plates over a column length of 1 cm. At higher retention factors, significantly larger plate heights were obtained. More experimental work is needed to investigate this more in depth. The study is completed with a discussion of the performance limits of the pillar array column concept in the frame of the current state-of-the-art in microfabrication precision.