Effect of the Steric Hindrance and Branched Substituents on Visible Phenylamine Oxime Ester Photoinitiators: Photopolymerization Kinetics Investigation through Photo-DSC Experiments

In this work, free radical photopolymerization (FRP) kinetics for series of different phenylamine oxime ester structures (DMA-P, DEA-P, DMA-M, TP-2P, TP-2M and TP-3M) was investigated. Steric hindrance and branched substituents were prepared to realize the corresponding electronic and photopolymerization effects. The photophysical, electrochemical, thermal properties and radical concentration were investigated by UV-visible spectroscopy, cyclic voltammetry (CV), thermogravimetric analysis (TGA), differential scanning calorimetry (DSC) and electron paramagnetic resonance (EPR). Furthermore, the structure-reactivity relationships were also studied in detail through photo-DSC experiment. We demonstrate that the introduction of alkyl chains and/or numbers of oxime esters affects significantly the photoreactivity. Under the same weight ratio of formulation and irradiated condition, TP-3M containing three oxime esters in its structure and methyl group in the periphery exhibits the highest double-bond conversion efficiency. TP-3M-based formulation also shows a wide operation window under different contents and light intensities. Importantly, the photoreactivity of the TP-3M-based system was found to be better than the commercial photoinitiator (OXE-01) under LED@405 nm at a low concentration. This work could provide some significance to the design of oxime esters with enhanced photoreactivity.

In Search of a Green Process: Polymeric Films with Ordered Arrays via a Water Droplet Technique

As an efficient technique for the preparation of polymeric hexagonal orderly arrays, the breath figure (BF) process has opened a modern avenue for a bottom-up fabrication method for more than two decades. Through the use of the water vapor condensation on the solution surface, the water droplets will hexagonally pack into ordered arrays, acting as a template for controlling the regular micro patterns of polymeric films. Comparing to the top-down techniques, such as lithography or chemical etching, the use of water vapor as the template provides a simple fabrication process with sustainability. However, using highly hazardous solvents such as chloroform, carbon disulfide (CS2), benzene, dichloromethane, etc., to dissolve polymers might hinder the development toward green processes based on this technique. In this review, we will touch upon the contemporary techniques of the BF process, including its up-to-date applications first. More importantly, the search of greener processes along with less hazardous solvents for the possibility of a more sustainable BF process is the focal point of this review.

Surface-functionalized hyperbranched poly(amido acid) magnetic nanocarriers for covalent immobilization of a bacterial γ-glutamyltranspeptidase

In this study, we synthesized water-soluble hyperbranched poly(amido acid)s (HBPAAs) featuring multiple terminal CO₂H units and internal tertiary amino and amido moieties and then used them in conjunction with an in situ Fe^2+/Fe³⁺ co-precipitation process to prepare organic/magnetic nanocarriers comprising uniformly small magnetic iron oxide nanoparticles (NP) incorporated within the globular HBPAAs. Transmission electron microscopy revealed that the HBPAA-γ-Fe₂O₃ NPs had dimensions of 6–11 nm, significantly smaller than those of the pristine γ-Fe₂O₃ (20–30 nm). Subsequently, we covalently immobilized a bacterial γ-glutamyltranspeptidase (BlGGT) upon the HBPAA-γ-Fe₂O₃ nanocarriers through the formation of amide linkages in the presence of a coupling agent. Magnetization curves of the HBPAA-γ-Fe₂O₃/BlGGT composites measured at 300 K suggested superparamagnetic characteristics, with a saturation magnetization of 52 emu g⁻¹. The loading capacity of BlGGT on the HBPAA-γ-Fe₂O₃ nanocarriers was 16 mg g⁻¹ support; this sample provided a 48% recovery of the initial activity. The immobilized enzyme could be recycled 10 times with 32% retention of the initial activity; it had stability comparable with that of the free enzyme during a storage period of 63 days. The covalent immobilization and stability of the enzyme and the magnetization provided by the HBPAA-γ-Fe₂O₃ NPs suggests that this approach could be an economical means of depositing bioactive enzymes upon nanocarriers for BlGGT-mediated bio-catalysis.