Gamma Radiation Processed Polymeric Materials for High Performance Applications: A Review

The polymeric properties are tailored and enhanced by high energy radiation processing, which is an effective technique to tune the physical, chemical, thermal, surface, and structural properties of the various thermoplastic and elastomeric polymeric components. The gamma and electron beam radiation are the most frequent radiation techniques used for crosslinking, compatibilizing, and grafting of various polymer blends and composites systems. The gamma radiation-induced grafting and crosslinking are the effective, rapid, clean, user-friendly, and well-controlled techniques for the polymeric materials for their properties improvement for high performance applications such as nuclear, automobile, electrical insulation, ink curing, surface modification, food packaging, medical, sterilization, and health-care in a different environment. Similarly, electron beam radiations crosslinking has been a well-known technique for properties development and has economic benefits over chemical crosslinking techniques. This review focuses on the development of polymeric multi component systems (functionalized polymer, blends, and nanohybrids), where partially nanoscale clay incorporation can achieve the desired properties, and partially by controlled high energy radiations crosslinking of blends and nanocomposites. In this review, various investigations have been studied on the development and modifications of polymeric systems, and controlled dose gamma radiation processed the polymer blends and clay-induced composites. Radiation induced grafting of the various monomers on the polymer backbone has been focused. Similarly, comparative studies of gamma and electron beam radiation and their effect on property devlopment have been focused. The high energy radiation modified polymers have been used in several high performance sectors, including automotive, wire and cable insulation, heat shrinkable tube, sterilization, biomedical, nuclear and space applications.

Designing a single superabsorbent for separating oil from both layered as well as micron/submicron size emulsified oil/water mixtures by gamma radiation assisted grafting

A single superabsorbent for separating both layered and emulsified oil/water mixtures designed by gamma radiation assisted grafting in aqueous ethanol solution.

Electron beam modified nylon 6-clay nanocomposites: morphology and water absorption behavior

A series of nylon 6-clay nanocomposites were prepared by melt mixing, followed by electron beam (EB) crosslinking at various doses. Effects of crosslinking on clay dispersion, gel content, crystallinity and water absorption properties (hygrothermal) were studied. No change of the dispersion pattern of clay in nanocomposites was observed after crosslinking [from X-ray diffraction (XRD) and transmission electron microscopy (TEM)]. Gel content, i.e., degree of crosslinking is seen to keep on increasing with irradiation dose, although clays hinder crosslinking of polymers to some extent. Crystallinity of polymers is reduced after incorporation of clay as well as crosslinks. However, water absorption rate and maximum water content of nanocomposites are found to increase and saturation time to decrease with clay content. However, these changes become opposite after crosslinking of polymers. The water absorption for all samples is noticed to increase with temperature. Thus, EB crosslinking, without affecting the nanocomposite morphology, i.e., properties derived from nano interface generation, decreases the water absorption properties of nanocomposites.