Strain effects determine the performance of artificial allosteric systems: calixarenes as models

It is shown that the performance of allosteric systems regarding the efficiency and the speed of response depends critically on the strain energy of the equilibrating conformers and of the corresponding interconversion transition state. The affinity of a substrate A can be large enough to overcome in the absence of an effector E by induced fit the strain involved in the formation of an optimal conformation for binding A. The efficiency as given by the ratio KAE/KA of binding constants in the presence or absence of an effector is, for many published synthetic allosteric systems, relatively low; in practice this means that these only function within rather limited concentration ranges. A small KAE/KA ratio means that the binding strength of A or the corresponding signal will increase only little by adding an effector, and may need higher concentration of E. Implementation of steric distortion in the minor conformer can lead to reduced binding of A in the absence of the effector E. Destabilization of conformers can also result from the inclusion of high energy water molecules within a cavity. Furthermore, until now it has been overlooked that strain in the transition state can lead to reaction times of up to days, and thus to the neglect of experimental observation. The role of conformational changes within an allosteric molecule is characterized with a variety of calixarenes and other compound classes, offering a clue for the design of more efficient synthetic systems with high cooperativity.

A novel jointly colorimetric and fluorescent sensor for Cu2+ recognition and its complex for sensing S2- by a Cu2+ displacement approach in aqueous media

In this work, a simple and easily synthesized Schiff-based derivative colorimetric and fluorescent sensor (1), 4-dimethylamino-benzoic acid (2-imidazole formaldehyde)-hydrazide, was obtained for the detection of Cu²⁺ and S^2-. The compound 1 exhibited dual spectral responses to Cu²⁺, that is, vivid color change and fluorescence enhancement in the presence of Cu²⁺. The detection limits were valued as 0.46 μM and 15 nM according to absorption and fluorescent response, respectively. Both of them are below the World Health Organization (WHO) guidelines for drinking water (31.5 μM). In addition, the ensemble (1-Cu²⁺) selectively and sensitively detected a low concentration of S^2-. As the addition of S^2- instantly removed Cu²⁺ from the ensemble (1-Cu²⁺) resulting in a color change from yellow to colorless and a "turn-off" fluorescent response. The detection limit for S^2- was estimated as 0.12 μM (from fluorescent method) and 0.68 μM (from absorption method), respectively, each of which was also lower than the maximum allowable level of S^2- (15 μM) in drinking water defined by the WHO. The binding process was confirmed via UV-vis absorption, fluorescence measurements, ¹H NMR, mass spectroscopy and density functional theory calculation. What's more, successful practical application of test paper is used to inspect the S^2- which means the convenient and rapid assay in real samples can be achieved.