Precise Stepwise Synthesis of Donor-Acceptor Conjugated Polymer Brushes Grafted from Surfaces

Donor-acceptor (D-A) conjugated polymers are promising materials in optoelectronic applications, especially those forming ordered thin films. The processability of such conjugated macromolecules is typically enhanced by introducing bulky side chains, but it may affect their ordering and/or photophysical properties of the films. We show here the synthesis of surface-grafted D-A polymer brushes using alternating attachment of tailored monomers serving as electron donors (D) and acceptors (A) via coupling reactions. In such a stepwise procedure, alternating copolymer brushes consisting of thiophene and benzothiadiazole-based moieties with precisely tailored thickness and no bulky substituents were formed. The utilization of Sonogashira coupling was shown to produce densely packed molecular wires of tailored thickness, while Stille coupling and Huisgen cycloaddition were less efficient, likely because of the higher flexibility of D-A bridging groups. The D-A brushes exhibit reduced bandgaps, semiconducting properties and can form aggregates, which can be adjusted by changing the grafting density of the chains.

Experimental and Theoretical Investigations of Different Diketopyrrolopyrrole-Based Polymers

Diketopyrrolopyrrole (DPP)-based polymers are often considered as the most promising donor moiety in traditional bulk heterojunction solar cell devices. In this paper, we report the synthesis, characterization of various DPP-based copolymers with different molecular weights, and polydispersity where other aromatic repeating units (phenyl or thiophene based) are connected by alternate double bonds or triple bonds. Some of the copolymers were used for device fabrication and the crucial parameters such as fill factor (FF) and open circuit voltage (V _oc) were calculated. The density functional theory was used to optimize the geometries and deduce highest occupied molecular orbital-lowest unoccupied molecular orbital gaps of all the polymers and theoretically predict their optical and electronic properties. Optical properties of all the polymers, electrochemical properties, and band gaps were also obtained experimentally and compared with the theoretically predicted values.

Polymer brush on surface with tunable hydrophilicity using SAM formation of zwitterionic 4-vinylpyridine-based polymer

A zwitterionic vinylpyridine-based polymeric SAM was assembled on different surfaces to obtain tunable hydrophilicity.

Microcapsules from diverse polyfunctional materials: synergistic interactions for a sharp response to pH changes

Responsive microcapsules with strong synergistic interactions were prepared using a copolymer, silver nanoparticles and carbon nanotubes.

Surface Grafting of Functionalized Poly(thiophene)s Using Thiol-Ene Click Chemistry for Thin Film Stabilization

Regioregular poly[(3-hexylthiophene)-ran-(3-undecenylthiophene)] (pP3HT) and vinyl terminated poly(3-hexylthiophene) (xP3HT) were synthesized by the McCullough method and surface grafted to thiol modified silicon dioxide wafers using thiol-ene click chemistry. Utilizing this method, semiconducting, solvent impervious films were easily generated. Thiol-ene click chemistry is convenient for film stabilization in electronics because it does not produce side products that could be inimical to charge transport in the active layer. It was found through grazing incidence wide-angle X-ray scattering (GIWAXS) that there is no change in microstructure between as-spun films and thiol-ene grafted films, while there was a change after the thiol-ene grafted film was exposed to solvent. Organic field-effect transistors (oFETs) were fabricated from grafted films that had been swelled with chloroform, and these devices had mobilities on the order of 10^-6 cm² V^-1 s^-1, which are consistent with poly(thiophene) monolayer devices.