Probing the interaction of Rh, Co and bimetallic Rh-Co nanoparticles with the CeO2 support: catalytic materials for alternative energy generation

Optimized Pt-Co Alloy Nanoparticles for Reverse Water-Gas Shift Activation of CO2

Different Co contents were used to tune bimetallic Pt-Co nanoparticles with a diameter of 8 nm, resulting in Pt:Co ratios of 3.54, 1.51, and 0.96. These nanoparticles were then applied to the MCF-17 mesoporous silica support. The synthesized materials were characterized with HR-TEM, HAADF-TEM, EDX, XRD, BET, ICP-MS, in situ DRIFTS, and quasi in situ XPS techniques. The catalysts were tested in a thermally induced reverse water-gas shift reaction (CO2:H2 = 1:4) at atmospheric pressure in the 200-700 °C temperature range. All bimetallic Pt-Co particles outperformed the pure Pt benchmark catalyst. The nanoparticles with a Pt:Co ratio of 1.51 exhibited 2.6 times higher activity and increased CO selectivity by 4% at 500 °C. Experiments proved that the electron accumulation and alloying effect on the Pt-Co particles are stronger with higher Co ratios. The production of CO followed the formate reaction pathway on all catalysts due to the face-centered-cubic structure, which is similar to the Pt benchmark. It is concluded that the enhanced properties of Co culminate at a Pt:Co ratio of 1.51 because decreasing the ratio to 0.96 results in lower activity despite having more Co atoms available for the electronic interaction, resulting in the lack of electron-rich Pt sites.

Co/CeO2/C composites derived from bimetallic metal-organic frameworks for efficient microwave absorption

CeO2, an n-type semiconductor material, has been widely used in microwave absorption (MA) due to its unique structural features such as oxygen vacancies and interstitial atoms. In this paper, Co/CeO2/C composites were prepared by a hydrothermal method followed by a pyrolysis process. The effect of different pyrolysis temperatures (650-950 °C) on the MA property of the composites was investigated. When the pyrolysis temperature was 850 °C, the Co/CeO2/C-850 composite exhibited outstanding MA behavior in the frequency range of 2-18 GHz, displaying a minimum reflection loss (RLmin) of -45.22 dB and an effective absorption bandwidth (EAB) of 4.61 GHz at a thin thickness of 1.75 mm. The MA performance of the Co/CeO2/C composites is mainly attributed to the dielectric loss due to interfacial polarization originating from different interfaces and dipole polarization caused by the oxygen vacancies in CeO2. In addition, the introduction of Co nanoparticles not only provides the magnetic loss but also modulates impendence matching for the current magnetoelectric coupling system.

Novel Catalyst Composites of Ni- and Co-Based Nanoparticles Supported on Inorganic Oxides for Fatty Acid Hydrogenations

In the quest to develop nanometrically defined catalytic systems for applications in the catalytic valorization of agri-food wastes, small Ni-based nanoparticles supported on inorganic solid supports have been prepared by decomposition of organometallic precursors in refluxing ethanol under H₂ atmosphere, in the presence of supports exhibiting insulating or semi-conductor properties, such as MgAl₂O₄ and TiO₂, respectively. The efficiency of the as-prepared Ni-based nanocomposites has been evaluated towards the hydrogenation of unsaturated fatty acids under solvent-free conditions, with high selectivity regarding the hydrogenation of C=C bonds. The influence of the support on the catalytic performance of the prepared Ni-based nanocomposites is particularly highlighted.

Co-Doped CeO2/Activated C Nanocomposite Functionalized with Ionic Liquid for Colorimetric Biosensing of H2O2 via Peroxidase Mimicking

Hydrogen peroxide acts as a byproduct of oxidative metabolism, and oxidative stress caused by its excess amount, causes different types of cancer. Thus, fast and cost-friendly analytical methods need to be developed for H₂O₂. Ionic liquid (IL)-coated cobalt (Co)-doped cerium oxide (CeO₂)/activated carbon (C) nanocomposite has been used to assess the peroxidase-like activity for the colorimetric detection of H₂O₂. Both activated C and IL have a synergistic effect on the electrical conductivity of the nanocomposites to catalyze the oxidation of 3,3',5,5'-tetramethylbenzidine (TMB). The Co-doped CeO₂/activated C nanocomposite has been synthesized by the co-precipitation method and characterized by UV-Vis spectrophotometry, FTIR, SEM, EDX, Raman spectroscopy, and XRD. The prepared nanocomposite was functionalized with IL to avoid agglomeration. H₂O₂ concentration, incubation time, pH, TMB concentration, and quantity of the capped nanocomposite were tuned. The proposed sensing probe gave a limit of detection of 1.3 × 10^-8 M, a limit of quantification of 1.4 × 10^-8 M, and an R² of 0.999. The sensor gave a colorimetric response within 2 min at pH 6 at room temperature. The co-existing species did not show any interference during the sensing probe. The proposed sensor showed high sensitivity and selectivity and was used to detect H₂O₂ in cancer patients' urine samples.

Intermetallic Nanocatalyst for Highly Active Heterogeneous Hydroformylation

Hydroformylation is an imperative chemical process traditionally catalyzed by homogeneous catalysts. Designing a heterogeneous catalyst with high activity and selectivity in hydroformylation is challenging but essential to allow the convenient separation and recycling of precious catalysts. Here, we report the development of an outstanding catalyst for efficient heterogeneous hydroformylation, RhZn intermetallic nanoparticles. In the hydroformylation of styrene, it shows three times higher turnover frequency (3090 h^-1) compared to the benchmark homogeneous Wilkinson's catalyst (966 h^-1), as well as a high chemoselectivity toward aldehyde products. RhZn is active for a variety of olefin substrates and can be recycled without a significant loss of activity. Density functional theory calculations show that the RhZn surfaces reduce the binding strength of reaction intermediates and have lower hydroformylation activation energy barriers compared to pure Rh(111), leading to more favorable reaction energetics on RhZn. The calculations also predict potential catalyst design strategies to achieve high regioselectivity.

Hydrogen Yield from CO2 Reforming of Methane: Impact of La2O3 Doping on Supported Ni Catalysts

Development of a transition metal based catalyst aiming at concomitant high activity and stability attributed to distinguished catalytic characteristics is considered as the bottleneck for dry reforming of methane (DRM). This work highlights the role of modifying zirconia (ZrO2) and alumina (Al2O3) supported nickel based catalysts using lanthanum oxide (La2O3) varying from 0 to 20 wt% during dry reforming of methane. The mesoporous catalysts with improved BET surface areas, improved dispersion, relatively lower reduction temperatures and enhanced surface basicity are identified after La2O3 doping. These factors have influenced the catalytic activity and higher hydrogen yields are found for La2O3 modified catalysts as compared to base catalysts (5 wt% Ni-ZrO2 and 5 wt% Ni-Al2O3). Post-reaction characterizations such as TGA have showed less coke formation over La2O3 modified samples. Raman spectra indicates decreased graphitization for La2O3 catalysts. The 5Ni-10La2O3-ZrO2 catalyst produced 80% hydrogen yields, 25% more than that of 5Ni-ZrO2. 5Ni-15La2O3-Al2O3 gave 84% hydrogen yields, 8% higher than that of 5Ni-Al2O3. Higher CO2 activity improved the surface carbon oxidation rate. From the study, the extent of La2O3 loading is dependent on the type of oxide support.

Noble Metal Nanoparticles Incorporated Siliceous TUD-1 Mesoporous Nano-Catalyst for Low-Temperature Oxidation of Carbon Monoxide

This report, for the first time, demonstrated the low-temperature oxidation of carbon monoxide (CO) using nano-catalysts consisting of noble metal nanoparticles incorporated in TUD-1 mesoporous silica nano-structures synthesized via a one-pot surfactant-free sol–gel synthesis methodology. Herein, we investigated a nano-catalyst, represented as M-TUD-1 (M = Rh, Pd, Pt and Au), which was prepared using a constant Si/M ratio of 100. The outcome of the analytical studies confirmed the formation of a nano-catalyst ranging from 5 to 10 nm wherein noble metal nanoparticles were distributed uniformly onto the mesopores of TUD-1. The catalytic performance of M-TUD-1 catalysts was examined in the environmentally impacted CO oxidation reaction to CO₂. The catalytic performance of Au-TUD-1 benchmarked other M-TUD-1 catalysts and a total conversion of CO was obtained at 303 K. The activity of the other nano-catalysts was obtained as Pt-TUD-1 > Pd-TUD-1 > Rh-TUD-1, with a total CO conversion at temperatures of 308, 328 and 348 K, respectively. The Au-TUD-1 exhibited a high stability and reusability as indicated by the observed high activity after ten continuous runs without any treatment. The outcomes of this research suggested that M-TUD-1 are promising nano-catalysts for the removal of the toxic CO gas and can also potentially be useful to protect the environment where a long-life time, cost-effectiveness and industrial scaling-up are the key approaches.

Combining Exsolution and Infiltration for Redox, Low Temperature CH4 Conversion to Syngas

Exsolution of surface and bulk nanoparticles in perovskites has been recently employed in chemical looping methane partial oxidation because of the emergent materials’ properties such as oxygen capacity, redox stability, durability, coke resistance and enhanced activity. Here we attempt to further lower the temperature of methane conversion by complementing exsolution with infiltration. We prepare an endo/exo-particle system using exsolution and infiltrate it with minimal amount of Rh (0.1 wt%) in order to functionalize the surface and induce low temperature activity. We achieve a temperature decrease by almost 220 °C and an increase of the activity up to 40%. We also show that the initial microstructure of the perovskite plays a key role in controlling nanoparticle anchorage and carbon deposition. Our results demonstrate that microstructure tuning and surface functionalization are important aspects to consider when designing materials for redox cycling applications.

Reductant composition influences the coordination of atomically dispersed Rh on anatase TiO2

Distinct local environments for atomically dispersed Rh species on anatase TiO₂ result from reduction treatments under CO and H₂.

First-principles insight into CO hindered agglomeration of Rh and Pt single atoms on m-ZrO2

Kinetic and thermodynamic stability of single-atom and nanocluster catalysts is addressed under reaction conditions within a DFT-parametrised multi-scale thermodynamic framework combining atomistic, non-equilibrium, and nanothermodynamics.

Ultrasensitive Microfluidic Paper-Based Electrochemical Biosensor Based on Molecularly Imprinted Film and Boronate Affinity Sandwich Assay for Glycoprotein Detection

In this work, we proposed a strategy that combined molecularly imprinted polymers (MIPs) and hybridization chain reaction into microfluidic paper-based analytical devices for ultrasensitive detection of target glycoprotein ovalbumin (OVA). During the fabrication, Au nanorods with a large surface area and superior conductibility were grown on paper cellulosic fiber as a matrix to introduce a boronate affinity sandwich assay. The composite of MIPs including 4-mercaptophenylboronic acid (MPBA) was able to capture target glycoprotein OVA. SiO₂@Au nanocomposites labeled MPBA and cerium dioxide (CeO₂)-modified nicked DNA double-strand polymers (SiO₂@Au/dsDNA/CeO₂) as a signal tag were captured into the surface of the electrode in the presence of OVA. An electrochemical signal was generated by using nanoceria as redox-active catalytic amplifiers in the presence of 1-naphthol in electrochemical assays. As a result, the electrochemical assay was fabricated and could be applied in the detection of OVA in the wide linear range of 1 pg/mL to 1000 ng/mL with a relatively low detection limit of 0.87 pg/mL (S/N = 3). The results indicated that the proposed platform possessed potential applications in clinical diagnosis and other related fields.

Ethyl Acetate Abatement on Copper Catalysts Supported on Ceria Doped with Rare Earth Oxides

Different lanthanide (Ln)-doped cerium oxides (Ce_0.5Ln_0.5O_1.75, where Ln: Gd, La, Pr, Nd, Sm) were loaded with Cu (20 wt. %) and used as catalysts for the oxidation of ethyl acetate (EtOAc), a common volatile organic compound (VOC). For comparison, both Cu-free (Ce-Ln) and supported Cu (Cu/Ce-Ln) samples were characterized by N₂ adsorption at −196 °C, scanning/transmission electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, X-ray photoelectron spectroscopy and temperature programmed reduction in H₂. The following activity sequence, in terms of EtOAc conversion, was found for bare supports: CeO₂ ≈ Ce_0.5Pr_0.5O_1.75 > Ce_0.5Sm_0.5O_1.75 > Ce_0.5Gd_0.5O_1.75 > Ce_0.5Nd_0.5O_1.75 > Ce_0.5La_0.5O_1.75. Cu addition improved the catalytic performance, without affecting the activity order. The best catalytic performance was obtained for Cu/CeO₂ and Cu/Ce_0.5Pr_0.5O_1.75 samples, both achieving complete EtOAc conversion below ca. 290 °C. A strong correlation was revealed between the catalytic performance and the redox properties of the samples, in terms of reducibility and lattice oxygen availability. Νo particular correlation between the VOC oxidation performance and textural characteristics was found. The obtained results can be explained in terms of a Mars-van Krevelen type redox mechanism involving the participation of weakly bound (easily reduced) lattice oxygen and its consequent replenishment by gas phase oxygen.

Band gap energies for white nanosheets/yellow nanoislands/purple nanorods of CeO2

The photon band gap energies and spin–orbit coupling states of white nanosheets, purple nanorods and yellow nanoislands of CeO₂.