Condensed Phase Membrane Introduction Mass Spectrometry: A Direct Alternative to Fully Exploit the Mass Spectrometry Potential in Environmental Sample Analysis

Membrane introduction mass spectrometry (MIMS) is a direct mass spectrometry technique used to monitor online chemical systems or quickly quantify trace levels of different groups of compounds in complex matrices without extensive sample preparation steps and chromatographic separation. MIMS utilizes a thin, semi-permeable, and selective membrane that directly connects the sample and the mass spectrometer. The analytes in the sample are pre-concentrated by the membrane depending on their physicochemical properties and directly transferred, using different acceptor phases (gas, liquid or vacuum) to the mass spectrometer. Condensed phase (CP) MIMS use a liquid as a medium, extending the range to new applications to less-volatile compounds that are challenging or unsuitable to gas-phase MIMS. It directly allows the rapid quantification of selected compounds in complex matrices, the online monitoring of chemical reactions (in real-time), as well as in situ measurements. CP-MIMS has expanded beyond the measurement of several organic compounds because of the use of different types of liquid acceptor phases, geometries, dimensions, and mass spectrometers. This review surveys advancements of CP-MIMS and its applications to several molecules and matrices over the past 15 years.

An advanced LC-MS/MS protocol for simultaneous detection of pharmaceuticals and personal care products in the environment

RATIONALE

The development of appropriate analytical screening techniques for pharmaceuticals and personal care products (PPCPs) is the basis for studying the distribution and environmental impact of emerging contaminants (ECs). Mass spectrometry-based screening methods vary with the complexity of the target compounds. It is challenging to balance both positive and negative ion quantification with a low detection limit. To establish a set of experimental methods including extraction, chromatography-separation and mass spectrometry screening is one of the most important topics in PPCP research. This paper describes a universal and efficient qualification and quantification protocol for the simultaneous detection of 34 PPCPs in different environmental samples in a single analytical data acquisition run.

METHODS

Thirty-four representative PPCPs, which are widely distributed in the environment with high ecological toxicity and complex chemical structures, were selected as representative target ECs. The extraction of the target PPCPs was achieved using only one solid-phase extraction cartridge without the need to adjust the pH of samples. The enriched samples were detected by LC-MS/MS in both positive and negative ion modes simultaneously. The protocol was evaluated based on the accuracy, precision, detection limits and matrix effects.

RESULTS

This method achieved simultaneous detection of PPCPs in both positive and negative ion modes, with a single analytical cycle of 12 min. The observed SPE recoveries were between 40% and 115%. The instrumental detection limits (IDL) varied from 0.01 to 1 pg, and the method detection limits (MDL) were between 0.002 and 3.323 ng/l in different matrices. Most of the PPCPs were subjected to matrix suppression below 30%. The method was successfully applied for quantitative analysis of the PPCPs in different environmental samples, including river samples, wastewater treatment plant (WWTP) samples and soil samples.

CONCLUSIONS

This protocol developed a rapid and efficient detection method to simultaneous qualitative and quantitative 34 representative PPCPs in the environment. The IDL ranged from 0.01 to 1 pg and the MDL ranged from 0.002 to 3.323 ng/l in different matrices. The detection limit was one order of magnitude lower compared to previous studies. The protocol also provided a wide application range for different environmental matrices, which permitted the migration and transformation of PPCPs to be explored.

Photosensitized Transformation of Peroxymonosulfate in Dissolved Organic Matter Solutions under Simulated Solar Irradiation

Sulfate radical (SO₄^•-)-mediated advanced oxidation processes via peroxymonosulfate (PMS) activation have been extensively investigated. However, the phototransformation of PMS in sunlit dissolved organic matter (DOM) solution has not been previously examined. For the first time, the photosensitized transformation of PMS in DOM-enriched solutions under simulated solar irradiation was observed. The generation of reactive species, including ¹O₂, SO₄^•-, and ^•OH, was confirmed by electron paramagnetic resonance and quantified by chemical probes. SO₄^•- was the primary reactive species generated via the reaction of excited triplet DOM (³DOM*) with PMS. ³DOM* acted as a reactive reductant and was quickly oxidized by PMS, with an estimated reaction rate constant of (4.09 ± 0.21) × 10⁸ M^-1 s^-1. Compared to ³DOM*, one-electron-reducing DOM (DOM^•-) was a minor contributor to the photosensitized transformation of PMS, and the contribution of DOM^•- relied on the phenolic constituents. In addition, a series of different types of DOM, including terrestrial DOM, autochthonous DOM, and effluent organic matter and its fractions, were employed to examine the photosensitized transformation kinetics of PMS. Overall, the photosensitized transformation of PMS by irradiated DOM could be a useful and economical approach to generate SO₄^•- under environmentally relevant conditions.

A Direct Mass Spectrometry Method for the Rapid Analysis of Ubiquitous Tire-Derived Toxin N-(1,3-Dimethylbutyl)-N'-phenyl-p-phenylenediamine Quinone (6-PPDQ)

The oxidative transformation product of a common tire preservative, identified as N-(1,3-dimethylbutyl)-N'-phenyl-p-phenylenediamine quinone (6-PPDQ), has recently been found to contribute to "urban runoff mortality syndrome" in Coho salmon at nanogram per liter levels. Given the number of fish-bearing streams with multiple stormwater inputs, large-scale campaigns to identify 6-PPDQ sources and evaluate mitigation strategies will require sensitive, high-throughput analytical methods. We report the development and optimization of a direct sampling tandem mass spectrometry method for semiquantitative 6-PPDQ determinations using a thin polydimethylsiloxane membrane immersion probe. The method requires no sample cleanup steps or chromatographic separations, even in complex, heterogeneous samples. Quantitation is achieved by the method of standard additions, with a detection limit of 8 ng/L and a duty cycle of 15 min/sample. High-throughput screening provides semiquantitative concentrations with similar sensitivity and a full analytical duty cycle of 2.5 min/sample. Preliminary data and performance metrics are reported for 6-PPDQ present in representative environmental and stormwater samples. The method is readily adapted for real-time process monitoring, demonstrated by following the dissolution of 6-PPDQ from tire fragments and subsequent removal in response to added sorbents.

Daylight LED promotes photochemical ring contraction of 2-amine-4H-pyran-3-carbonitriles with consequent loss of their antifungal activity

The initial objective of our work was to synthesize a series of 2-amino-4H-pyran-3-carbonitriles to be tested for their antifungal activities against economically relevant phytopathogenic fungi. Fourteen compounds were prepared in up to 94% yield and shown percentages of Botrytis cinerea inhibition above 70%. Despite the promising biological results, we observed that stock solutions prepared for biological tests showed color changing when kept for a few days on the laboratory bench, under room conditions, illuminated by common LED daylight tubes (4500-6000 k). This prompted us to investigate the possible photo-induced degradation of our compounds. FT-IR ATR experiments evidenced variations in the expected bands for functional of -amino-4H-pyran-3-carbonitriles stored under LED daylight. Following, HPLC-UV analysis showed reductions in the intensity of chromatographic peaks of 2-amino-4H-pyran-3-carbonitriles, and but not for solutions kept in the dark. A solution of (E)-2-amino-8-(4-nitrobenzylidene)-4-(4-nitrophenyl)-5,6,7,8-tetrahydro-4H-chromene-3-carbonitrile underwent 84.4% of conversion after 72 h of exposure to continuous LED daylight in a BOD chamber, and the reaction product was isolated in 36% yield and characterized as (E)-7-cyano-5-(4-nitrobenzylidene)-8-(4-nitrophenyl)bicyclo[4.2.0]oct-1(6)-ene-7-carboxamide (7*). Despite freshly prepared solutions of 2-amino-4H-pyran-3-carbonitriles produced antifungal activities, these solutions lost biological activity when left on the bench for a week. Besides, compound 7* formed from photo-induced degradation of 7 also showed no antifungal activity. With this, we hope to bring two contributions: (1) production of cyclobutenes through photochemical reactions of 2-amino-4H-pyran-3-carbonitriles can be carried out through exposure to simple white LED daylight; (2) biological applications of such 2-amino-4H-pyran-3-carbonitriles may be impaired by their poor photostability.

Combined fluorescent measurements, parallel factor analysis and GC-mass spectrometry in evaluating the photodegradation of PAHS in freshwater systems

To better understand the transformation and photochemical fate of PAHs in aquatic environments, a custom-designed closed-circuit recirculation photodegradation system, combined with inline semi-continuous fluorescence and absorbance measurements, as well as modelling of excitation-emission (EEM) measurements with parallel factor analysis (PARAFAC), and GC-MS analysis, were combined to create a robust tool for holistically assessing the photodegradation of individual PAHs, their mixtures and photoproduct formation. Selected compounds included in the US EPA priority list, representing 2- to 6-ring compounds, were monitored individually and in mixtures, during 24 h photodegradation experiments. Experiments were conducted in solutions simulating ideal (ultrapure water) and environmentally relevant conditions (1.00 mg L^-1 Suwannee River Natural Organic Matter (SRNOM)). The fluorescence, primary PARAFAC components and quantification data obtained by GC-MS, indicated that the decline in parent molecule concentration occurred rapidly within 200 min. The degradation rates of parent PAHs increased with aromaticity (6-ring ≫ 2-ring PAHs) and followed pseudo-first order degradation kinetics. The presence and transformation of degradation products, were captured by PARAFAC. NOM influenced the diversity of photoproducts. From the GC-MS results, photoproducts were only detected in Ant, BAnt and the PAH mixture solutions, but optical property analyses indicated that diverse changes occurred with all PAHs. Spectrometric and chromatographic data demonstrated that parent PAHs and photoproducts co-existed at various stages, which is significant for freshwater systems contaminated with these compounds if photoproducts have higher-toxic potential. These results may be used to model the hazard-potential associated with PAHs present in freshwater systems and understanding the mechanisms that govern their environmental fate.

Reductive Dechlorination of Chloroacetamides with NaBH4 Catalyzed by Zero Valent Iron, ZVI, Nanoparticles in ORMOSIL Matrices Prepared via the Sol-Gel Route

The efficient reductive dechlorination, as remediation of dichloroacetamide and monochloroacetamide, toxic and abundant pollutants, using sodium borohydride catalyzed by zero valent iron nanoparticles (ZVI-NPs), entrapped in organically modified hybrid silica matrices prepared via the sol-gel route, ZVI@ORMOSIL, is demonstrated. The results indicate that the extent of the dechlorination reaction depends on the nature of the substrate and on the reaction medium. By varying the amount of catalyst or reductant in the reaction it was possible to obtain conditions for full dechlorination of these pollutants to nontoxic acetamide and acetic acid. A plausible mechanism of the catalytic process is discussed. The present work expands the scope of ZVI-NP catalyzed reduction of polluting compounds, first reports the catalytic parameters of chloroacetamide reduction, and offers additional insight into the heterogeneous catalyst structure of M0@ORMOSIL sol-gel. The ZVI@ORMOSIL catalyst is ferromagnetic and hence can be recycled easily.

Mass Spectrometry Based Approach for Organic Synthesis Monitoring

Current mass spectrometry-based methodologies for synthetic organic reaction monitoring largely use electrospray ionization (ESI), or other related atmospheric pressure ionization-based approaches. Monitoring of complex, heterogeneous systems may be problematic because of sampling hardware limitations, and many relevant analytes (neutrals) exhibit poor ESI performance. An alternative monitoring strategy addressing this significant impasse is condensed phase membrane introduction mass spectrometry using liquid electron ionization (CP-MIMS-LEI). In CP-MIMS, a semipermeable silicone membrane selects hydrophobic neutral analytes, rejecting particulates and charged chemical components. Analytes partition through the membrane, and are then transported to the LEI interface for sequential nebulization, vaporization, and ionization. CP-MIMS and LEI are both ideal for continuous monitoring applications of hydrophobic neutral molecules. We demonstrate quantitative reaction monitoring of harsh, complex reaction mixtures (alkaline, acidic, heterogeneous) in protic and aprotic organic solvents. Also presented are solvent-membrane compatibility investigations and, in situ quantitative monitoring of catalytic oxidation and alkylation reactions.

Triplet state dissolved organic matter in aquatic photochemistry: reaction mechanisms, substrate scope, and photophysical properties

Excited triplet states of chromophoric dissolved organic matter (³CDOM*) play a major role among the reactive intermediates produced upon absorption of sunlight by surface waters. After more than two decades of research on the aquatic photochemistry of ³CDOM*, the need for improving the knowledge about the photophysical and photochemical properties of these elusive reactive species remains considerable. This critical review examines the efforts to date to characterize ³CDOM*. Information on ³CDOM* relies mainly on the use of probe compounds because of the difficulties associated with directly observing ³CDOM* using transient spectroscopic methods. Singlet molecular oxygen (¹O₂), which is a product of the reaction between ³CDOM* and dissolved oxygen, is probably the simplest indicator that can be used to estimate steady-state concentrations of ³CDOM*. There are two major modes of reaction of ³CDOM* with substrates, namely triplet energy transfer or oxidation (via electron transfer, proton-coupled electron transfer or related mechanisms). Organic molecules, including several environmental contaminants, that are susceptible to degradation by these two different reaction modes are reviewed. It is proposed that through the use of appropriate sets of probe compounds and model photosensitizers an improved estimation of the distribution of triplet energies and one-electron reduction potentials of ³CDOM* can be achieved.