Combining electrochemical and quantitative elemental analysis to investigate the sulfur poisoning process of ceria thin film fuel electrodes

This work deals with the effect of sulfur incorporation into model-type GDC thin films on their in-plane ionic conductivity. By means of impedance measurements, a strongly deteriorating effect on the grain boundary conductivity was confirmed, which additionally depends on the applied electrochemical polarisation. To quantify the total amount of sulfur incorporated into GDC thin films, online-laser ablation of solids in liquid (online-LASIL) was used as a novel solid sampling strategy. Online-LASIL combines several advantages of conventional sample introduction systems and enables the detection of S as a minor component in a very limited sample system (in the present case 35 μg total sample mass). To reach the requested sensitivity for S detection using an inductively coupled plasma-mass spectrometer (ICP-MS), the reaction cell of the quadrupole instrument was used and the parameters for the mass shift reaction with O₂ were optimised. The combination of electrical and quantitative analytical results allows the identification of a potential sulfur incorporation pathway, which very likely proceeds along GDC grain boundaries with oxysulfide formation as the main driver of ion transport degradation. Depending on the applied cathodic bias, the measured amount of sulfur would be equivalent to 1-4 lattice constants of GDC transformed into an oxysulfide phase at the material's grain boundaries.

Effects of alloying for steam or dry reforming of methane: a review of recent studies

A survey on the catalytic nature of Ni-based alloy catalysts in recent years provides a direction for future catalyst development.

Focus on Materials for Sulfur-Resistant Catalysts in the Reforming of Biofuels

The reforming of biofuels represents a promising technology for low carbon and renewable hydrogen production today. The core of the process is an active and stable catalyst, which can help to improve this technology and its efficiency. With this review, we aim to survey the more relevant literature on heterogeneous catalysts for the reforming of biofuels with improved sulfur tolerance. The review is structured into four main sections. Following the introduction, the fundamental aspects of sulfur poisoning are discussed. In the third section, the basic principles of the reforming of biofuels are reported, and finally, in the fourth section—the core of the review—recent progresses in the development of sulfur resistant catalysts are discussed, distinguishing the role of the metal (noble and non-noble) from that of the support.

Development of Ni-based alloy catalysts to improve the sulfur poisoning resistance of Ni/YSZ anodes in SOFCs

Alloying Au into Ni surfaces provides a way to alleviate sulfur poisoning in the anode of solid oxide fuel cells.

Experimental Clarification of the RWGS Reaction Effect in H2O/CO2 SOEC Co-Electrolysis Conditions

In the present investigation, modified X-Ni/GDC electrodes (where X = Au, Mo, and Fe) are studied, in the form of half-electrolyte supported cells, for their performance in the RWGS through catalytic-kinetic measurements. The samples were tested at open circuit potential conditions in order to elucidate their catalytic activity towards the production of CO (rco), which is one of the products of the H2O/CO2 co-electrolysis reaction. Physicochemical characterization is also presented, in which the samples were examined in the form of powders and as half cells with BET, H2-TPR, Air-TPO and TGA re-oxidation measurements in the presence of H2O. In brief, it was found that the rate of the produced CO (rco) increases by increasing the operating temperature and the partial pressure of H2 in the reaction mixture. In addition, the first results revealed that Fe and Mo modification enhances the catalytic production of CO, since the 2wt% Fe-Ni/GDC and 3wt% Mo-Ni/GDC electrodes were proven to perform better compared to the other samples, in the whole studied temperature range (800–900 °C), reaching thermodynamic equilibrium. Furthermore, carbon formation was not detected.