Fluid Mechanical and Visible-Light-Driven Piezophotocatalysis in MoS2/Carbon-Rich Carbon Nitride Heterostructures for Enhanced Green Energy Production and Environmental Remediation

Molybdenum disulfide (MoS2)/carbon-rich carbon nitride (TCN) heterostructure, a piezophotocatalyst sensitive to fluid mechanical energy and visible light, has been developed for green energy production and environmental remediation. The optimized MoS2/TCN heterostructure exhibits an absorption edge at 520 nm, identical to that of TCN but significantly red-shifted compared with conventional carbon nitride. Piezopotential measurements via piezoelectric force microscopy demonstrate that the MoS2/TCN heterostructure generates a much higher piezopotential response than TCN under the same applied voltage. This heterostructure exhibits substantial improvements in photocatalytic performance for both the hydrogen evolution reaction (HER) and the degradation of tetracycline (TC) under visible light. Additionally, its photocatalytic activity is further enhanced by vortex-induced fluid motion. Compared to TCN, the piezophotocatalytic activity of the optimized MoS2/TCN heterostructure increases the HER rate from 1.8 to 3.62 mmol g-1 h-1 and the TC degradation rates from 57.8 to 85.1% and 73.2 to 98.8% in 15 and 60 min, respectively. MoS2 nanosheets act as piezoelectric generators, triggered by fluid flow, to induce a macroscopic piezopotential, aiding in the collection of visible-light-generated electrons and holes on the TCN surface to enhance catalytic activity. This work highlights that the shearing forces from fluid flow, essential for wastewater discharge, piezoelectrically amplify the photocatalytic efficiency of the MoS2/TCN heterostructure.

Mild-Condition Photocatalytic Reforming of Methanol-Water by a Hierarchical, Asymmetry Carbon Nitride

As a reproducible intermediate for hydrogen (H2) and carbon cycling, methanol mixed with water (H2O) in a ratio of 1 : 1 can multiply the outcome of green H2 generation via Photocatalytic reforming of methanol-H2O (PRMW). Hitherto, low-energy and mild-condition PRMW remains a serious challenge. Here, the amino acid-derived carbon nitrides (ACN) were synthesized supramolecular precursor strategy for PRMW and achieved excellent performance (H2, 35.6 mmol h-1 g-1; CO2, 11.5 mmol h-1 g-1) under sunlight at 35 °C. It was revealed that the surface-terminating carboxyl groups (-COOH) promote the dark dehydrogenation of methanol on MetCNx to form methoxy (*OCH3) and methylol (*CH2OH) simultaneously, with the hydroxyl (*OH) generated by photostimulated H2O oxidation promotes the C-H activation of formaldehyde, then leads the whole reaction into the formation of CO2 and three H2. The extended light absorption, enhanced charge separation and transport, and efficient surface reaction improve photocatalytic efficiency.

Defective Potassium Poly(Heptazine Imide) Preventing Spin Delocalization and Hole Transfer Deactivation for Efficient Solar Energy Conversion and Storage

Anti-site defective potassium poly(heptazine imide) (KPHI) with the central nitrogen atoms partially replaced by graphitic carbon atoms in the flawed heptazine rings is prepared by direct ionothermal treatment of the rationally designed supramolecular complex in KSCN salt molten. Compared to the KPHIs without the anti-site defect, the anti-site defective KPHI demonstrates significantly improved photocatalytic and dark photocatalytic performances for H2 evolution reaction (HER). In the presence of the hole scavenger, the anti-site defective KPHI exhibits superior photocatalytic stability for HER lasting 20 h, whereas the deactivation is observed from the ordinary KHPIs after 3 h HER. Moreover, the H2 yield in the dark by the stored photoelectrons in the anti-site defective KPHI increases by more than an order of magnitude. Density functional theory calculations reveal that the anti-site defective unit in KPHI not only prevents spin delocalization but also inhibits the deactivation of hole transfer, which are beneficial to photoelectron storage and photocatalytic activity. The findings in this study provide insight into the photophysical and catalytic properties of KPHI, which conclude a strategy to improve the performances for solar energy conversion and storage by incorporating intrinsic anti-site defects in KPHI.

Controllable Generation of Reactive Oxygen Species on Cyano-Group-Modified Carbon Nitride for Selective Epoxidation of Styrene

The controlled generation of reactive oxygen species (ROS) to selectively epoxidize styrene is a grand challenge. Herein, cyano-group-modified carbon nitrides (CNCY x and CN-T y ) are prepared, and the catalysts show better performance in regulating ROS and producing styrene oxide than the cyano-free sample. The in situ diffuse reflectance infrared and density functional theory calculation results reveal that the cyano group acts as the adsorption and activation site of oxygen. X-ray photoelectron spectroscopy and NMR spectrum results confirm that the cyano group bonds with the intact heptazine ring. This unique structure could inhibit H2O2 and ⋅OH formation, resulting in high selectivity of styrene oxide. Furthermore, high catalytic activity is still achieved when the system scales up to 2.7 L with 100 g styrene under solar light irradiation. The strategy of cyano group modification gives a new insight into regulating spatial configuration for tuning the utilization of oxygen-active species and shows potential applications in industry.

Highly enhanced H2 evolution of MoO3/g-C3N4 hybrid composites based on a direct Z-scheme photocatalytic system

A direct Z-scheme MoO₃/g-C₃N₄ heterojunction with appropriate oxygen vacancies is successfully fabricated via an in situ method of a one-pot pyrolysis strategy.

A novel design of SiH/CeO2(111) van der Waals type-II heterojunction for water splitting

Searching for economical low-dimensional materials to construct the highly efficient type-II heterojunction photocatalysts for splitting water into hydrogen is very strategic. In this study, using the first-principles calculations, we construct a novel SiH/CeO2(111) type-II heterojunction with a very small lattice mismatch of less than 1%. Based on AIMD simulation and phonon dispersion calculations, the SiH/CeO2(111) heterojunction reveals sufficient stability, and is easy to synthesize. Due to the vdW interaction between SiH and CeO2(111) components, electron and hole accumulation regions form at the heterojunction interface, which is very conducive to the separation of photoexcited electron-hole pairs. Besides, the SiH/CeO2(111) heterojunction has good visible light response, and even a strong absorption peak of up to 8.7 × 105 cm-1 in the high-energy visible region. More importantly, the SiH/CeO2(111) heterojunction exhibits good OER and HER performance because its oxidation and reduction potentials well meet the requirements of water splitting. Consequently, SiH/CeO2(111) is a potential photocatalyst for splitting water to hydrogen.