Accelerated start-up, long-term performance and microbial community shifts within a novel upflow porous-plated anaerobic reactor treating nitrogen-rich wastewater via ANAMMOX process

Feasibility of low-intensity ultrasound treatment with hydroxylamine to accelerate the initiation of partial nitrification and allow operation under intermittent aeration

Partial nitrification is a key aspect of efficient nitrogen removal, although practically it suffers from long start-up cycles and unstable long-term operational performance. To address these drawbacks, this study investigated the effect of low intensity ultrasound treatment combined with hydroxylamine (NH2OH) on the performance of partial nitrification. Results show that compared with the control group, low-intensity ultrasound treatment (0.10 W/mL, 15 min) combined with NH2OH (5 mg/L) reduced the time required for partial nitrification initiation by 6 days, increasing the nitrite accumulation rate (NAR) and ammonia nitrogen removal rate (NRR) by 20.4% and 6.7%, respectively, achieving 96.48% NRR. Mechanistic analysis showed that NH2OH enhanced ammonia oxidation, inhibited nitrite-oxidizing bacteria (NOB) activity and shortened the time required for partial nitrification initiation. Furthermore, ultrasonication combined with NH2OH dosing stimulated EPS (extracellular polymeric substances) secretion, increased carbonyl, hydroxyl and amine functional group abundances and enhanced mass transfer. In addition, 16S rRNA gene sequencing results showed that ultrasonication-sensitive Nitrospira disappeared from the ultrasound + NH2OH system, while Nitrosomonas gradually became the dominant group. Collectively, the results of this study provide valuable insight into the enhancement of partial nitrification start-up during the process of wastewater nitrogen removal.

Ecological interactions and the underlying mechanism of anammox and denitrification across the anammox enrichment with eutrophic lake sediments

BACKGROUND

Increasing attention has recently been devoted to the anaerobic ammonium oxidation (anammox) in eutrophic lakes due to its potential key functions in nitrogen (N) removal for eutrophication control. However, successful enrichment of anammox bacteria from lake sediments is still challenging, partly due to the ecological interactions between anammox and denitrifying bacteria across such enrichment with lake sediments remain unclear.

RESULTS

This study thus designed to fill such knowledge gaps using bioreactors to enrich anammox bacteria with eutrophic lake sediments for more than 365 days. We continuously monitored the influent and effluent water, measured the anammox and denitrification efficiencies, quantified the anammox and denitrifying bacteria, as well as the related N cycling genes. We found that the maximum removal efficiencies of NH₄⁺ and NO₂^- reached up to 85.92% and 95.34%, respectively. Accordingly, the diversity of anammox and denitrifying bacteria decreased significantly across the enrichment, and the relative dominant anammox (e.g., Candidatus Jettenia) and denitrifying bacteria (e.g., Thauera, Afipia) shifted considerably. The ecological cooperation between anammox and denitrifying bacteria tended to increase the microbial community stability, indicating a potential coupling between anammox and denitrifying bacteria. Moreover, the nirS-type denitrifiers showed stronger coupling with anammox bacteria than that of nirK-type denitrifiers during the enrichment. Functional potentials as depicted by metagenome sequencing confirmed the ecological interactions between anammox and denitrification. Metagenome-assembled genomes-based ecological model indicated that the most dominant denitrifiers could provide various materials such as amino acid, cofactors, and vitamin for anammox bacteria. Cross-feeding in anammox and denitrifying bacteria highlights the importance of microbial interactions for increasing the anammox N removal in eutrophic lakes.

CONCLUSIONS

This study greatly expands our understanding of cooperation mechanisms among anammox and denitrifying bacteria during the anammox enrichment with eutrophic lake sediments, which sheds new insights into N removal for controlling lake eutrophication. Video Abstract.

Impact of soluble organic matter and particulate organic matter on anammox system: Performance, microbial community and N2O production

In this study, the effects of soluble readily biodegradable COD (sCOD) and particulate slowly biodegradable COD (pCOD) on anammox process were investigated. The results of the long-term experiment indicated that a low sCOD/N ratio of 0.5 could accelerate the anammox and denitrification activity, to reach as high as 84.9%±2.8% TN removal efficiency. Partial denitrification-anammox (PDN/anammox) and denitrification were proposed as the major pathways for nitrogen removal, accounting for 91.3% and 8.7% of the TN removal, respectively. Anammox bacteria could remain active with high abundance of anammox genes to maintain its dominance. Candidatus Kuenenia and Thauera were the predominant genera in the presence of organic matter. Compared with sCOD, batch experiments showed that the introduction of pCOD had a negative effect on nitrogen removal. The contribution of denitrification to nitrogen removal decreased from approximately 14% to 3% with increasing percentage of pCOD. In addition, the analysis result of the process data using an optimized ASM1 model indicated that high percentage of pCOD resulted in serious N₂O emission (the peak value up to 0.25 mg N/L), which was likely due to limited mass diffusion and insufficient available carbon sources for denitrification. However, a high sCOD/N ratio was beneficial for alleviating N₂O accumulation.

Distinctive differences in the granulation of saline and non-saline enriched anaerobic ammonia oxidizing (AMX) bacteria

The growing interest in the anaerobic ammonium oxidizing (AMX) process in treating high nitrogen containing wastewaters and a comprehensive study into the granulation mechanism of these bacteria under diverse environmental conditions over the years have been unequal. To this effect, the distinctive differences in saline adapted AMX (S_AMX) and non-saline adapted AMX (NS_AMX) granules are presented in this study. It was observed that substrate utilisation profiles, granule formation mechanism, and pace towards granulation differed marginally for the two adaptation conditions. The different microbial dominant aggregation types aided in splitting the 471 days operated lab-scale SBRs into three distinct phases. In both reactors, phase III (granules dominant phase) showed the highest average nitrogen removal efficiency of 87.9% ± 4.8% and 85.6% ± 3.6% for the S_AMX and NS_AMX processes, respectively. The extracellular polymeric substances (EPS) quantity and major composition determined its role either as a binding agent in granulation or a survival mechanism in saline adaptation. It was also observed that granules of the S_AMX reactor were mostly loosely and less condensed aggregates of smaller sub-units and flocs while those of the NS_AMX reactor were compact agglomerates. The ionic gradient in saline enrichment led to an increased activity of the Na⁺/K⁺ - ATPase, hence enriched granules produced higher cellular adenosine triphosphate molecules which finally improved the granules active biomass ratio by 32.96%. Microbial community showed that about three to four major known AMX species made up the granules consortia in both reactors. Proteins and expression of functional genes differed for these different species.

From freshwater anammox bacteria (FAB) to marine anammox bacteria (MAB): A stepwise salinity acclimation process

An investigation into the effect of stepwise saline introduction (3-20 g·L^-1 NaCl) on the anaerobic ammonium oxidation (anammox) process in a lab-scale sequencing batch reactor was carried out for 252 days by evaluating the changes in influent and effluent nitrogen concentrations, conductivity, microbial extracellular polymeric substances' (EPS) ionic content, as well as stresses due to salinity, via microbial ATP analysis. It was observed that, effluent nitrogen concentrations remained stable at low saline levels of 3 g·L^-1 to 10 g·L^-1. Nonetheless, midway through 10 g·L^-1 and the preliminary phase of 15 g·L^-1 salinity presented a very unstable, highly fluctuating as well as deteriorating effluent nitrogen concentrations. A more satisfactory nitrogen removal efficiency of 83.7 ± 5.9% was obtained at higher saline concentrations implying that, the adaptation mechanism to tolerate increasing salinity was taking place. Saline induced stress, which measures the variation in viable anammox bacteria, was correlative to the formation of EPS and changes in its cationic contents along the increasing salinity. Although the specific anammox activity (SAA) dropped by approximately 15% from the beginning of the process to the midpoint, the drop in SAA after the midpoint was not as drastic as the initial phase. A change in microbial aggregation and dominance proved the existence of new saline-dependent species that can withstand high saline stresses. Recovery from abrupt high saline shocks in batch experiment was seen to be almost impossible.

Adaptation, restoration and collapse of anammox process to La(III) stress: Performance, microbial community, metabolic function and network analysis

During the mining of rare earth mineral, the use of lanthanum-containing fertilizers, and the disposal of lanthanum-containing electronic products, the content of lanthanum (La(III)) in typical ammonia wastewater with low carbon to nitrogen ratio is increasing day by day. Here, effects of La(III) on anammox process in performance, microbial community structure, metabolic function, and microbial co-occurrence network were investigated. The results shown that the nitrogen removal efficiency was declines briefly and then gradually recovers after low dosage (1-5 mg/L) La(III) treatment and the decrease to low level (24.25 ± 1.74%) under high La(III) dosage (10 mg/L). La(III) in the range of 1-5 mg/L significantly promoted the relative abundance of Anammoxoglobus (0.024% to 9.762%). The blocking of key metabolic pathways was confirmed to cause the breakdown of anammox by PICRUSt. Furthermore, network analysis revealed that lack of cooperation bacteria limits the activity of Anammoxoglobus.

High-quality bacterial genomes of a partial-nitritation/anammox system by an iterative hybrid assembly method

BACKGROUND

Genome-centric approaches are widely used to investigate microbial compositions, dynamics, ecology, and interactions within various environmental systems. Hundreds or even thousands of genomes could be retrieved in a single study contributed by the cost-effective short-read sequencing and developed assembly/binning pipelines. However, conventional binning methods usually yield highly fragmented draft genomes that limit our ability to comprehensively understand these microbial communities. Thus, to leverage advantage of both the long and short reads to retrieve more complete genomes from environmental samples is a must-do task to move this direction forward.

RESULTS

Here, we used an iterative hybrid assembly (IHA) approach to reconstruct 49 metagenome-assembled genomes (MAGs), including 27 high-quality (HQ) and high-contiguity (HC) genomes with contig number ≤ 5, eight of which were circular finished genomes from a partial-nitritation anammox (PNA) reactor. These 49 recovered MAGs (43 MAGs encoding full-length rRNA, average N50 of 2.2 Mbp), represented the majority (92.3%) of the bacterial community. Moreover, the workflow retrieved HQ and HC MAGs even with an extremely low coverage (relative abundance < 0.1%). Among them, 34 MAGs could not be assigned to the genus level, indicating the novelty of the genomes retrieved using the IHA method proposed in this study. Comparative analysis of HQ MAG pairs reconstructed using two methods, i.e., hybrid and short reads only, revealed that identical genes in the MAG pairs represented 87.5% and 95.5% of the total gene inventory of hybrid and short reads only assembled MAGs, respectively. In addition, the first finished anammox genome of the genus Ca. Brocadia reconstructed revealed that there were two identical hydrazine synthase (hzs) genes, providing the exact gene copy number of this crucial phylomarker of anammox at the genome level.

CONCLUSIONS

Our results showcased the high-quality and high-contiguity genome retrieval performance and demonstrated the feasibility of complete genome reconstruction using the IHA workflow from the enrichment system. These (near-) complete genomes provided a high resolution of the microbial community, which might help to understand the bacterial repertoire of anammox-associated systems. Combined with other validation experiments, the workflow can enable a detailed view of the anammox or other similar enrichment systems. Video Abstract.

Anammox and partial denitrification coupling: a review

As a new wastewater biological nitrogen removal process, anammox and partial denitrification coupling not only plays a significant role in the nitrogen cycle, but also holds high engineering application value. Because anammox and some denitrifying bacteria are coupled under harsh living conditions, certain operating conditions and mechanisms of the coupling process are not clear; thus, it is more difficult to control the process, which is why the process has not been widely applied. This paper analyzes the research focusing on the coupling process in recent years, including anammox and partial denitrification coupling process inhibitors such as nitrogen (NH₄⁺, NO₂⁻), organics (toxic and non-toxic organics), and salts. The mechanism of substrate removal in anammox and partial denitrification coupling nitrogen removal is described in detail. Due to the differences in process methods, experimental conditions, and sludge choices between the rapid start-up and stable operation stages of the reactor, there are significant differences in substrate inhibition. Multiple process parameters (such as pH, temperature, dissolved oxygen, redox potential, carbon-to-nitrogen ratio, and sludge) can be adjusted to improve the coupling of anammox and partial denitrification to modify nitrogen removal performance.

As a new wastewater biological nitrogen removal process, anammox and partial denitrification coupling not only plays a significant role in the nitrogen cycle, but also holds high engineering application value.

Investigation of the process stability of different anammox configurations and assessment of the simulation validity of various anammox-based kinetic models

Over the last 30 years, the successful implementation of the anammox process has attracted research interest from all over the world. Various reactor configurations were investigated for the anammox process. However, the construction of the anammox process is a delicate topic in regards to the high sensitivity of the biological reaction. To better understand the effects of configurations on the anammox performance, process-kinetic models and activity kinetic models were critically overviewed, respectively. A significant difference in the denitrification capabilities was observed even with similar dominated functional species of anammox with different configurations. Although the kinetic analysis gained insight into the feasibility of both batch and continuous processes, most models were often applied to match the kinetic data in an unsuitable manner. The validity assessment illustrated that the Grau second-order model and Stover–Kincannon model were the most appropriate and shareable reactor-kinetic models for different anammox configurations. This review plays an important role in the anammox process performance assessment and augmentation of the process control.

Over the last 30 years, the successful implementation of the anammox process has attracted research interest from all over the world.