Probing P25 TiO2 photocatalysis using photoinduced absorption spectroscopy (PIAS)

Photoinduced absorption spectroscopy (PIAS) study of water and chloride oxidation by a WO3 photoanode in acidic solution

The mechanisms of water and chloride oxidation by a WO3 photoanode are probed by photoinduced absorption spectroscopy (PIAS) coupled with transient photocurrent (TC) measurements. Linear sweep voltammograms (LSVs) and incident photon to current efficiencies (IPCEs) are obtained, in the water oxidation electrolyte (1 M HClO4) and chloride oxidation electrolyte (3.5 M NaCl in 1 M HClO4). Other work shows that the faradaic efficiency of water oxidation to O2 in 1 M HClO4 is ca. 1.0, and that for chloride oxidation to Cl2 in 3.5 M NaCl plus 1 M HClO4 is ca. 0.62. The PIAS/TC data reveals a 0.4 order dependency of the rate of water oxidation on the steady state concentration of photogenerated surface holes, [hs+]ss, and an approximately first order dependency of the rate of chloride oxidation on [hs+]ss. Associated mechanisms and rate determining steps for water and chloride oxidation at the photoanode surface that account for these reaction orders are proposed.

Study and Modeling of the Kinetics of the Photocatalytic Destruction of Stearic Acid Islands on TiO2 Films

The kinetics of the removal of stearic acid (SA) islands by photocatalytic coatings is controversial, with some reporting that the islands fade as their thickness, h, decreases with the irradiation time, t, but maintain a constant area, a, -da/dt = 0, and others reporting that -dh/dt = 0 and -da/dt = -constant, i.e., the islands shrink, rather than fade. This study attempts to understand the possible cause for these two very different observations through a study of the destruction of a cylindrical SA island and an array of such islands, on two different photocatalytic films, namely, Activ self-cleaning glass, and a P25 TiO₂ coating on glass, which have established uniform and heterogeneous surface activities, respectively. In both cases, using optical microscopy and profilometry, it is shown that, irrespective of whether there is as a single cylindrical island or an array of islands, h decreases uniformly with t, -dh/dt = constant, and -da/dt = 0, so that the SA islands just fade. However, in a study of the photocatalyzed removal of SA islands with a volcano-shaped profile, rather than that of a cylinder, it is found that the islands shrink and fade. A simple 2D kinetic model is used to rationalize the results reported in this work. Possible reasons for the two very different kinetic behaviors are discussed. The relevance of this work to self-cleaning photocatalytic films is discussed briefly.

In Situ Investigation of Charge Performance in Anatase TiO2 Powder for Methane Conversion by Vis-NIR Spectroscopy

The intrinsic behavior of photogenerated charges and reactions with chemicals are key for a photocatalytic process. To observe these basic steps is of great importance. Here we present a reliable and robust system to monitor these basic steps in powder photocatalysts, and more importantly to elucidate the key issue in photocatalytic methane conversion over the benchmark catalyst TiO₂. Under constant excitation, the absorption signal across the NIR region was demonstrated to be dominated by photoexcited electrons, the absorption of photoexcited holes increases toward shorter wavelengths in the visible region, and the overall shapes of the photoinduced absorption spectra obtained using the system demonstrated in the present work are consistent with widely accepted transient absorption results. Next, in situ measurements provide direct experimental evidence that the initial step of methane activation over TiO₂ involves oxidation by photoexcited holes. It is calculated that 90 ± 6% of photoexcited electrons are scavenged by O₂ (in dry air), 61 ± 9% of photoexcited holes are scavenged by methane (10% in argon), and a similar amount of photoexcited electrons can be scavenged by O₂ even when the O₂ concentration is reduced by a factor of 10. The present results suggest that O₂ is much more easily activated in comparison to methane over anatase TiO₂, which rationalizes the much higher methane/O₂ ratio frequently used in practice in comparison to that required stoichiometrically for photocatalytic production of value-added chemicals via methane oxidation with oxygen. In addition, methanol (a preferable product of methane oxidation) is much more readily oxidized than methane over anatase TiO₂.

Nanostructured TiO2 cavitation agents for dual-modal sonophotocatalysis with pulsed ultrasound

Current sonochemical methods rely on spatially uncontrolled cavitation for radical species generation to promote chemical reactions. To improve radical generation, sonosensitizers have been demonstrated to be activated by cavitation-based light emission (sonoluminescence). Unfortunately, this process remains relatively inefficient compared to direct photocatalysis, due to the physical separation between cavitation event and sonosensitizing agent. In this study, we have synthesized nanostructured titanium dioxide particles to couple the source for cavitation within a photocatalytic site to create a sonophotocatalyst. In doing so, we demonstrate that site-controlled cavitation from the nanoparticles using pulsed ultrasound at reduced acoustic powers resulted in the sonochemical degradation methylene blue at rates nearly three orders of magnitude faster than other titanium dioxide-based nanoparticles by conventional methods. Sonochemical degradation was directly proportional to the measured cavitation produced by these sonophotocatalysts. Our work suggests that simple nanostructuring of current sonosensitizers to enable on-site cavitation greatly enhances sonochemical reaction rates.