Development of 100 Mo -containing scintillating bolometers for a high-sensitivity neutrinoless double-beta decay search

This paper reports on the development of a technology involving 100 Mo -enriched scintillating bolometers, compatible with the goals of CUPID, a proposed next-generation bolometric experiment to search for neutrinoless double-beta decay. Large mass ( ∼ 1 kg ), high optical quality, radiopure 100 Mo -containing zinc and lithium molybdate crystals have been produced and used to develop high performance single detector modules based on 0.2-0.4 kg scintillating bolometers. In particular, the energy resolution of the lithium molybdate detectors near the Q-value of the double-beta transition of 100 Mo (3034 keV) is 4-6 keV FWHM. The rejection of the α -induced dominant background above 2.6 MeV is better than 8 σ . Less than 10 μ Bq/kg activity of 232 Th ( 228 Th ) and 226 Ra in the crystals is ensured by boule recrystallization. The potential of 100 Mo -enriched scintillating bolometers to perform high sensitivity double-beta decay searches has been demonstrated with only 10 kg × d exposure: the two neutrino double-beta decay half-life of 100 Mo has been measured with the up-to-date highest accuracy as T 1 / 2 = [6.90 ± 0.15(stat.) ± 0.37(syst.)] × 10 18 years . Both crystallization and detector technologies favor lithium molybdate, which has been selected for the ongoing construction of the CUPID-0/Mo demonstrator, containing several kg of 100 Mo .

Thermal diagnostics front-end electronics for LISA Pathfinder

Precision temperature measurements are required in the LTP, the LISA technology package, for various diagnostics objectives. In this article, we describe in detail the front-end electronics design and the associated temperature sensors to achieve the LTP requirements: noise equivalent temperature of 10 microK Hz(-12) in the frequency range from 1 to 30 mHz at room temperature. We designed an ac Wheatstone bridge and a subsequent digital demodulation to minimize 1/f noise. We show experimental results where the required sensitivity in the measurement bandwidth is fulfilled.

Use of quantum-point-contact high-electron-mobility-transistors for time domain multiplexing of large arrays of high impedance low temperature bolometers

The use of a multiplexing readout for an array of bolometers simplifies the electronics and wiring, so making the readout of large arrays of bolometers (>100) feasible. Here we describe a time domain multiplexing technique and its performance based on the use of quantum-point-contact high-electron-mobility-transistors as low temperature (to approximately 100 mK) switches for measuring high impedance (5...70 MOmega) resistances and sensors. The presented system is well matched to ground based millimetric astronomy demands.