Impact of selected thermal and flow parameters on flow boiling heat transfer in a minichannel

This paper reports an impact of selected thermal and flow parameters i.e., mass flux and inlet pressure on flow boiling heat transfer in a minichannel. Research was carried out on the experimental set up with the test section fitted with a single, rectangular and vertically oriented minichannel 1.7 mm deep. Infrared thermography was used to determine changes in the temperature on the outer side of the heated minichannel wall in the central part of the minichannel. The heated element for HFE-649 flowing in the minichannel was a thin alloy plate, made of Haynes-230. Local values of heat transfer coefficient for stationary state conditions were calculated using a simple one-dimensional method. Analysis of the results was based on experimental series obtained for the same heat flux, various mass fluxes and average inlet pressures. The experimental results are presented as the relationship between the heat transfer coefficient and the distance along the minichannel length and boiling curves. The highest local heat transfer coefficients were obtained for the lower average inlet pressure and for the highest mass flux at lower heat flux.

Estimating uncertainty of temperature measurements for studies of flow boiling heat transfer in minichannels

This paper presents the method of estimating the uncertainty of temperature measurements conducted using K-type thermocouples in the study of flow boiling heat transfer in minichannels. During heat transfer experiments. the fluid temperature at the inlet and outlet of the minichannel is measured with thermocouples connected to a DaqLab 2005 data acquisition station. The major part of the experimental setup for calibration of temperature measurement included a calibrator of thermocouples. The thermocouples were manufactured by Czaki Thermo-Product. Poland. The temperatures recorded with the thermocouples were compared statistically while measuring the temperature of demineralised water at several characteristic points at liquid phase change or using the reference temperature known from the calibrator. The experimental error of the temperature measurement method was determined according to the principles of statistical analysis. Estimates of the mean value and the experimental standard deviation of the experimental error as well as the confidence interval for a single experimental error and the measurement accuracy were presented. The uncertainty of the difference in temperature was also calculated