Comparison of tissue heat balance- and thermal dissipation-derived sap flow measurements in ring-porous oaks and a pine

Sap flow measurements have become integral in many physiological and ecological investigations. A number of methods are used to estimate sap flow rates in trees, but probably the most popular is the thermal dissipation (TD) method because of its affordability, relatively low power consumption, and ease of use. However, there have been questions about the use of this method in ring-porous species and whether individual species and site calibrations are needed. We made concurrent measurements of sap flow rates using TD sensors and the tissue heat balance (THB) method in two oak species (Quercus prinus Willd. and Quercus velutina Lam.) and one pine (Pinus echinata Mill.). We also made concurrent measurements of sap flow rates using both 1 and 2-cm long TD sensors in both oak species. We found that both the TD and THB systems tended to match well in the pine individual, but sap flow rates were underestimated by 2-cm long TD sensors in five individuals of the two ring-porous oak species. Underestimations of 20-35% occurred in Q. prinus even when a "Clearwater" correction was applied to account for the shallowness of the sapwood depth relative to the sensor length and flow rates were underestimated by up to 50% in Q. velutina. Two centimeter long TD sensors also underestimated flow rates compared with 1-cm long sensors in Q. prinus, but only at large flow rates. When 2-cm long sensor data in Q. prinus were scaled using the regression with 1-cm long data, daily flow rates matched well with the rates measured by the THB system. Daily plot level transpiration estimated using TD sap flow rates and scaled 1 cm sensor data averaged about 15% lower than those estimated by the THB method. Therefore, these results suggest that 1-cm long sensors are appropriate in species with shallow sapwood, however more corrections may be necessary in ring-porous species.

The challenge of making ozone risk assessment for forest trees more mechanistic

Upcoming decades will experience increasing atmospheric CO2 and likely enhanced O3 exposure which represents a risk for the carbon sink strength of forests, so that the need for cause-effect related O3 risk assessment increases. Although assessment will gain in reliability on an O3 uptake basis, risk is co-determined by the effective dose, i.e. the plant's sensitivity per O3 uptake. Recent progress in research on the molecular and metabolic control of the effective O3 dose is reported along with advances in empirically assessing O3 uptake at the whole-tree and stand level. Knowledge on both O3 uptake and effective dose (measures of stress avoidance and tolerance, respectively) needs to be understood mechanistically and linked as a pre-requisite before practical use of process-based O3 risk assessment can be implemented. To this end, perspectives are derived for validating and promoting new O3 flux-based modelling tools.

Promoting the O3 flux concept for European forest trees

Tropospheric ozone (O3) levels are predicted to stay high, being a factor within "global change" with potential effects on the carbon sink strength of forest trees. Hence, new approaches to O3 risk assessment and their validation are required, although appropriate databases for adult trees are scant. Approaches based on external O3 exposure are presently being evaluated against the ones on O3 flux into leaves, as the cumulative uptake has the capacity for deriving O3 risk from cause-effect relationships. The effective dose, however, needs to account for the trees' O3 defence and tolerance in addition to O3 uptake. The current status of promoting the preferable mechanistic O3 flux concept is highlighted for major regions of Europe, addressing refinements and simplifications needed for routine use. At the pan-European scale, however, the flux-based concept is ready for use in O3 risk assessment and has the potential of meso-scale application at the forest ecosystem level.