[Results of operative therapy of idiopathic clubfoot using a dorsomedial approach with soft tissue preparation "à la carte"]

A cementless hip system with a new surface for osseous integration

PURPOSE

The failure of total hip systems caused by wear-particle-induced loosening has focused interest on factors potentially affecting wear rate. Remnants of the blasting material were reported on grit-blasted surfaces for cementless fixation. These particles are believed to cause third-body wear and implant loosening. The purpose of this study was to evaluate the early clinical and radiological outcomes of a cementless hip system with a new, contamination-free, roughened surface with regard to prosthesis-related failures.

METHODS

Between May 2004 and March 2009, 202 consecutive primary total hip arthroplasties (THAs) (192 patients with a mean age of 62.6 years) were performed using a cementless stem (Hipstar®) and a hemispherical acetabular cup (Trident®).

RESULTS

At a minimum follow-up of two years, five revisions (2.5%) due to aseptic loosening of the stem and three (1.5%) of the cup were necessary. The cumulative rate of prostheses survival, counting revision of both components and with aseptic failure as end point, was 92.9% at 8.8 years. Radiolucent lines up to three millimetres were evaluated in the proximal part of the femur in 61% of cases.

CONCLUSIONS

Although the incidence of radiolucent lines was decreased, the revision rate was considerably increased compared to other uncemented hip implants with grit-blasted surfaces in the short- to mid-term follow-up of our study. Subsequent studies are needed to confirm whether these changes in implant material and surface affect the radiological and clinical outcome in the long term.

Ponseti method compared with soft-tissue release for the management of clubfoot: A meta-analysis study

AIM

To compare the functional outcomes of patients who underwent open surgery vs Ponseti method for the management of idiopathic clubfoot and to determine whether correlations exist between functional outcome and radiographic measurements.

METHODS

A meta-analysis of the literature was conducted for studies concerning primary treatment of patients with idiopathic clubfoot. We searched PubMed Medline, EMBASE, and the Cochrane Library databases from January 1950 to October 2011. Meta-analyses were performed on outcomes from 12 studies. Pooled means, SDs, and sample sizes were either identified in the results or calculated based on the results of each study.

RESULTS

Overall, 835 treated idiopathic clubfeet in 516 patients were reviewed. The average follow-up was 15.7 years. Patients managed with Ponseti method did have a higher rate of excellent or good outcome than patients treated with open surgery (0.76 and 0.62, respectively), but not quite to the point of statistical significance (Q = 3.73, P = 0.053). Age at surgery was not correlated with the functional outcome for the surgically treated patients (r = -0.32, P = 0.68). A larger anteroposterior talocalcaneal angle was correlated with a higher rate of excellent or good outcomes (r = 0.80, P = 0.006). There were no other significant correlations between the functional and radiographic outcomes.

CONCLUSION

The Ponseti method should be considered the initial treatment of idiopathic clubfeet, and open surgery should be reserved for clubfeet that cannot be completely corrected.

Comparing alumina-reduced and conventional surface grit-blasted acetabular cups in primary THA: early results from a randomised clinical trial

Alumina grit-blasted implants have been widely used in cementless total hip arthroplasty (THA). However, alumina particles can become embedded in the implant surface, leading to deposition in periprosthetic tissues and implant wear. We hypothesised that the alumina-reduced surface BICON-PLUS NT acetabular cup would improve implant fixation and clinical outcomes over the conventional surface BICON-PLUS cup. In a randomised controlled, double-blind study, patients with primary or secondary osteoarthritis requiring primary arthroplasty were randomly assigned to THA with either the BICON-PLUS or BICON-PLUS NT cup. All cups were combined with the SL-PLUS stem. In addition to clinical and radiographic assessments, dual-energy X-absorptiometry (DEXA) was performed preoperatively and at regular intervals during a planned 2-year follow-up period to measure bone mineral density as a marker of implant fixation. At 1 year, there were no differences in bone mineral density, or in clinical or radiographic outcomes between the BICON-PLUS and BICON-PLUS NT groups were identified, leading to early termination of the study. Both groups showed excellent clinical improvement and there were few complications. Both the alumina-reduced and conventional surface acetabular cups can be used with confidence in primary THA for osteoarthritis, although longer-term studies are required to confirm these findings.