An alternative method to determining optical lever sensitivity in atomic force microscopy without tip-sample contact

Improved Application of Carbon Nanotube Atomic Force Microscopy Probes Using PeakForce Tapping Mode

In this work PeakForce tapping (PFT) imaging was demonstrated with carbon nanotube atomic force microscopy (CNT-AFM) probes; this imaging mode shows great promise for providing simple, stable imaging with CNT-AFM probes, which can be difficult to apply. The PFT mode is used with CNT-AFM probes to demonstrate high resolution imaging on samples with features in the nanometre range, including a Nioprobe calibration sample and gold nanoparticles on silicon, in order to demonstrate the modes imaging effectiveness, and to also aid in determining the diameter of very thin CNT-AFM probes. In addition to stable operation, the PFT mode is shown to eliminate “ringing” artefacts that often affect CNT-AFM probes in tapping mode near steep vertical step edges. This will allow for the characterization of high aspect ratio structures using CNT-AFM probes, an exercise which has previously been challenging with the standard tapping mode.

Establishing proper scanning conditions in atomic force microscopy on polyimide and polyurethane samples and their effect on 3D surface texture parameters

Several atomic force microscopy (AFM) tests have been carried out on both smooth (polyimide) and rough (polyurethane) surfaces so that to obtain the best results; subsequently, the optimization of experiments performed is presented. A special emphasis has been put on the effect of tip geometry, image pre-processing procedure, scanning area, resolution, pixel size, and cantilever oscillation amplitude in tapping mode, as well as on the quality of the topographical images and 3D surface texture parameters. After viewing the scanning tip and finding out its sharpness, degradation, and contamination, a simultaneous calibration in X, Y, and Z directions, lateral calibration of SPM scanners and detection of lateral non-linearity, hysteresis, creep, and cross-coupling effects has been made. We have established the following experimental parameters: proper scanning resolution (512 × 512 pixels), adequate pixel size (between 2.9 and 19.5 nm) and suitable intermittent contact region (moderate tapping) for which the AFM images present good contrast and resolution. Using these parameters, the values of 3D texture parameters remain constant. These kinds of measurements are extremely important to conduct further AFM experiments on polyimide and polyurethane surfaces under optimal conditions, thus avoiding unwanted artifacts on the morphological images or unrealistic values for the 3D surface texture parameters that might occur.

Quantitative characterization of adhesion and stiffness of corneal lens of Drosophila melanogaster using atomic force microscopy

Atomic force Microscopy (AFM) has become a versatile tool in biology due to its advantage of high-resolution imaging of biological samples close to their native condition. Apart from imaging, AFM can also measure the local mechanical properties of the surfaces. In this study, we explore the possibility of using AFM to quantify the rough eye phenotype of Drosophila melanogaster through mechanical properties. We have measured adhesion force, stiffness and elastic modulus of the corneal lens using AFM. Various parameters affecting these measurements like cantilever stiffness and tip geometry are systematically studied and the measurement procedures are standardized. Results show that the mean adhesion force of the ommatidial surface varies from 36 nN to 16 nN based on the location. The mean stiffness is 483 ± 5 N/m, and the elastic modulus is 3.4 ± 0.05 GPa (95% confidence level) at the center of ommatidia. These properties are found to be different in corneal lens of eye expressing human mutant tau gene (mutant). The adhesion force, stiffness and elastic modulus are decreased in the mutant. We conclude that the measurement of surface and mechanical properties of D. melanogaster using AFM can be used for quantitative evaluation of 'rough eye' surface.