The products of the thermal decomposition of CH3CHO

Experimental and Theoretical Study of Oxolan-3-one Thermal Decomposition

The thermal decomposition of oxolan-3-one, a common component of the bio-oil formed during biomass pyrolysis, has been studied using ab initio calculations and experiments employing pulsed gas-phase pyrolysis with matrix-isolation FTIR product detection. Four pathways for unimolecular decomposition were predicted using computational methods. The dominant reaction channel led to carbon monoxide, formaldehyde, and ethylene, all of which were observed experimentally. The other channels led to an assortment of products including ketene, water, propyne, and acetylene, which were all confirmed in the matrix-isolation FTIR spectra. There is also evidence for the production of substituted ketenes in pyrolysis, most likely hydroxyketene and methylketene.

An Experimental and Theoretical Investigation of 1-Butanol Pyrolysis

Bioalcohols are a promising family of biofuels. Among them, 1-butanol has a strong potential as a substitute for petrol. In this manuscript, we report on a theoretical and experimental characterization of 1-butanol thermal decomposition, a very important process in the 1-butanol combustion at high temperatures. Advantage has been taken of a flash pyrolysis experimental set-up with mass spectrometric detection, in which the brief residence time of the pyrolyzing mixture inside a short, resistively heated SiC tube allows the identification of the primary products of the decomposing species, limiting secondary processes. Dedicated electronic structure calculations of the relevant potential energy surface have also been performed and RRKM estimates of the rate coefficients and product branching ratios up to 2,000 K are provided. Both electronic structure and RRKM calculations are in line with previous determinations. According to the present study, the H₂O elimination channel leading to 1-butene is more important than previously believed. In addition to that, we provide experimental evidence that butanal formation by H₂ elimination is not a primary decomposition route. Finally, we have experimental evidence of a small yield of the CH₃ elimination channel.

Quasiclassical trajectory calculations of CD3CHO dissociation to CD2H + DCO on a global potential energy surface

We present a quasiclassical trajectory study of the photodissociation of CD3CHO based on a global ab initio-based potential energy surface. Calculations are performed at the total energy corresponding to the photolysis wavelength of 280[Formula: see text]nm. In addition to the major radical and molecular products, CD[Formula: see text] and CD3H [Formula: see text] CO, respectively, this paper focuses on the unusual radical channel CD2H [Formula: see text] DCO, which requires a D/H exchange process before the conventional C–C bond cleavage. Five D/H exchange mechanisms are reported, which are related to the isomerizations from acetaldehyde to vinyl alcohol and back, to oxirane and back, and to the intermediate (CD–CHD–OD) and back. These D/H exchange mechanisms are in good agreement with the experimental findings [Heazlewood BR, Maccarone AT, Andrews DU, Osborn DL, Harding LB, Klippenstein SJ, Jordan MJT, Kable SH, Nat Chem 3:443, 2011].

Theoretical Studies on the Kinetics of Multi-Channel Gas-Phase Unimolecular Decomposition of Acetaldehyde

Theoretical kinetic studies are performed on the multichannel thermal decomposition of acetaldehyde. The geometries of the stationary points on the potential energy surface of the reaction are optimized at the MP2(full)/6-311++G(2d,2p) level of theory. More accurate energies are obtained by single point energy calculations at the CCSD(T,full)/augh-cc-pVTZ+2df, CBS-Q and G4 levels of theory. Here, by application of steady-state approximation to the thermally activated species CH₃CHO* and CH₂CHOH* and performance of statistical mechanical manipulations, expressions for the rate constants for different product channels are derived. Special attempts are made to compute accurate energy-specific rate coefficients for different channels by using semiclassical transition state theory. It is found that the isomerization of CH₃CHO to the enol-form CH₂CHOH plays a significant role in the unimolecular reaction of CH₃CHO. The possible products of the reaction are formed via unimolecular decomposition of CH₃CHO and CH₂CHOH. The computed rate coefficients reveal that the dominant channel at low temperatures and high pressures is the formation of CH₂CHOH due to the low barrier height for CH₃CHO → CH₂CHOH isomerization process. However, at high temperatures, the product channel CH₃ + CHO becomes dominant.

Thermal Decomposition Mechanism for Ethanethiol

The thermal decomposition of ethanethiol was studied using a 1 mm × 2 cm pulsed silicon carbide microtubular reactor, CH₃CH₂SH + Δ → Products. Unlike previous studies these experiments were able to identify the initial ethanethiol decomposition products. Ethanethiol was entrained in either an Ar or a He carrier gas, passed through a heated (300-1700 K) SiC microtubular reactor (roughly ≤100 μs residence time) and exited into a vacuum chamber. Within one reactor diameter the gas cools to less than 50 K rotationally, and all reactions cease. The resultant molecular beam was probed by photoionization mass spectroscopy and IR spectroscopy. Ethanethiol was found to undergo unimolecular decomposition by three pathways: CH₃CH₂SH → (1) CH₃CH₂ + SH, (2) CH₃ + H₂C═S, and (3) H₂C═CH₂ + H₂S. The experimental findings are in good agreement with electronic structure calculations.

Thermal Decomposition of Potential Ester Biofuels. Part I: Methyl Acetate and Methyl Butanoate

Two methyl esters were examined as models for the pyrolysis of biofuels. Dilute samples (0.06-0.13%) of methyl acetate (CH₃COOCH₃) and methyl butanoate (CH₃CH₂CH₂COOCH₃) were entrained in (He, Ar) carrier gas and decomposed in a set of flash-pyrolysis microreactors. The pyrolysis products resulting from the methyl esters were detected and identified by vacuum ultraviolet photoionization mass spectrometry. Complementary product identification was provided by matrix infrared absorption spectroscopy. Pyrolysis pressures in the pulsed microreactor were about 20 Torr and residence times through the reactors were roughly 25-150 μs. Reactor temperatures of 300-1600 K were explored. Decomposition of CH₃COOCH₃ commences at 1000 K, and the initial products are (CH₂═C═O and CH₃OH). As the microreactor is heated to 1300 K, a mixture of CH₂═C═O and CH₃OH, CH₃, CH₂═O, H, CO, and CO₂ appears. The thermal cracking of CH₃CH₂CH₂COOCH₃ begins at 800 K with the formation of CH₃CH₂CH═C═O and CH₃OH. By 1300 K, the pyrolysis of methyl butanoate yields a complex mixture of CH₃CH₂CH═C═O, CH₃OH, CH₃, CH₂═O, CO, CO₂, CH₃CH═CH₂, CH₂CHCH₂, CH₂═C═CH₂, HCCCH₂, CH₂═C═C═O, CH₂═CH₂, HC≡CH, and CH₂═C═O. On the basis of the results from the thermal cracking of methyl acetate and methyl butanoate, we predict several important decomposition channels for the pyrolysis of fatty acid methyl esters, R-CH₂-COOCH₃. The lowest-energy fragmentation will be a 4-center elimination of methanol to form the ketene RCH═C═O. At higher temperatures, concerted fragmentation to radicals will ensue to produce a mixture of species: (RCH₂ + CO₂ + CH₃) and (RCH₂ + CO + CH₂═O + H). Thermal cracking of the β C-C bond of the methyl ester will generate the radicals (R and H) as well as CH₂═C═O + CH₂═O. The thermochemistry of methyl acetate and its fragmentation products were obtained via the Active Thermochemical Tables (ATcT) approach, resulting in Δ_fH₂₉₈(CH₃COOCH₃) = -98.7 ± 0.2 kcal mol^-1, Δ_fH₂₉₈(CH₃CO₂) = -45.7 ± 0.3 kcal mol^-1, and Δ_fH₂₉₈(COOCH₃) = -38.3 ± 0.4 kcal mol^-1.

Pyrolysis Reactions of 3-Oxetanone

The pyrolysis products of gas-phase 3-oxetanone were identified via matrix-isolation Fourier transform infrared spectroscopy and photoionization mass spectrometry. Pyrolysis was conducted in a hyperthermal nozzle at temperatures from 100 to 1200 °C with the dissociation onset observed at ∼600 °C. The ring strain in the cyclic structure of 3-oxetanone causes the molecule to decompose at relatively low temperatures. Previously, only one dissociation channel, producing formaldehyde and ketene, was considered as significant in photolysis. This study presents the first experimental measurements of the thermal decomposition of 3-oxetanone demonstrating an additional dissociation channel that forms ethylene oxide and carbon monoxide. Major products include formaldehyde, ketene, carbon monoxide, ethylene oxide, ethylene, and methyl radical. The first four products stem from initial decomposition of 3-oxetanone, while the additional products, ethylene and methyl radical, are believed to be due to further reactions involving ethylene oxide.

Products from pyrolysis of gas-phase propionaldehyde

A hyperthermal nozzle was utilized to study the thermal decomposition of propionaldehyde, CH3CH2CHO, over a temperature range of 1073-1600 K. Products were identified with two detection methods: matrix-isolation Fourier transform infrared spectroscopy and photoionization mass spectrometry. Evidence was observed for four reactions during the breakdown of propionaldehyde: α-C-C bond scission yielding CH3CH2, CO, and H, an elimination reaction forming methylketene and H2, an isomerization pathway leading to propyne via the elimination of H2O, and a β-C-C bond scission channel forming methyl radical and (•)CH2CHO. The products identified during this experiment were CO, HCO, CH3CH2, CH3CH═C═O, H2O, CH3C≡CH, CH3, H2C═C═O, CH2CH2, CH3CH═CH2, HC≡CH, CH2CCH, H2CO, C4H2, C4H4, and CH3CHO. The first eight products result from primary or bimolecular reactions involving propionaldehyde while the remaining products occur from reactions including the initial pyrolysis products. While the pyrolysis of propionaldehyde involves reactions similar to those observed for acetaldehyde and butyraldehyde in recent studies, there are a few unique products observed which highlight the need for further study of the pyrolysis mechanism.

Imaging the molecular channel in acetaldehyde photodissociation: roaming and transition state mechanisms

The roaming dynamics in the photodissociation of acetaldehyde is studied through the first absorption band, in the wavelength interval ranging from 230 nm to 325 nm. Using a combination of the velocity-map imaging technique and rotational resonance enhanced multiphoton ionization (REMPI) spectroscopy of the CO fragment, the branching ratio between the canonical transition state and roaming dissociation mechanisms is obtained at each of the photolysis wavelengths studied. Upon one photon absorption, the molecule is excited to the first singlet excited S(1) state, which, depending on the excitation wavelength, either converts back to highly vibrationally excited ground S(0) state or undergoes intersystem crossing to the first excited triplet T(1) state, from where the molecule can dissociate over two main channels: the radical (CH(3) + HCO) and the molecular (CO + CH(4)) channels. Three dynamical regions are characterized: in the red edge of the absorption band, at excitation energies below the T(1) barrier, the ratio of the roaming dissociation channel increases, largely surpassing the transition state contribution. As the excitation wavelength is increased, the roaming propensity decreases reaching a minimum at wavelengths ∼308 nm. Towards the blue edge, at 230 nm, an upper limit of ∼50% has been estimated for the contribution of the roaming channel. The experimental results are interpreted in terms of the interaction between the different potential energy surfaces involved by means of ab initio stationary points and intrinsic reaction coordinate paths calculations.