Note: fast neutron efficiency in CR-39 nuclear track detectors

Linac natW target close-in geometry photoneutron study by nuclear track distribution function

During electron beam stopping on ^natW target in a linear accelerator, photonuclear (γ, xn) reactions occur; the tungsten converter provides a non-negligible neutron yield with an energy spectrum that significantly depends on surrounding mass nuclei. Reduction of the neutron radiation field is convenient to limit the side-effects that accompany the tumor or cancer radiotherapy. A close-in irradiation geometry is proposed to improve therapy effectiveness. The convenience of the proposed experimental arrangement is assessed using Monte Carlo simulation and experimental results based on nuclear track-etch methodology. Photoneutron yield for two energy groups (thermal and epithermal) are determined experimentally via boron (98%) converter and cadmium-filter employing a passive detector (poly allyl di-glicol carbonate polimer). Etched track diameter histograms are described by distribution functions to determine the ratio between thermal and higher energy neutrons. New insights are given into therapy beam quality and radiotherapy dose delivery based on bar histograms unfolding.

New target with low photoneutron yield for LINAC radiotherapy applications

This paper presents three new materials composed of Ti_XV_0,035XCu_X-1,035 (X = 2, 4 and 6%), is proposed as Linear Accelerator target. Its response to electron beam based on photoneutron production, is assessed by MC simulation and nuclear track-etch methodology. The outcome is compared to a tungsten target irradiated by energetic 16 MeV electron beam. Photoneutron yield, of two energy groups (thermal and epithermal) were determined via converter matter ¹⁰B (98%) and Cd-filter by PADC-track density comparison. The multi-metal Ti₂V_0,07Cu_97.93 target related to therapy beam quality, resulted advantageous in comparison to that provided by W-target, commonly used in the LINAC.

Plasma-laser ion discrimination by TOF technique applied to coupled SiC detectors

The rate estimation of nuclear reactions induced in high intensity laser-target interaction (≥1016 W/cm2), is strongly depending on the neutron detection efficiency and ion charge discrimination, according to particles involved in exit open-channels. Ion discrimination is basically performed by means of analysis of pits observed on track detector, which is critically dependent on calibration and/or fast TOF devices based on SiC and diamond detectors. Last setup is used to determine the ion energy and to obtain a rough estimation of yields. However, for each TOF interval, the dependence of yield from the energy deposited in the detector sensitive region, introduces a distortion in the ion spectra. Moreover, if two ion species are present in the same spectrum, the discrimination of their contribution is not attainable. In this paper a new method is described which allows to discriminate the contribution of two ion species in the wide energy range of nuclear reactions induced in laser-target interactions. The method is based on charge response of two TOF-SiC detectors, of suitable thicknesses, placed in adjacent positions. In presence of two ion species, the response of the detectors, associated with different energy losses, can determine the ion specific contribution to each TOF interval.