Pressure cell for transport measurements under high pressure and low temperature in pulsed magnetic fields

Piston-cylinder cell made of Ni-Cr-Al alloy for magnetic susceptibility measurements under high pressures in pulsed high magnetic fields

We developed a metallic pressure cell made of 56Ni-40Cr-4Al (Ni-Cr-Al) alloy for use with a non-destructive pulse magnet and a magnetic susceptibility measurement apparatus with a proximity detector oscillator (PDO) in pulsed magnetic fields of up to 51 T under pressures of up to 2.1 GPa. Both the sample and sensor coil of the PDO were placed in the cell so that the magnetic signal from Ni-Cr-Al would not overlay the intrinsic magnetic susceptibility of the sample. A systematic investigation of the Joule heating originating from metallic parts of the pressure cell revealed that the increase in sample temperature is negligible at 1.4 K in magnetic fields of up to 40 T in the field-ascending process for the maximum applied magnetic field of 51 T. The effectiveness of our apparatus was demonstrated by investigating the pressure dependence of the magnetization process of the triangular-lattice antiferromagnet Ba3CoSb2O9.

Composite pressure cell for pulsed magnets

Extreme pressures and high magnetic fields can affect materials in profound and fascinating ways. However, large pressures and fields are often mutually incompatible; the rapidly changing fields provided by pulsed magnets induce eddy currents in the metallic components used in conventional pressure cells, causing serious heating, forces, and vibration. Here, we report a diamond-anvil-cell made mainly out of insulating composites that minimizes inductive heating while retaining sufficient strength to apply pressures of up to 8 GPa. Any residual metallic component is made of low-conductivity metals and patterned to reduce eddy currents. The simple design enables rapid sample or pressure changes, desired by pulsed-magnetic-field-facility users. The pressure cell has been used in pulsed magnetic fields of up to 65 T with no noticeable heating at cryogenic temperatures. Several measurement techniques are possible inside the cell at temperatures as low as 500 mK.

Non-monotonic pressure dependence of high-field nematicity and magnetism in CeRhIn5

CeRhIn₅ provides a textbook example of quantum criticality in a heavy fermion system: Pressure suppresses local-moment antiferromagnetic (AFM) order and induces superconductivity in a dome around the associated quantum critical point (QCP) near p_c ≈ 23 kbar. Strong magnetic fields also suppress the AFM order at a field-induced QCP at B_c ≈ 50 T. In its vicinity, a nematic phase at B^* ≈ 28 T characterized by a large in-plane resistivity anisotropy emerges. Here, we directly investigate the interrelation between these phenomena via magnetoresistivity measurements under high pressure. As pressure increases, the nematic transition shifts to higher fields, until it vanishes just below p_c. While pressure suppresses magnetic order in zero field as p_c is approached, we find magnetism to strengthen under strong magnetic fields due to suppression of the Kondo effect. We reveal a strongly non-mean-field-like phase diagram, much richer than the common local-moment description of CeRhIn₅ would suggest.

Multiple quantum critical behaviors exist in the heavy fermion material CeRhIn5, but their interrelation is less studied. Here, Helm et al. investigate the interrelation of two quantum critical points and other relevant orders, revealing a strongly non-mean-field-like phase diagram.