Reducing current noise in cryogenic experiments by vacuum-insulated cables

Development of a near-5-Kelvin, cryogen-free, pulse-tube refrigerator-based scanning probe microscope

We report the design and performance of a cryogen-free, pulse-tube refrigerator (PTR)-based scanning probe microscopy (SPM) system capable of operating at a base temperature of near 5 K. We achieve this by combining a home-made interface design between the PTR cold head and the SPM head, with an automatic gas-handling system. The interface design isolates the PTR vibrations by a combination of polytetrafluoroethylene and stainless-steel bellows and by placing the SPM head on a passive vibration isolation table via two cold stages that are connected to thermal radiation shields using copper heat links. The gas-handling system regulates the helium heat-exchange gas pressures, facilitating both the cooldown to and maintenance of the base temperature. We discuss the effects of each component using measured vibration, current-noise, temperature, and pressure data. We demonstrate that our SPM system performance is comparable to known liquid-helium-based systems with the measurements of the superconducting gap spectrum of Pb, atomic-resolution scanning tunneling microscopy image and quasiparticle interference pattern of Au(111) surface, and non-contact atomic force microscopy image of NaCl(100) surface. Without the need for cryogen refills, the present SPM system enables uninterrupted low-temperature measurements.

Measurement of sub-picoampere direct currents with uncertainties below ten attoamperes

A new type of the ultrastable low-noise current amplifier (ULCA) is presented. It involves thick-film resistors to achieve a high feedback resistance of 185 GΩ at the input amplifier. An improved noise level of 0.4 fA/Hz with a 1/f corner of about 30 μHz and an effective input bias current well below 100 aA are demonstrated. For small direct currents, measurement uncertainties below 10 aA are achievable even without current reversal or on/off switching. Above about 1 pA, the stability of the ULCA's resistor network limits the relative measurement uncertainty to about 10 parts per million. The new setup is used to characterize and optimize the noise in the wiring installed on a dilution refrigerator for current measurements on single-electron transport pumps. In a test configuration connected to the wiring in a pulse tube refrigerator, a total noise floor of 0.44 fA/Hz was achieved including the contributions of amplifier and cryogenic wiring.

Vibration-induced electrical noise in a cryogen-free dilution refrigerator: Characterization, mitigation, and impact on qubit coherence

Cryogen-free low-temperature setups are becoming more prominent in experimental science due to their convenience and reliability, and concern about the increasing scarcity of helium as a natural resource. Despite not having any moving parts at the cold end, pulse tube cryocoolers introduce vibrations that can be detrimental to the experiments. We characterize the coupling of these vibrations to the electrical signal observed on cables installed in a cryogen-free dilution refrigerator. The dominant electrical noise is in the 5-10 kHz range and its magnitude is found to be strongly temperature dependent. We test the performance of different cables designed to diagnose and tackle the noise, and find triboelectrics to be the dominant mechanism coupling the vibrations to the electrical signal. Flattening a semi-rigid cable or jacketing a flexible cable in order to restrict movement within the cable, successfully reduces the noise level by over an order of magnitude. Furthermore, we characterize the effect of the pulse tube vibrations on an electron spin qubit device in this setup. Coherence measurements are used to map out the spectrum of the noise experienced by the qubit, revealing spectral components matching the spectral signature of the pulse tube.