Photon counting with photon number resolution through superconducting nanowires coupled to a multi-channel TDC in FPGA

Digital Integration of LiDAR System Implemented in a Low-Cost FPGA

With the development of artificial intelligence, LiDAR finds significant applications in robotics and autonomous driving. Aiming at increasing the compactness and the integration of 2-D LiDAR, this paper presents a highly digitally integrated 2-D LiDAR system implemented in a low-cost FPGA. The system is made of off-the-shelf components to limit the cost to USD 100. A laser transceiver with a symmetrical transmitting and receiving lens emits and collects laser pulses to range distance using the time-of-flight (ToF) method. As a key component in ToF, the FPGA-based time-to-digital converter (TDC) is adopted for counting the round-trip time of pulses, which is implemented in a low-cost FPGA of ZYNQ7010 with limited resources. The symmetrical structure of the delay line is used to design a more efficient TDC. The FPGA-TDC enables flexibility of design and integration with more functional logics and is microcontroller-free. All the digital logics including data processing and controlling are integrated into an FPGA with the TDC logics to realize fully digital integration and compact dimensions. The utilization of the whole architecture in the FPGA is about 15%. The experimental results demonstrated that the ranging accuracy of the LiDAR is about 2 cm, which is suitable for consumer electronics.

Synchronized time tagger for single-photon detection in one- and two-dimension quantum experiments

We report a synchronized time tagger based on a field-programmable-gate-array chip for one- or two-dimensional quantum experiments that require precise single-photon detections. The time tagger has a 9.2 ps single-shot root-mean-square precision and is equipped with a 1 GB dynamic memory for data storage. Because the relationship between the control parameter and acquired data is guaranteed by using hardware synchronization, the experiment can be performed much faster than conventional schemes that are based on software synchronization. With this technique, an improvement of up to 61.3% in efficiency is observed in a typical nitrogen-vacancy center quantum experiment. We further show advanced optical features of the center using the detected high-resolution photon-arrival information and provide detailed electrical benchmarking of the device. This technique could be easily extended to other quantum control systems.

Fine-time measurement circuit based on 180° phase-shifted clock sampling in time-to-digital converters

Dead time is an important parameter in time-to-digital converters, which is the significant time measure circuit. To reduce the dead time, this note proposes a new fine-time measurement circuit. In this configuration, two clocks having a phase difference of 180° are used to sample the signals passing through the delay chain, and their average is taken as the final measurement result. The experimental results demonstrate that the dead time of the proposed circuit is observed to be 1.25 ns at 800 MHz clock and the circuit logic resource consumption of the proposed circuit is reduced by approximately 25% compared to other methods.

Digital instrument with configurable hardware and firmware for multi-channel time measures

A new digital instrument for timing of events is presented. It is based on a reconfigurable, high-performance, 16-channel time-to-digital converter implemented in a Xilinx 7 Series 28-nm field programmable gate array device. Each channel provides timestamps with a least significant bit of 2 ps that states the resolution, whereas instead the single-shot precision is below 12.5 ps rms with the possibility of multihit measures at the maximum rate of 20 MHz. The default width of the full-scale range is 157 µs that can be extended at users choosing up to 15 days by means of proper time tagging procedures made available. The instrument achieves performance in terms of precision, resolution, and full-scale range of measurement at the state-of-art of existing solutions. The novelty is that besides performance, the presented instrument is totally reconfigurable by the user both in the hardware and in the firmware parts. Moreover, novel techniques of event acquisition (e.g., level-zero trigger) are introduced. These further features are not present in any other instrument available nor in the literature or in commerce and constitute a difference with respect to all referenced instruments.

FPGA based demodulation of laser induced fluorescence in plasmas

We present a field programmable gate array (FPGA)-based system that counts photons from laser-induced fluorescence (LIF) on a laboratory plasma. This is accomplished with FPGA-based up/down counters that demodulate the data, giving a background-subtracted LIF signal stream that is updated with a new point as each laser amplitude modulation cycle completes. We demonstrate using the FPGA to modulate a laser at 1 MHz and demodulate the resulting LIF data stream. This data stream is used to calculate an LIF-based measurement sampled at 1 MHz of a plasma ion fluctuation spectrum.