An in situ microtomography apparatus with a laboratory x-ray source for elevated temperatures of up to 1000 °C

Influence of Manufacturing Defects on Mechanical Behavior of the Laser Powder Bed Fused Invar 36 Alloy: In-Situ X-ray Computed Tomography Studies

The mechanical properties of laser powder bed fused (LPBFed) Invar 36 alloy have been limited by the presence of manufacturing defects. It is imperative to investigate the influence of these defects on the mechanical behavior of LPBFed Invar 36 alloy. In this study, in-situ X-ray computed tomography (XCT) tests were conducted on LPBFed Invar 36 alloy fabricated at different scanning speeds to examine the relationship between manufacturing defects and mechanical behavior. For LPBFed Invar 36 alloy fabricated at a scanning speed of 400 mm/s, the manufacturing defects were randomly distributed and tended to be elliptical in shape. Plastic deformation behavior was observed, and failure initiated from defects inside the material resulting in ductile failure. Conversely, for LPBFed Invar 36 alloy fabricated at a scanning speed of 1000 mm/s, numerous lamellar defects were observed mainly located between deposition layers, and their quantity was significantly increased. Little plastic deformation behavior was observed, and failure initiated from defects on the shallow surface of the material resulting in brittle failure. The differences in manufacturing defects and mechanical behavior are attributed to changes in input energy during the laser powder bed fusion process.

Environmental control for X-ray nanotomography

The acquisition speed and spatial resolution of X-ray nanotomography have continuously improved over the last decades. Coherent diffraction-based techniques breach the 10 nm resolution barrier frequently and thus pose stringent demands on sample positioning accuracy and stability. At the same time there is an increasing desire to accommodate in situ or operando measurements. Here, an environmental control system for X-ray nanotomography is introduced to regulate the temperature of a sample from room temperature up to 850°C in a controlled atmospheric composition. The system allows for a 360° sample rotation, permitting tomographic studies in situ or operando free of missing wedge constraints. The system is implemented and available at the flOMNI microscope at the Swiss Light Source. In addition to the environmental control system itself, the related modifications of flOMNI are described. Tomographic measurements of a nanoporous gold sample at 50°C and 600°C at a resolution of sub-20 nm demonstrate the performance of the device.

Investigation on Flaw Evolution of Additively Manufactured Al2O3 Ceramic by In Situ X-ray Computed Tomography

The additive manufacturing process may create flaws inside ceramic materials. The flaws have a significant influence on the macroscopic mechanical behavior of ceramic materials. In order to reveal the influence of flaws on the mechanical behavior of additively manufactured ceramic, flaw evolution under mechanical loads was studied by in situ X-ray computed tomography (XCT) in this work. In situ compression XCT tests were conducted on stereolithographic additively manufactured Al2O3 ceramic. The three-dimensional full-field morphologies at different compressive loads were obtained. The evolution of flaws, including pores, transverse cracks, and vertical cracks, during compressive loading was observed. The number and volume of pores, transverse cracks, and vertical cracks were extracted. It was found that most pores and transverse cracks tend to be compacted. However, high compressive loads cause vertical cracks near the upper surface to expand, leading to the failure of the specimen. Real flaws with morphological and positional information were introduced into the finite element models. The influence of different types of flaws on the mechanical behavior is discussed. It was found that vertical cracks have a greater influence on mechanical behavior than do transverse cracks under compression. The presence of transverse cracks contributes to the evolution of vertical cracks. This study may be helpful for process optimization and performance enhancement of additively manufactured ceramic materials.