Direct measurements of intramolecular electron transfer rates between cytochrome c and cytochrome c peroxidase: effects of exothermicity and primary sequence on rate

Contributions to cytochrome c inner- and outer-sphere reorganization energy

Cytochromes c are small water-soluble proteins that catalyze electron transfer in metabolism and energy conversion processes. Hydrogenobacter thermophilus cytochrome c₅₅₂ presents a curious case in displaying fluxionality of its heme axial methionine ligand; this behavior is altered by single point mutation of the Q64 residue to N64 or V64, which fixes the ligand in a single configuration. The reorganization energy (λ) of these cytochrome c₅₅₂ variants is experimentally determined using a combination of rotating disc electrochemistry, chronoamperometry and cyclic voltammetry. The differences between the λ determined from these complementary techniques helps to deconvolute the contribution of the active site and its immediate environment to the overall λ (λ_Total). The experimentally determined λ values in conjunction with DFT calculations indicate that the differences in λ among the protein variants are mainly due to the differences in contributions from the protein environment and not just inner-sphere λ. DFT calculations indicate that the position of residue 64, responsible for the orientation of the axial methionine, determines the geometric relaxation of the redox active molecular orbital (RAMO). The orientation of the RAMO with respect to the heme is key to determining electron transfer coupling (H_AB) which results in higher ET rates in the wild-type protein relative to the Q64V mutant despite a 150 mV higher λ_Total in the former.

Efficient delocalization of the redox-active molecular orbital (RAMO) in HtWT results in an increase in H_AB value which in turn accelerates the electron transfer (ET) rate in spite of the higher reorganization energy (λ) than the HtQ64V mutant.

A Binuclear CuA Center Designed in an All α-Helical Protein Scaffold

The primary and secondary coordination spheres of metal binding sites in metalloproteins have been investigated extensively, leading to the creation of high-performing functional metalloproteins; however, the impact of the overall structure of the protein scaffold on the unique properties of metalloproteins has rarely been studied. A primary example is the binuclear Cu_A center, an electron transfer cupredoxin domain of photosynthetic and respiratory complexes and, recently, a protein coregulated with particulate methane and ammonia monooxygenases. The redox potential, Cu-Cu spectroscopic features, and a valence delocalized state of Cu_A are difficult to reproduce in synthetic models, and every artificial protein Cu_A center to-date has used a modified cupredoxin. Here, we present a fully functional Cu_A center designed in a structurally nonhomologous protein, cytochrome c peroxidase (CcP), by only two mutations (Cu_ACcP). We demonstrate with UV-visible absorption, resonance Raman, and magnetic circular dichroism spectroscopy that Cu_ACcP is valence delocalized. Continuous wave and pulsed (HYSCORE) X-band EPR show it has a highly compact g_z area and small A_z hyperfine principal value with g and A tensors that resemble axially perturbed Cu_A. Stopped-flow kinetics found that Cu_A formation proceeds through a single T2Cu intermediate. The reduction potential of Cu_ACcP is comparable to native Cu_A and can transfer electrons to a physiological redox partner. We built a structural model of the designed Cu binding site from extended X-ray absorption fine structure spectroscopy and validated it by mutation of coordinating Cys and His residues, revealing that a triad of residues (R48C, W51C, and His52) rigidly arranged on one α-helix is responsible for chelating the first Cu(II) and that His175 stabilizes the binuclear complex by rearrangement of the CcP heme-coordinating helix. This design is a demonstration that a highly conserved protein fold is not uniquely necessary to induce certain characteristic physical and chemical properties in a metal redox center.

Tuning Radical Relay Residues by Proton Management Rescues Protein Electron Hopping

Transient tyrosine and tryptophan radicals play key roles in the electron transfer (ET) reactions of photosystem (PS) II, ribonucleotide reductase (RNR), photolyase, and many other proteins. However, Tyr and Trp are not functionally interchangeable, and the factors controlling their reactivity are often unclear. Cytochrome c peroxidase (CcP) employs a Trp191^•+ radical to oxidize reduced cytochrome c (Cc). Although a Tyr191 replacement also forms a stable radical, it does not support rapid ET from Cc. Here we probe the redox properties of CcP Y191 by non-natural amino acid substitution, altering the ET driving force and manipulating the protic environment of Y191. Higher potential fluorotyrosine residues increase ET rates marginally, but only addition of a hydrogen bond donor to Tyr191^• (via Leu232His or Glu) substantially alters activity by increasing the ET rate by nearly 30-fold. ESR and ESEEM spectroscopies, crystallography, and pH-dependent ET kinetics provide strong evidence for hydrogen bond formation to Y191^• by His232/Glu232. Rate measurements and rapid freeze quench ESR spectroscopy further reveal differences in radical propagation and Cc oxidation that support an increased Y191^• formal potential of ∼200 mV in the presence of E232. Hence, Y191 inactivity results from a potential drop owing to Y191^•+ deprotonation. Incorporation of a well-positioned base to accept and donate back a hydrogen bond upshifts the Tyr^• potential into a range where it can effectively oxidize Cc. These findings have implications for the Y_Z/Y_D radicals of PS II, hole-hopping in RNR and cryptochrome, and engineering proteins for long-range ET reactions.

Designed multi-stranded heme binding β-sheet peptides in membrane

Designed peptides demonstrating well-defined structures and functioning in membrane environment are of significant interest in developing novel proteins for membrane active biological processes including enzymes, electron transfer, ion channels and energy conversion. Heme proteins' ability to carry out multiple functions in nature has inspired the design of several helical heme binding peptides and proteins soluble in water and also recently in membrane. Naturally occurring β-sheet proteins are both water and membrane soluble, and are known to bind heme, however, designed heme binding β-sheet proteins are yet to be reported, plausibly because of the complex folding and difficulty in introducing heme binding sites in the β-sheet structures. Here, we describe the design, NMR structures and biochemical functional characterization of four stranded and six stranded membrane soluble β-sheet peptides that bind heme and di-heme, respectively. The designed peptides contain either DP-G or DP-DA residues for the nucleation of β-turns intended to stabilize multi-stranded β-sheet topologies and ligate heme with bis-His coordination between adjacent antiparallel β-strands. Furthermore, we have optimized a high affinity heme binding pocket, Kd ∼ nM range, in the adjacent β-strands by utilizing a series of four stranded β-sheet peptides employing β- and ω-amino acids. We find that there is a progressive increase in cofactor binding affinity in the designed peptides with the alkyl chain length of ω-amino acids. Notably, the six stranded β-sheet peptide binds two molecules of heme in a cooperative fashion. The designed peptides perform peroxidase activity with varying ability and efficiently carried out electron transfer with membrane associated protein cytochrome c. The current study demonstrates the designing of functional β-sheet proteins in a membrane environment and expands the repertoire of heme protein design.

Proton-Coupled Electron Transfer During the S-State Transitions of the Oxygen-Evolving Complex of Photosystem II

The oxygen-evolving complex (OEC) of photosystem II (PSII) is a unique Mn4O5Ca cluster that catalyzes water oxidation via four photoactivated electron transfer steps. As the protein influence on the redox and protonation chemistry of the OEC remains an open question, we present a classical valence model of the OEC that allows the redox state of each Mn and the protonation state of bridging μ-oxos and terminal waters to remain in equilibrium with the PSII protein throughout the redox cycle. We find that the last bridging oxygen loses its proton during the transition from S0 to S1. Two possible S2 states are found depending on the OEC geometry: S2 has Mn4(IV) with a proton lost from a terminal water (W1) trapped by the nearby D1-D61 if O5 is closer to Mn4, or Mn1(IV), with partial deprotonation of D1-H337 and D1-E329 if O5 is closer to Mn1. In S3, the OEC is Mn4(IV) with W2 deprotonated. The estimated OEC Em's range from +0.7 to +1.3 V, enabling oxidation by P680(+), the primary electron donor in PSII. In chloride-depleted PSII, the proton release increases during the S1 to S2 transition, leaving the OEC unable to properly advance through the water-splitting cycle.

Designing photosystem II: molecular engineering of photo-catalytic proteins

Biological photosynthesis utilizes membrane-bound pigment/protein complexes to convert light into chemical energy through a series of electron-transfer events. In the unique photosystem II (PSII) complex these electron-transfer events result in the oxidation of water to molecular oxygen. PSII is an extremely complex enzyme and in order to exploit its unique ability to convert sunlight into chemical energy it will be necessary to make a minimal model. Here we will briefly describe how PSII functions and identify those aspects that are essential in order to catalyze the oxidation of water into O(2), and review previous attempts to design simple photo-catalytic proteins and summarize our current research exploiting the E. coli bacterioferritin protein as a scaffold into which multiple cofactors can be bound, to oxidize a manganese metal center upon illumination. Through the reverse engineering of PSII and light driven water splitting reactions it may be possible to provide a blueprint for catalysts that can produce clean green fuel for human energy needs.

Characterisation of the electron self-exchange rates in hexametaphosphate-cytochrome-c aggregates measured using high-resolution 1H-NMR spectroscopy

1H-NMR spectroscopy has been used to measure the rate of unimolecular electron exchange between cytochrome c molecules in protein aggregates stabilised by the addition of sodium hexametaphosphate. The average intracomplex electron exchange rate is measured from line broadening of hyperfine-shifted resonances of ferricytochrome c in an equimolar mixture of reduced and oxidised protein. The line-broadening due to electron exchange is significantly greater than that due to protein aggregation and reaches a maximum value between 1-2 mol hexametaphosphate/mol protein. Significantly the exchange-induced broadening is a first-order process and is directly proportional to the size of the cytochrome c oligomer. From the temperature dependence of exchange broadening the activation enthalpy was estimated to be 75.8 kJ mol-1 whereas the activation entropy was 295 J mol-1 K-1 for a dimer of cytochrome c at a hexametaphosphate/protein molar ratio of 1. Both activation parameters decrease in magnitude as the order of the cytochrome c oligomer increases. The rates of intracomplex electron exchange in Saccharomyces cerevisiae iso-2 and Candida krusei cytochromes c are lower than that of the horse protein, implying that primary sequence plays a fundamental part in determining the rate of exchange. The relevance of these observations is discussed in terms of the function of cytochrome c.

Porphyrin cytochrome c. pH effects and interaction with cytochrome-c oxidase

1. Porphyrin cytochrome c, the iron-free derivative of cytochrome c, has been used extensively as a fluorescent analog of cytochrome c. It appears as though its fluorescence intensity but not its relative quantum yield is affected by pH in the physiological range; an apparent pK of about 6.2 is found suggesting a histidine close to the porphyrin. 2. The fluorescence intensity of the porphyrin cytochrome c in the presence of cytochrome c oxidase is independent of pH; this suggests that the oxidase has the capacity to control the pK of whichever group is responsible for the pH sensitivity of the free porphyrin cytochrome c. The most likely candidate for this pH-sensitive group is histidine-18. The N-3 nitrogen of this residue forms one of the axial ligands to the iron in the intact cytochrome c but it is uncoordinated in the iron-free derivative.

The interactions of cytochrome c and porphyrin cytochrome c with cytochrome c oxidase. The resting, reduced and pulsed enzymes

Cytochrome c oxidase forms tight binding complexes with the cytochrome c analog, porphyrin cytochrome c. The behaviour of the reduced and pulsed forms of the oxidase with porphyrin cytochrome c have been followed as functions of ionic strength; this behaviour has been compared with that of the resting oxidase [Kornblatt, Hui Bon Hoa and English (1984) Biochemistry 23, 5906-5911]. All forms of the cytochrome oxidase studied bind one porphyrin cytochrome c per 'functional' cytochrome oxidase (two heme a); it appears as though porphyrin cytochrome c and cytochrome c compete for the same site on the oxidase. The resting enzyme binds cytochrome c 8 times more strongly than porphyrin cytochrome c; the reduced enzyme, in contrast, binds the two with almost equal affinity. In all three cases, resting, pulsed and reduced, the heme-to-porphyrin distance is estimated to be about 3 nm. The tight-binding complexes formed between cytochrome oxidase and porphyrin cytochrome c can be dissociated by salt. Debye-Hückel analysis of salt titrations indicate that the resting enzyme and the reduced enzyme are similar in that the product of the interaction charges on the two proteins is about -14. The product of the charges for the pulsed enzyme is -25, indicating that on average another positive and negative charge take part in the interaction of the two proteins. While there is one tight binding site for cytochrome c per two heme a, cytochrome c is able to 'communicate' with four heme a. In the absence of cytochrome c, electron transfer from tetramethylphenylenediamine to the oxidase to oxygen results in the conversion of the resting form to the 'oxygenated'; in the presence of cytochrome c, the same electron transfer results in the appearance of the 'pulsed' form. Cytochrome c titrations of the enzyme show that a ratio of only one cytochrome c to four heme a is sufficient to convert all the oxidase to the 'pulsed' form. Porphyrin cytochrome c, like cytochrome c, catalyzes the same conversion with the same stoichiometry. The binding data and salt effects indicate that major structural alterations occur in the oxidase as it is converted from the resting to the partially reduced and subsequently to the pulsed form.

Long-range electron transfer in heme proteins

Kinetic experiments have conclusively shown that electron transfer can take place over large distances (greater than 10 angstroms) through protein interiors. Current research focuses on the elucidation of the factors that determine the rates of long-range electron-transfer reactions in modified proteins and protein complexes. Factors receiving experimental and theoretical attention include the donor-acceptor distance, changes in geometry of the donor and acceptor upon electron transfer, and the thermodynamic driving force. Recent experimental work on heme proteins indicates that the electron-transfer rate falls off exponentially with donor-acceptor distance at long range. The rate is greatly enhanced in proteins in which the structural changes accompanying electron transfer are very small.