Kinetic and mechanistic studies of the reactivity of iron(IV) TAMLs toward organic sulfides in water: resolving a fast catalysis versus slower single-turnover reactivity dilemma

Application of FeIII-TAML/H2O2 system for treatment of fluoroquinolone antibiotics

Over the recent past, fluoroquinolone antibiotics (FQs) have raised extensive attention due to their potential to induce the formation of resistance genes and "superbugs", thus various advanced oxidation techniques have been developed to eliminate their release into the environment. In the present study, the prototype tetraamido macrocyclic ligand (Fe^III-TAML)/hydrogen peroxide (H₂O₂) system is employed to degrade FQs (i.e., norfloxacin and ciprofloxacin) over a wide pH range (i.e., pH 6-10), and the reaction rate increases with the increase in pH level. The effect of dosage of Fe^III-TAML and H₂O₂ on the degradation of FQs is evaluated, and the reaction rate is linearly correlated with the added amount of chemicals. Moreover, the impact of natural organic matters (NOM) on the removal of FQs is investigated, and the degradation kinetics show that both NOM type and experimental concentration exhibit negligible influence on the oxidative degradation of selected antibiotics. Based on the results of liquid chromatography-high resolution mass spectrometry and theoretical calculations, the reaction sites and pathways of FQs by Fe^III-TAML/H₂O₂ system are further predicted and elucidated.

Zero-Order Catalysis in TAML-Catalyzed Oxidation of Imidacloprid, a Neonicotinoid Pesticide

Bis-sulfonamide bis-amide TAML activator [Fe{4-NO₂ C₆ H₃ -1,2-(NCOCMe₂ NSO₂ )₂ CHMe}]^- (2) catalyzes oxidative degradation of the oxidation-resistant neonicotinoid insecticide, imidacloprid (IMI), by H₂ O₂ at pH 7 and 25 °C, whereas the tetrakis-amide TAML [Fe{4-NO₂ C₆ H₃ -1,2-(NCOCMe₂ NCO)₂ CF₂ }]^- (1), previously regarded as the most catalytically active TAML, is inactive under the same conditions. At ultra-low concentrations of both imidacloprid and 2, 62 % of the insecticide was oxidized in 2 h, at which time the catalyst is inactivated; oxidation resumes on addition of a succeeding aliquot of 2. Acetate and oxamate were detected by ion chromatography, suggesting deep oxidation of imidacloprid. Explored at concentrations [2]≥[IMI], the reaction kinetics revealed unusually low kinetic order in 2 (0.164±0.006), which is observed alongside the first order in imidacloprid and an ascending hyperbolic dependence in [H₂ O₂ ]. Actual independence of the reaction rate on the catalyst concentration is accounted for in terms of a reversible noncovalent binding between a substrate and a catalyst, which usually results in substrate inhibition when [catalyst]≪[substrate] but explains the zero order in the catalyst when [2]>[IMI]. A plausible mechanism of the TAML-catalyzed oxidations of imidacloprid is briefly discussed. Similar zero-order catalysis is presented for the oxidation of 3-methyl-4-nitrophenol by H₂ O₂ , catalyzed by the TAML analogue of 1 without a NO₂ -group in the aromatic ring.

Peroxymonosulfate activation by iron(III)-tetraamidomacrocyclic ligand for degradation of organic pollutants via high-valent iron-oxo complex

Herein, we proposed a new catalytic oxidation system, i.e., iron(III)-tetraamidomacrocyclic ligand (Fe^III-TAML) mediated activation of peroxymonosulfate (PMS), for highly efficient organic degradation using p-chlorophenol (4-CP) as a model one. PMS/Fe^III-TAML is capable of degrading 4-CP completely in 9 min at the initial 4-CP of 50 μM and pH = 7, whereas the recently explored system, H₂O₂/Fe^III-TAML, could only result in ∼22% 4-CP removal in 20 min under otherwise identical conditions. More attractively, inorganic anions (i.e., Cl^-, SO₄^2-, NO₃^-, and HCO₃^-) exhibited insignificant effect on 4-CP degradation, and the negative effect of natural organic matters (NOM) on the degradation of 4-CP in PMS/Fe^III-TAML is much weaker than the sulfate radical-based oxidation process (PMS/Co²⁺). Combined with in-situ XANES spectra, UV-visible spectra, electron paramagnetic resonance (EPR) spectra, and radical quenching experiments, high-valent iron-oxo complex (Fe^IV(O)TAML) instead of singlet oxygen (¹O₂), superoxide radical (O₂^•-), sulfate radicals (SO₄^•-) and hydroxyl radicals (HO^•) was the key active species responsible for 4-CP degradation. The formation rate (k_I) and consumption rate (k_II) of the Fe^IV(O)TAML in PMS/Fe^III-TAML were pH-dependent in the range of 6.0-11.5. As expected, increasing the Fe^III-TAML and PMS dosage resulted in a higher steady-state concentration of Fe^IV(O)TAML and enhanced the 4-CP degradation accordingly. In addition, the oxidation capacity of PMS was almost totally utilized in PMS/Fe^III-TAML for 4-CP oxidation due to the two-electron abstraction from 4-CP by one PMS. We believe this study will shed new light on effective PMS activation by Fe-ligand complexes to efficiently degrade organic contaminants via nonradical pathway.

Targeting of High-Valent Iron-TAML Activators at Hydrocarbons and Beyond

TAML activators of peroxides are iron(III) complexes. The ligation by four deprotonated amide nitrogens in macrocyclic motifs is the signature of TAMLs where the macrocyclic structures vary considerably. TAML activators are exceptional functional replicas of the peroxidases and cytochrome P450 oxidizing enzymes. In water, they catalyze peroxide oxidation of a broad spectrum of compounds, many of which are micropollutants, compounds that produce undesired effects at low concentrations-as with the enzymes, peroxide is typically activated with near-quantitative efficiency. In nonaqueous solvents such as organic nitriles, the prototype TAML activator gave the structurally authenticated reactive iron(V)oxo units (Fe^VO), wherein the iron atom is two oxidation equivalents above the Fe^III resting state. The iron(V) state can be achieved through the intermediacy of iron(IV) species, which are usually μ-oxo-bridged dimers (Fe^IVFe^IV), and this allows for the reactivity of this potent reactive intermediate to be studied in stoichiometric processes. The present review is primarily focused at the mechanistic features of the oxidation by Fe^VO of hydrocarbons including cyclohexane. The main topic is preceded by a description of mechanisms of oxidation of thioanisoles by Fe^VO, because the associated studies provide valuable insight into the ability of Fe^VO to oxidize organic molecules. The review is opened by a summary of the interconversions between Fe^III, Fe^IVFe^IV, and Fe^VO species, since this information is crucial for interpreting the kinetic data. The highest reactivity in both reaction classes described belongs to Fe^VO. The resting state Fe^III is unreactive oxidatively. Intermediate reactivity is typically found for Fe^IVFe^IV; therefore, kinetic features for these species in interchange and oxidation processes are also reviewed. Examples of using TAML activators for C-H bond cleavage applied to fine organic synthesis conclude the review.

Activation of Dioxygen by a TAML Activator in Reverse Micelles: Characterization of an Fe(III)Fe(IV) Dimer and Associated Catalytic Chemistry

Iron TAML activators of peroxides are functional catalase-peroxidase mimics. Switching from hydrogen peroxide (H2O2) to dioxygen (O2) as the primary oxidant was achieved by using a system of reverse micelles of Aerosol OT (AOT) in n-octane. Hydrophilic TAML activators are localized in the aqueous microreactors of reverse micelles where water is present in much lower abundance than in bulk water. n-Octane serves as a proximate reservoir supplying O2 to result in partial oxidation of Fe(III) to Fe(IV)-containing species, mostly the Fe(III)Fe(IV) (major) and Fe(IV)Fe(IV) (minor) dimers which coexist with the Fe(III) TAML monomeric species. The speciation depends on the pH and the degree of hydration w0, viz., the amount of water in the reverse micelles. The previously unknown Fe(III)Fe(IV) dimer has been characterized by UV-vis, EPR, and Mössbauer spectroscopies. Reactive electron donors such as NADH, pinacyanol chloride, and hydroquinone undergo the TAML-catalyzed oxidation by O2. The oxidation of NADH, studied in most detail, is much faster at the lowest degree of hydration w0 (in "drier micelles") and is accelerated by light through NADH photochemistry. Dyes that are more resistant to oxidation than pinacyanol chloride (Orange II, Safranine O) are not oxidized in the reverse micellar media. Despite the limitation of low reactivity, the new systems highlight an encouraging step in replacing TAML peroxidase-like chemistry with more attractive dioxygen-activation chemistry.