Grain-boundary studies by the coincident-site lattice model and electron-energy-loss spectroscopy of the oxygen K edge in YBa2Cu3O7-δ

Electron energy-loss spectroscopy study of ZnO nanobelts

Nanobelts of ZnO have well-defined shapes that are enclosed by {0001}, {0110} and {2110} facets. The nanobelts grow along [0110] and [2110] with large flat surfaces of +/-(0001) and +/-(0110), respectively. Electron energy-loss spectroscopy has been applied to study the electronic structure of ZnO nanobelts of different growth orientations. A plasmon peak observed at 13 eV is suggested to be the result of polar surface excitation. The energy-loss near-edge structure of the oxygen K and zinc L3 edges acquired from the two types of nanobelts show clear orientation dependence, and they agree well to the calculated results.

Experimental and theoretical evidence for the magic angle in transmission electron energy loss spectroscopy

We present experimental measurements of the C K-ELNES of high temperature pyrolysed graphite and related crystalline materials as a function of collection angle and sample tilt. These results together with a corresponding theoretical analysis indicate that the so-called "magic angle" for EELS measurements of an anisotropic crystal such as graphite, where spectra are independent of sample orientation, is approximately two times the characteristic scattering angle. We briefly discuss the implications of this result for the experimental measurement of anisotropic structures, including interfaces, as well as for the detailed modelling of ELNES structures using advanced electronic structure calculations.

Crystal structure, chemical composition, and extended defects of the high-Tc (Bi,Pb)2Sr2Ca(n)-1CunO4 + 2n + delta compounds

This paper summarizes results obtained by high-resolution transmission electron microscopy on the crystal structure and microstructure of the (Bi,Pb)2Sr2Ca(n)-1CunO4 + 2n + delta high-Tc superconducting oxides. The experimental basis for the work presented here are high-resolution structure images obtained at ultra-thin (3 nm) areas of carefully prepared transmission electron microscope (TEM) samples. The analysis was carried out on a 400 kV TEM equipped with a pole piece yielding 0.17 nm point-to-point resolution. From the images obtained the projected crystal potential of the cations can be extracted directly, as confirmed by detailed image simulation. Structural analysis of the oxygen sublattice remains an unsolved problem by high-resolution TEM (HRTEM), mainly because of the small scattering factors, and thus the contribution of the oxygen sublattice to the image contrast is small. The (BiPb)2Sr2Ca(n)-1CunO4 + 2n + delta phases are modulated structures that can be understood as an average structure plus a superimposed displacement field. The crystal structure consists of BiO double layers and perovskite-type cuboids (containing Sr, Ca, Cu, and O), which are sandwiched between the BiO double layers. The displacement field can be directly analyzed by HRTEM, and the largest displacement amplitudes of 70 pm were determined for the Bi atoms in the n = 1 compound. The chemical composition of the n = 2 and n = 3 compounds was determined by EDX in the TEM for the cation sublattice. A significant (Ca + Sr) deficiency (approximately 10%) with respect to Cu was found. The (Sr + Ca)/Cu mole fraction ratio was 1.31 for the Bi-2212 phase and 1.14 for the Bi(Pb)-2223 phase. The oxygen content cannot be determined by EDX in the TEM with the accuracy necessary for a correlation with electrical and superconducting properties. The defect structure present in these materials, that is, intergrown lamellae with different crystal structures and equal or different chemical compositions, stacking faults, and grain boundaries, is summarized. The importance of grain boundaries for understanding and improving superconducting properties is emphasized.