Applications of a Modified “Isohydric Solvent System” in HPLC on Silica Gel for the Analysis of the Macrolide Antibiotics Turimycins and Spiramycins

Analysis of spiramycin by capillary electrophoresis

The development and validation of an analytical method for the determination of spiramycin I in the presence of its related substances by capillary electrophoresis is shown. The separation, performed in a phosphate buffer (80 mM, pH 7.5) containing 12 mM cetyltrimethylammonium bromide (CTAB) and 20 mM sodium cholate, with a 50 microm ID and 44 cm long fused-silica capillary (36 cm effective length), applying a voltage of 12 kV (l approximately 80 microA), at 25 degrees C, is achieved in 15 min. Good selectivity among spiramycin I and its related substances was obtained. The influence of the buffer pH, and of the CTAB and sodium cholate concentrations was investigated. The method robustness, examined by means of a full-fraction factorial design, shows that it can be used within the limits set for the three parameters that were investigated. The method is linear (r = 0.9992) and precise (day-to-day corrected peak area repeatability, n = 18, relative standard deviation = 1.3%). The limits of detection and quantitation are 7 pg (0.025%) and 22 pg (0.08%), respectively, relative to a 2 mg/mL solution.

Analysis of macrolide antibiotics

The following macrolide antibiotics have been covered in this review: erythromycin and its related substances, azithromycin, clarithromycin, dirithromycin, roxithromycin, flurithromycin, josamycin, rokitamycin, kitasamycin, mycinamycin, mirosamycin, oleandomycin, rosaramicin, spiramycin and tylosin. The application of various thin-layer chromatography, paper chromatography, gas chromatography, high-performance liquid chromatography and capillary zone electrophoresis procedures for their analysis are described. These techniques have been applied to the separation and quantitative analysis of the macrolides in fermentation media, purity assessment of raw materials, assay of pharmaceutical dosage forms and the measurement of clinically useful macrolide antibiotics in biological samples such as blood, plasma, serum, urine and tissues. Data relating to the chromatographic behaviour of some macrolide antibiotics as well as the various detection methods used, such as bioautography, UV spectrophotometry, fluorometry, electrochemical detection, chemiluminescence and mass spectrometry techniques are also included.