Towards an absolute scale for adhesion strength of ship hull microfouling

Nanotechnology-Based Antimicrobial and Antiviral Surface Coating Strategies

Biocontamination of medical devices and implants is a growing issue that causes medical complications and increased expenses. In the fight against biocontamination, developing synthetic surfaces, which reduce the adhesion of microbes and provide biocidal activity or combinatory effects, has emerged as a major global strategy. Advances in nanotechnology and biological sciences have made it possible to design smart surfaces for decreasing infections. Nevertheless, the clinical performance of these surfaces is highly depending on the choice of material. This review focuses on the antimicrobial surfaces with functional material coatings, such as cationic polymers, metal coatings and antifouling micro-/nanostructures. One of the highlights of the review is providing insights into the virus-inactivating surface development, which might particularly be useful for controlling the currently confronted pandemic coronavirus disease 2019 (COVID-19). The nanotechnology-based strategies presented here might be beneficial to produce materials that reduce or prevent the transmission of airborne viral droplets, once applied to biomedical devices and protective equipment of medical workers. Overall, this review compiles existing studies in this broad field by focusing on the recent related developments, draws attention to the possible activity mechanisms, discusses the key challenges and provides future recommendations for developing new, efficient antimicrobial and antiviral surface coatings.

Underwater shear-based grooming of marine biofouling using a non-contact Bernoulli pad device

The biofouling removal ability of a shear-based device was tested on two submerged surface types, Garolite G-10 and Intersleek 1100SR. Each surface was groomed at four frequencies along with a control group. The seven-week grooming study was conducted in Narragansett Bay, Rhode Island. The Bernoulli pad device uses confined radial outflow to generate both surface-normal forces to grip the submerged surface and shear stress to groom the surface without contact. An image-processing algorithm was developed and used to assess the effectiveness of the various grooming protocols, along with direct measurements of chlorophyll a per surface area. The image-processing data showed that the grooming resulted in ∼50% cleanliness on the Garolite at the end of the study whereas the Intersleek was continuously restored to nearly its initial clean state. Chlorophyll a data supported these overall conclusions. These results indicate that surface cleanliness can be maintained effectively on Intersleek using frequent shear-based grooming.

Ship hull in-water cleaning and its effects on fouling-control coatings

Today, ship hull fouling is managed through fouling-control coatings, complemented with in-water cleaning. During cleaning, coating damage and wear must be avoided, for maximum coating lifetime and reduced antifoulant release. When possible, cleaning should target early stages of fouling, using minimal forces. However, such forces, and their effects on coatings, have not yet been fully quantified. In this one-year study, minimal cleaning forces were determined using a newly-designed immersed waterjet. The results show that bi-monthly/monthly cleaning, with maximum wall shear stress up to ∼1.3 kPa and jet stagnation pressure ∼0.17 MPa, did not appear to cause damage or wear on either the biocidal antifouling (AF) or the biocide-free foul-release (FR) coatings. The AF coating required bi-monthly cleanings to keep fouling to incipient slime (time-averaged results), while the FR coating had a similar fouling level even without cleaning. The reported forces may be used in matching cleaning parameters to the adhesion strength of the early stages of fouling.