The synthesis and characterisation of a magnesium amine bis(phenolate) complex as a potential initiator for the ring-opening polymerisation of cyclic esters

Fast magnesium ion conducting isopropylamine magnesium borohydride enhanced by hydrophobic interactions

New materials for the next generation of electrochemical energy storage devices such as batteries are of extreme importance. Here we investigate the structure, ionic conductivity and thermal properties of isopropylamine magnesium borohydride based composites with different compositions, Mg(BH₄)₂·x(CH₃)₂CHNH₂, x = 0.5, 0.9, 1.25, 1.5, 1.75, 2.5, 3.1. Three new compounds are discovered, x = 1, 2, and 3 and the monoclinic structure of Mg(BH₄)₂·2(CH₃)₂CHNH₂ (P2₁/c) is investigated in detail. This structure consists of neutral complexes [Mg(BH₄)₂((CH₃)₂CHNH₂)₂] di-hydrogen bonded to form layers and these layers are connected by hydrophobic interactions via the isopropyl moieties. The orthorhombic unit cell of Mg(BH₄)₂·(CH₃)₂CHNH₂ was also determined, a = 9.78, b = 12.17 and c = 17.24 Å. In general, the samples are thermally stable up to 50 °C where they started to become softer, and at 70 °C isopropylamine release and melting started. The highest Mg²⁺ ionic conductivity was that of Mg(BH₄)₂·1.5(CH₃)₂CHNH₂, σ(Mg²⁺) = 2.7 × 10^-4 S cm^-1 at 45 °C, with an activation energy of E_A = 1.22 eV. Furthermore, reversible stripping/plating of Mg was displayed at 45 °C, with an oxidative stability of 1.2 V vs. Mg/Mg²⁺. The addition of MgO nanoparticles (75 wt%) improves the mechanical and thermal stability, and decreases the activation energy, to E_A = 0.56 eV. Thereby the Mg²⁺ conductivity is increased at low temperature. This suggests that the hydrophobic interactions contribute to the high ionic conductivity in the solid state, which opens a new avenue for design and discovery of electrolyte materials.

Lithium, sodium, potassium and calcium amine-bis(phenolate) complexes in the ring-opening polymerization of rac-lactide

Compounds of Li, Na, K and Ca of a tetradentate amino-bis(phenolato) ligand were prepared. Bimetallic compounds formulated as M₂[L](THF)_n (where M = Na, n = 1 (1·THF) or Li, n = 1 (2·THF)) were synthesized via the reaction of H₂[L] (where [L] = 2-pyridylmethylamino-N,N-bis(2-methylene-4-methoxy-6-tert-butylphenolato) with sodium hydride or n-butyllithium, respectively, in THF. Monometallic complexes MH[L](THF)_n (where M = Na, n = 1 (3·THF), Li, n = 0 (4) and K, n = 0 (5)) were obtained by reaction of H₂[L] with MN(SiMe₃)₂ where M = Na, Li, or K. Calcium complex Ca[L](THF) (6·THF) was synthesized in two ways; reaction of Na₂[L] with calcium iodide in THF, and reaction of Ca[N(SiMe₃)₂]₂ with H₂[L] in toluene. Compounds 1-6 exhibit activity for rac-lactide polymerization under melt and solution conditions. Moderate control of polymer molecular weights was achieved in toluene, whereas polydisperse polymer was obtained under solvent free conditions. MALDI-TOF MS analysis of the polymer end groups revealed a predominantly cyclic nature for the polylactides.

Magnesium amino-bis(phenolato) complexes for the ring-opening polymerization of rac-lactide

Magnesium compounds of tetradentate amino-bis(phenolato) ligands, Mg[L1] (1) and Mg[L2] (2) (where [L1] = 2-pyridyl-N,N-bis(2-methylene-4-methoxy-6-tert-butylphenolato), and [L2] = dimethylaminoethylamino-N,N-bis(2-methylene-4-methyl-6-tert-butylphenolato)) were prepared. The proligands, H2[L1] and H2[L2] were reacted with di(n-butyl)magnesium in toluene to give the desired compounds in high yields. Compounds 1 and 2 exhibit dimeric structures in solutions of non-coordinating solvents as observed by NMR spectroscopy and in the solid state as shown by the single crystal X-ray structure of 2. These compounds exhibit good activity for rac-lactide polymerization in solution and in molten lactide.