α-Chymotrypsin shows higher activity in water as well as organic solvents after three phase partitioning

Three-phase partitioning as a rapid and easy method for the purification and recovery of catalase from sweet potato tubers (Solanum tuberosum)

Three-phase partitioning (TPP) was used to purify and recover catalase from potato crude extract. The method consists of ammonium sulfate saturation, t-butanol addition, and adjustment of pH, respectively. The best catalase recovery (262 %) and 14.1-fold purification were seen in the interfacial phase in the presence of 40 % (w/v) ammonium sulfate saturation with 1.0:1.0 crude extract/t-butanol ratio (v/v) at pH 7 in a single step. The sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) analysis of the enzyme showed comparatively purification and protein molecular weight was nearly found to be 56 kDa. This study shows that TPP is a simple, economical, and quick method for the recovering of catalase and can be used for the purification process.

Activation of alpha chymotrypsin by three phase partitioning is accompanied by aggregation

Precipitation of alpha chymotrypsin in the simultaneous presence of ammonium sulphate and t-butanol (three phase partitioning) resulted in preparations which showed self aggregation of the enzyme molecules. Precipitation with increasing amounts of ammonium sulphate led to increasing size of aggregates. While light scattering estimated the hydrodynamic diameter of these aggregates in the range of 242-1124 nm; Nanoparticle tracking analysis (NTA) gave the value as 130-462 nm. Scanning electron microscopy and gel filtration on Sephadex G-200 showed extensive aggregation in these preparations. Transmission electron microscopy showed that the aggregates had irregular shapes. All the aggregates had about 3× higher catalytic activity than the native enzyme. These aggregates did not differ in λ(max) of fluorescence emission which was around 340 nm. However, all the aggregates showed higher fluorescence emission intensity. Far-UV and near-UV circular dichroism also showed no significant structural changes as compared to the native molecule. Interestingly, HPLC gel filtration (on a hydroxylated silica column) gave 14 nm as the diameter for all preparations. Light scattering of preparations in the presence of 10% ethylene glycol also dissociated the aggregates to monomers of 14 nm. Both these results indicated that hydrophobic interactions were the driving force behind this aggregation. These results indicate: (1) Even without any major structural change, three phase partitioning led to protein molecules becoming highly prone to aggregation. (2) Different methods gave widely different estimates of sizes of aggregates. It was however possible to reconcile the data obtained with various approaches. (3) The nature of the gel filtration column is crucial and use of this technique for refolding and studying aggregation needs a rethink.

Enhancement of lipase activity in non-aqueous media upon immobilization on multi-walled carbon nanotubes

BACKGROUND

Immobilization of biologically active proteins on nanosized surfaces is a key process in bionanofabrication. Carbon nanotubes with their high surface areas, as well as useful electronic, thermal and mechanical properties, constitute important building blocks in the fabrication of novel functional materials.

RESULTS

Lipases from Candida rugosa (CRL) were found to be adsorbed on the multiwalled carbon nanotubes with very high retention of their biological activity (97%). The immobilized biocatalyst showed 2.2- and 14-fold increases in the initial rates of transesterification activity in nearly anhydrous hexane and water immiscible ionic liquid [Bmim] [PF6] respectively, as compared to the lyophilized powdered enzyme. It is presumed that the interaction with the hydrophobic surface of the nanotubes resulted in conformational changes leading to the 'open lid' structure of CRL. The immobilized enzyme was found to give 64% conversion over 24 h (as opposed to 14% with free enzyme) in the formation of butylbutyrate in nearly anhydrous hexane. Similarly, with ionic liquid [Bmim] [PF6], the immobilized enzyme allowed 71% conversion as compared to 16% with the free enzyme. The immobilized lipase also showed high enantioselectivity as determined by kinetic resolution of (+/-) 1-phenylethanol in [Bmim] [PF6]. While free CRL gave only 5% conversion after 36 h, the immobilized enzyme resulted in 37% conversion with > 99% enantiomeric excess. TEM studies on the immobilized biocatalyst showed that the enzyme is attached to the multiwalled nanotubes.

CONCLUSION

Successful immobilization of enzymes on nanosized carriers could pave the way for reduced reactor volumes required for biotransformations, as well as having a use in the construction of miniaturized biosensensor devices.

Obtaining high transesterification activity for subtilisin in ionic liquids

It is known that subtilisin shows poor transesterification activity in ionic liquids (ILs). The present work, taking subtilisin as the system, explores approaches for biocatalyst preparations, which are capable of yielding higher/adequate transesterification activity in these solvents. Of all the approaches tried, enzyme precipitated and rinsed with n-propanol (EPRP) gave the best results (about 10,000 times increase in initial rates in 1-butyl-3-methylimidazolium hexafluorophosphate ([Bmim][PF(6)]) over what is obtained with pH tuned lyophilized powders). In case of water soluble ionic liquid 1-butyl-3-methylimidazolium tetrafluoroborate ([Bmim][BF(4)]), pH tuned lyophilized subtilisin did not show any transesterification activity. EPRP, however, gave an initial rate (for transesterification) of 2.78 mmol mg(-1) h(-1).

Enhancing the synthetic utility of aldolase antibody 38C2

Three-phase partitioning (TPP) treated aldolase antibody 38C2 was evaluated for aldol reaction between p-nitrobenzaldehyde and acetone to give 4-(4'-nitrophenyl)-4-hydroxy-2-butanone. While TPP-treated 38C2 transformed 65% of p-nitrobenzaldehyde, the untreated 38C2 gave only 24% transformation in 18 h at 25 degrees C. However, since TPP-treated 38C2 also gave an additional (unidentified) product, its synthetic utility was limited. Crosslinked aggregate of 38C2, however, gave the biocatalyst which gave a single product and could be reused at 40 degrees C five times without loss of activity.