Treatment of high-strength purified terephthalic acid (PTA) wastewater using a magnetic porous ceramic support in laboratory-scale anaerobic-aerobic fluidized bed reactors

Evaluation of the start-up of hydraulic conditions of a fluidised bed system

The development of this research was based on the analysis of an anaerobic fluidised bed reactor from the assembly of its components to the sealing of the system and further fluidisation. A hydrometer and a Venturi were used to identify the best means of measuring the flow rate. Results produced by both devices were similar, however, the latter was less effective due to the low flow rates necessary to operate the system. The hydrometer was the most adequate device for flow rate measurements in the range between 0.1 and 1.0 m³/h, whereas the Venturi proved to be an adequate device for the flow in the range between 0.3 and 0.7 m³/h. Sand with grain sizes varying from 357 to 1000 µm was used as support material. It was not observed statistically significant differences between the minimum fluidisation velocities related to the amount of supported material of 20% and 40% (V_SM/V_usable) added to the reactor. Forty percent of the usable volume occupied with sand is adequate to reach fluidisation, instead of only the expansion of the bed. The fluidisation velocities for the sand grain size of 357 µm were 8.4 m/h ± 0.25 for 20%, and 8.6 m/h ± 0.30 for 40%, whereas for the 505 µm they were, respectively for 20% and 40%, 9.2 m/h ±0.70 and 10.1 m/h ± 0.37. The hydraulic tests allow to stress that sand grain sizes varying from 357 to 505 µm are recommended to be used in a system with similar characteristics.