Separation and purification of scandium: From industry to medicine

Highly Selective and Portable Fluorescence Turn-On Detection of Sc3+ in Ore and Water Based on Strong Lewis Acid-Base Coordination

Detecting scandium (Sc) with high selectivity and sensitivity is a challenging task due to its chemical similarity to other rare earth ions. Our findings show that the fluorescence of the complex fluorescent indicator calcein (CL) is quenched under acidic conditions (pH = 2), and Sc3+ strongly inhibits this process. The results demonstrate that CL forms multimers and precipitates out of the solution under acidic conditions, while Sc3+ causes a significant decrease in the scattering intensity of the solution. Additional experiments revealed that the strong Lewis acid nature of Sc3+ complexes with the carboxyl groups of CL leads to increased dispersion of CL even under acidic conditions, thus enhancing its absorption and fluorescence. The complexation ratio of Sc3+ and CL was investigated through spectral titrations and theoretical calculations. The interaction between Sc3+ and CL is the strongest among rare earth and common metal ions due to the smallest ionic radius, resulting in high selectivity. The fluorescence turn-on strategy had a linear range of 0.04 to 2.25 μM under optimal conditions, with a detection limit of 20 nM for Sc3+. The combination of 3D printing and a smartphone program allows for portable on-site analysis of Sc3+. Mineral and water samples were used to demonstrate the potential of this strategy for the rapid, selective, and sensitive analysis of low levels of Sc3+.

New insights on scandium separation from scandium concentrate with titanium dioxide wastewater

In this study, a scandium concentrate with Sc2O3 content of 66.24 g/t was obtained from V-Ti magnetite tailings by physical concentration, and the main Sc-bearing minerals were augite and hornblende. A novel process of roasting and leaching was proposed to extract scandium from scandium concentrate with titanium dioxide wastewater. Scandium concentrate was pretreated by roasting, and titanium dioxide wastewater was used to directly leach scandium from the roasted ore. The effects of roasting and leaching parameters such as roasting temperature, roasting time, roasting agents, leaching temperature, leaching time, liquid-to-solid ratio, and leaching agents on scandium separation were thoroughly researched in the experimental procedure. The results show that a scandium leaching efficiency of 85.89% was obtained, and the scandium content of leaching residue decreased to 9.31 g/t under the optimal conditions: a roasting temperature of 1123 K, a roasting time of 120 min, a leaching temperature of 343 K, a leaching time of 120 min, and a m (titanium dioxide wastewater)∶m (roasted ore)∶m (ammonium fluoride) ratio of 8∶1∶0.09. The main findings of the scandium separation mechanism show that Sc-bearing minerals can effectively decompose and release scandium element after roasting, and created favorable conditions for scandium leaching with titanium dioxide wastewater to achieve the purpose of scandium recovery.

Scandium Radioisotopes-Toward New Targets and Imaging Modalities

The concept of theranostics uses radioisotopes of the same or chemically similar elements to label biological ligands in a way that allows the use of diagnostic and therapeutic radiation for a combined diagnosis and treatment regimen. For scandium, radioisotopes -43 and -44 can be used as diagnostic markers, while radioisotope scandium-47 can be used in the same configuration for targeted therapy. This work presents the latest achievements in the production and processing of radioisotopes and briefly characterizes solutions aimed at increasing the availability of these radioisotopes for research and clinical practice.

Breaking through the Separation Barrier of Zr(IV) and Hf(IV): Magical Effect of the Bisamide Ligand

The fundamental safety improvement of the nuclear industry depends on two important elements: Zr(IV) and Hf(IV). However, the elementary knowledge is that separation processes of the two are difficult, so there are few existing methods to meet the requirement. Furthermore, the process is highly contaminated. The development of green and efficient ligands for the separation of Zr(IV) and Hf(IV) is beneficial to the stable development of the nuclear industry. A bisamide ligand D001 was reported for the extraction and separation of Zr(IV) and Hf(IV). D001 utilizes an anionic association mechanism to extract Zr(IV) and Hf(IV) by coordinating amide groups with metals to form complexes H₂ZrCl₆·2 D001 and H₂HfCl₆·2 D001. Using quantum chemical calculations, we illuminate the extraction mechanism of bisamide ligands and the reasons for their better coordination ability than monoamide ligands and carboxylic acid ligands. A process of bisamide extraction and separation of Zr(IV) and Hf(IV) was established, and the thermodynamic parameters of the process were investigated.

A holistic approach for the recovery of rare earth elements and scandium from secondary sources under a circular economy framework - A review

Limited natural resources and a continuous increase in the demand for modern technological products, is creating a demand and supply gap for rare earth elements (REEs) and Sc. There is therefore a need to adopt the sustainable approach of the circular economy system (CE). In this review, we defined six steps required to close the loop and recover REEs, using a holistic approach. Recent statistics on REEs and Sc demand and the number of waste generations are reported and studies on more environmentally friendly, economic, and/or efficient recovery processes are summarized. Pilot-scale recovery facilities are described for several types of secondary sources. Finally, we identify obstacles to closing the REE loop in a circular economy and the reasons why secondary sources are not preferred over primary sources. Briefly, recovery from secondary sources should be environmentally and economically friendly and of an acceptable standard concerning final product quality. However, current technologies for recovery from for secondary sources are limiting and technology needs will vary depending on the source type. The quality/purity of the recovered metals should be proven so that they do not result in any adverse effects on the product quality, when they are being used as secondary raw material. In addition, for industrial-scale facilities, process improvements are required that consider environmental conditions.

Scandium-microorganism interactions in new biotechnologies

Scandium (Sc) plays a special role in high-tech industries because of its wide application in green, space, and defense technologies. However, Sc mining and purification are problematic due to political, technological, and environmental difficulties. The deficit of this element limits global technological development. One sustainable solution to this problem is to use microorganisms to extract Sc from ore and waste, as well as to concentrate and separate it from other elements. Sc also demonstrates attractive metabolic effects on microbes that is of great interest in white biotechnology. Sc increases the production of proteins and secondary metabolites and activates poorly expressed genes. This review offers a comprehensive analysis of current knowledge on the application of Sc-microorganism interactions in promising biotechnologies, its perspectives, and future challenges.

Methods for the Determination of Transition Metal Impurities in Cyclotron-Produced Radiometals

Cyclotron-produced radiometals must be separated from the irradiated target and purified from other metal impurities, which could interfere with the radiolabeling process. We compared different chromatographic and colorimetric methods to determine the amount of transition metals in radioactive samples. Besides commercially available colorimetric tests, 4-(2-pyridylazo)resorcinol and xylenol orange were used as a non-selective metal reagents, forming water-soluble chelates with most of the transition metals immediately. We compared the applicability of pre- and post-column derivatization, as well as colorimetric determination without separation. The studied chromatographic and colorimetric analyses are not suitable to completely replace atomic spectroscopic techniques for the determination of metal contaminants in radioactive samples, but they may play an important role in the development of methods for the purification of radiometals and in their routine quality control.

Comparison of Usefulness of Four Chelating Agents (EDTA, NTA, ODA and IDA) for the Chromatographic Separation of Micro and Macro Amounts of Rare Earth Elements

Literature on the use of four chelating agents namely: ethylenediaminetetraacetic acid, nitrilotriacetic acid, diglycolic acid and iminodiacetic acid for the chromatographic separation of micro and macro amounts of rare earth elements was critically reviewed and supplemented with some new unpublished data from our Laboratory. Advantages and disadvantages of ion exchange chromatography both in cation and anion mode as well as ion interaction chromatography techniques, which were used for rare earth elements separation, are discussed. The usefulness of some of the chromatographic systems for micro-macro separations was discussed and demonstrated. The importance of resilience of the separation method to column overloading in some analytical and larger scale separations was emphasized. The methods described in this article might suit well for recovering of individual lanthanides and yttrium from e-waste and other industrial wastes which were fast accumulating in recent years.

A Step-by-Step Guide for the Novel Radiometal Production for Medical Applications: Case Studies with 68Ga, 44Sc, 177Lu and 161Tb

The production of novel radionuclides is the first step towards the development of new effective radiopharmaceuticals, and the quality thereof directly affects the preclinical and clinical phases. In this review, novel radiometal production for medical applications is briefly elucidated. The production status of the imaging nuclide 44Sc and the therapeutic β--emitter nuclide 161Tb are compared to their more established counterparts, 68Ga and 177Lu according to their targetry, irradiation process, radiochemistry, and quality control aspects. The detailed discussion of these significant issues will help towards the future introduction of these promising radionuclides into drug manufacture for clinical application under Good Manufacturing Practice (GMP).

The First-Row Transition Metals in the Periodic Table of Medicine

In this manuscript, we describe medical applications of each first-row transition metal including nutritional, pharmaceutical, and diagnostic applications. The 10 first-row transition metals in particular are found to have many applications since there five essential elements among them. We summarize the aqueous chemistry of each element to illustrate that these fundamental properties are linked to medical applications and will dictate some of nature’s solutions to the needs of cells. The five essential trace elements—iron, copper, zinc, manganese, and cobalt—represent four redox active elements and one redox inactive element. Since electron transfer is a critical process that must happen for life, it is therefore not surprising that four of the essential trace elements are involved in such processes, whereas the one non-redox active element is found to have important roles as a secondary messenger.. Perhaps surprising is the fact that scandium, titanium, vanadium, chromium, and nickel have many applications, covering the entire range of benefits including controlling pathogen growth, pharmaceutical and diagnostic applications, including benefits such as nutritional additives and hardware production of key medical devices. Some patterns emerge in the summary of biological function andmedical roles that can be attributed to small differences in the first-row transition metals.

Perspectives on the Use of Liquid Extraction for Radioisotope Purification

The reliable and efficient production of radioisotopes for diagnosis and therapy is becoming an increasingly important capability, due to their demonstrated utility in Nuclear Medicine applications. Starting from the first processes involving the separation of ^99mTc from irradiated materials, several methods and concepts have been developed to selectively extract the radioisotopes of interest. Even though the initial methods were based on liquid-liquid extraction (LLE) approaches, the perceived difficulty in automating such processes has slowly moved the focus towards resin separation methods, whose basic chemical principles are often similar to the LLE ones in terms of chelators and phases. However, the emerging field of flow chemistry allows LLE to be easily automated and operated in a continuous manner, resulting in an even improved efficiency and reliability. In this contribution, we will outline the fundamentals of LLE processes and their translation into flow-based apparatuses; in addition, we will provide examples of radioisotope separations that have been achieved using LLE methods. This article is intended to offer insights about the future potential of LLE to purify medically relevant radioisotopes.

Promising Scandium Radionuclides for Nuclear Medicine: A Review on the Production and Chemistry up to In Vivo Proofs of Concept

Scandium radionuclides have been identified in the late 1990s as promising for nuclear medicine applications, but have been set aside for about 20 years. Among the different isotopes of scandium, ⁴³Sc and ⁴⁴Sc are interesting for positron emission tomography imaging, whereas ⁴⁷Sc is interesting for therapy. The ⁴⁴Sc/⁴⁷Sc or ⁴³Sc/⁴⁷Sc pairs could be thus envisaged as true theranostic pairs. Another interesting aspect of scandium is that its chemistry is governed by the trivalent ion, Sc³⁺. When combined with its hardness and its size, it gives this element a lanthanide-like behavior. It is then also possible to use it in a theranostic approach in combination with ¹⁷⁷Lu or other lanthanides. This article aims to review the progresses that have been made over the last decade on scandium isotope production and coordination chemistry. It also reviews the radiolabeling aspects and the first (pre) clinical studies performed.