Long bone fractures: treatment patterns and factors contributing to use of intramedullary nailing

Mechanically compliant locking plates for diaphyseal fracture fixation: A biomechanical study

Axial micromotion between bone fragments can stimulate callus formation and fracture healing. In this study, we propose a novel mechanically compliant locking plate which achieves up to 0.6 mm of interfragmentary motion as flexures machined into the plate elastically deflect under physiological load. We investigated the biomechanical performance of three compliant plate variations in comparison to rigid control plates with small and large working lengths in a comminuted bridge plating scenario using humeral diaphysis surrogates. Under static axial loading, average interfragmentary motion was 6 times larger at 100 N (0.38 vs. 0.05 mm) and nearly three times larger at 350 N (0.58 vs. 0.2 mm) for compliant plates than rigid plates, respectively. Compliant plates delivered between 2.5 and 3.4 times more symmetric interfragmentary motion than rigid plates (p < 0.01). The bi-phasic stiffness of compliant pates provided 74%-96% lower initial axial stiffness up to approximately 100 N (p < 0.01), after which compliant plate stiffness was similar to rigid plates with increased working length (p > 0.3). The strength to failure of compliant plates under dynamic loading was on average 48%-55% lower than rigid plate groups (p < 0.01); however, all plates survived cyclic fatigue loading of 100,000 cycles at 350 N. This work characterizes the improvement in interfragmentary motion and the reduction in strength to failure of compliant plates compared to control rigid plates. Compliant plates may offer potential in comminuted fracture healing due to their ability to deliver symmetric interfragmentary motion into the range known to stimulate callus formation while surviving moderate fatigue loading with no signs of failure.

Long-term outcome of fibula flaps in complex limb reconstruction compared to alternative procedures, a median follow up of 41 months

INTRODUCTION

Complex open long bone fractures present a multidisciplinary surgical challenge. Various treatment options are discussed with no consensus. Fibula flaps (FF) are frequently used in maxillofacial surgery, however their use in limb injuries is less common. With the tremendous improvement in microsurgery, orthoplastic surgery gained importance. Our retrospective study aims to assess the long-term results and the quality of life of the patients operated by FF for complex traumatic limb reconstruction.

PATIENTS AND METHODS

We conducted an observational mono centric retrospective study from the year 2011 to the year 2021. Patients operated for complicated traumatic limb fractures using FF were included in the study. Not only long-term clinical results were evaluated, but also Patient-reported outcome measures (PROM). These included the Lower Extremity Functional Scale (LEFS), Quick Disabilities of the Arm, shoulder and hand (Qdash), and the Visual Analogue Scale (VAS). The statistical analysis was done using the R Software.

RESULTS

Twenty patients were included in our study. 80% achieved complete union with no re fracture rate at a median follow-up of 41 months. All of the patients (n = 4) who underwent amputation were smokers (p = .09), were operated for lower limb fractures (p = .54), and were males (p = 1). The length of hospital stay was associated with an increased duration to complete bony union (p = .01, coefficient = 2.88). At the end of follow-up, the LEFS median score was 67 for the total population and 63.5 for the lower limb reconstructed sub group.

CONCLUSION

VFF is an important tool in the armamentarium of orthoplastic surgeons. Encouraging long term functional and clinical outcomes were obtained in patients with complex traumatic limb fractures.

The burden of long bone fracture and health system response in Malawi: A scoping review

OBJECTIVES

Fractures pose serious health and socioeconomic consequences for individuals, their families, and societies more broadly. In many low-resource settings, case fatality and long-term sequelae after a fracture remain high due to individual- and system-level barriers affecting timely access to care. This scoping review explored the burden of fractures in Malawi using long bone fracture (LBF) as a case study by examining the epidemiology of these injuries, their consequences, and the accessibility of quality healthcare. Our aim is to not only describe the scale of the issue but to identify specific interventions that can help address the challenges faced in settings with limited resources and healthcare budgets.

METHODS

A scoping review methodology was adopted with a narrative synthesis of results. We searched five databases to identify relevant literature and applied the "Three Delays" model and the WHO's Building Blocks Framework to analyse findings on the accessibility of fracture care.

RESULTS

Fractures most often occurred among young males, with falls being the leading cause, constituting between 5 and 35 % of the total burden of injuries. Fractures were typically managed without surgery despite consistent local evidence showing surgical treatment was superior to conservative management in terms of length of hospital stay and bone healing. Poor functional, economic, and social outcomes were noted in fracture patients, especially after conservative treatment. A lack of trust in the health system, financial barriers, poor transport, and road infrastructure, and interfacility transfers were identified as barriers to care-seeking. Factors challenging the provision of appropriate care included governance issues, poor health infrastructure, financial constraints, and shortage of supplies and human resources.

CONCLUSIONS

To the best of our knowledge, this review represents the first comprehensive examination of the state of LBF and the health system's response in Malawi. The findings underscore the pressing need for a national trauma registry to accurately determine the actual burden of injuries and support a tailored approach to fracture care in Malawi. It is further evident that the health system in Malawi must be strengthen across all six building blocks to address obstacles to equitable access to high-quality fracture care.

A new technology using a customized 3D printed fixator to assist fracture reduction and fixation: Technical note

BACKGROUND

Poor reduction can lead to complications such as deformity and delayed fracture healing. We introduce a 3D printed external fixator technology that can assist in fracture reduction and fixation.

METHODS

A fractured long bone was first fixed by a temporary external fixator and then scanned with computed tomography. Three-dimensional reconstruction of the contour and bone fragments of the affected limb was performed using Mimics software, and the fracture reduction was simulated. Subsequently, data were imported into SolidWorks software for customized external fixator design and 3D printing. Through the precise assembly of the 3D printed external fixator and external fixation pins, automatic fracture reduction.

RESULTS

The patient's fractures were well reduced, firmly fixed, and the postoperative fractures healed well with no complications.

CONCLUSION

The technique we introduce not only assists in fracture reduction for temporary external fixation but can also be used as a definitive treatment for long bone fractures.

Intramedullary Nail Breakage and Mechanical Displacement in Patients with Proximal Femoral Fractures: A Commercial and Medicare Supplemental Claims Database Analysis

Objective

This study evaluated the rates and patterns of intramedullary nail (IMN) breakage and mechanical displacement for proximal femur fractures and the factors associated with their occurrence.

Patients and Methods

Patients with subtrochanteric, intertrochanteric, or basicervical femoral neck fractures treated with IMN from 2016 to 2019 were identified from commercial and Medicare supplemental claims databases and were followed for up to two years. Kaplan–Meier analysis estimated the cumulative incidence of and patterns of breakage/mechanical displacement. Multivariable Cox regression models evaluated the factors associated with breakage/mechanical displacement.

Results

A total of 11,128 patients had IMN fixation for subtrochanteric, intertrochanteric, or basicervical femoral neck fractures: (mean SD) age 75.6 (16.4) years, 66.2% female, 74.3% Medicare supplemental vs 26.7% commercial insurance. Comorbidities included hypertension (62.9%), osteoporosis (27.3%), cardiac arrhythmia (23.1%), diabetes (30.7%), and chronic pulmonary disease (16.3%). Most fractures were closed (97.2%), intertrochanteric or basicervical femoral neck (80.1%), and not pathological (91.0%). The cumulative incidence of nail breakage over two years was 0.66% overall, 1.44% for combination fractures, 1.16% for subtrochanteric fractures, and 0.49% for intertrochanteric or basicervical fractures. The cumulative incidence of mechanical displacement was 0.37% overall, 0.43% for subtrochanteric fractures, 0.42% for combination fractures, and 0.36% for intertrochanteric or basicervical femoral neck fractures. Half of the breakages occurred within five months after surgery and half of the mechanical displacements occurred within 75 days. Age 50–64 (vs 75+) and subtrochanteric or pathological fracture were more commonly associated with nail breakage. Complicated hypertension was more commonly associated with mechanical displacement.

Conclusion

The incidence of IMN breakage and mechanical displacement in US commercial and Medicare supplemental patients with proximal femur fractures from 2016 to 2019 was low (0.66% and 0.37%, respectively up to two years). Age 50–64 (vs 75+) and subtrochanteric or pathological fracture were more commonly associated with breakage. Complicated hypertension was associated with mechanical displacement.