The effects of mineral trioxide aggregate on osteo/odontogenic potential of mesenchymal stem cells: a comprehensive and systematic literature review

Effects of vehicles on the physical properties and biocompatibility of premixed calcium silicate cements

Premixed calcium silicate cements (pCSCs) contain vehicles which endow fluidity and viscosity to CSCs. This study aimed to investigate the effects of three vehicles, namely, polyethylene glycol (PEG), propylene glycol (PG), and dimethyl sulfoxide (DMSO), on the physicochemical properties and biocompatibility of pCSCs. The setting time, solubility, expansion rate, and mechanical strength of the pCSCs were evaluated, and the formation of calcium phosphate precipitates was assessed in phosphate-buffered saline (PBS). The effects of pCSC extracts on the osteogenic differentiation of mesenchymal stem cells (MSCs) were investigated. Finally, the tissue compatibility of pCSCs in rat femurs was observed. CSC containing PEG (CSC-PEG) exhibited higher solubility and setting time, and CSC-DMSO showed the highest expansion rate and mechanical strength. All pCSCs generated calcium phosphate precipitates. The extract of CSC-PG induced the highest expressions of osteogenic markers along with the greatest calcium deposites. When implanted in rat femurs, CSC-PEG was absorbed considerably, whereas CSC-PG remained relatively unaltered inside the femur.

Effect of pulp capping materials on odontogenic differentiation of human dental pulp stem cells: An in vitro study

OBJECTIVES

Migration and differentiation of human dental pulp stem cells (hDPSCs) is a vital and key factor in the success of reparative dentin formation for maintenance of pulp vitality. Pulp capping materials are used to stimulate DPSCs to induce new dentin formation. Thus, the aim of the present study was to compare the response of DPSCs to four commercially available pulp capping materials: a bioactive bioceramic (Material 1), a nonresinous ready-to-use bioceramic cement (Material 2), a bioactive composite (Material 3), and a biocompatible, dual-cured, resin-modified calcium silicate (Material 4).

MATERIALS AND METHODS

hDPSCs were isolated and cultured from freshly extracted teeth and were then characterized by flow cytometry and multilineage differentiation. Discs prepared from pulp capping materials were tested with hDPSCs and MTT (3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide) assay, cell migration assay and odontogenic differentiation assay was performed. Expression of osteogenic markers (osteopontin, RUNX family transcription factor 2, osteocalcin) and the odontogenic marker (dentin sialophosphoprotein) was detected using reverse transcription-polymerase chain reaction.

RESULTS

Materials 1, 2, and 3 generated more cell viability than Material 4. Furthermore, Material 4 showed the least wound exposure percentage, while Material 3 showed the highest percentage. Enhanced mineralization was found in hDSCPs cultured with Material 3, followed by Material 1, and then Material 2, while Material 4 revealed the least calcified mineralization.

CONCLUSIONS

The results of this study were inconclusive regards contemporary bioceramic materials designed for vital pulp therapy as they have different effects on hDPSC. Further testing for cytotoxicity using live-dead staining, animal experiments, clinical trials, and independent analyses of these biomaterials is necessary for clinicians to make an informed decision for their use.

Evaluation of the genotoxicity, cytotoxicity, and bioactivity of calcium silicate-based cements

BACKGROUND

As calcium silicate-based cements (CSCs) have found success in various vital pulp therapy applications, several new CSC products have emerged. This study aimed to assess the genotoxicity, cytotoxicity, and bioactivity of four CSCs by comparing the newly introduced materials Bio MTA+ and MTA Cem with previously studied materials, Biodentine and NeoMTA.

METHODS

Genotoxicity was evaluated using the micronucleus (MN) assay in human peripheral blood lymphocyte cells, measuring MN frequency and nuclear division index (NDI). Cytotoxicity was assessed in human dental pulp stem cells through the Water-Soluble Tetrazolium Salt-1 (WST-1) colorimetric assay. Bioactivity was determined by ELISA, measuring the levels of angiogenic and odontogenic markers (BMP-2, FGF-2, VEGF, and ALP). Statistical analyses included ANOVA, Dunnet and Sidak tests, and Wald chi-square test. (p < .05).

RESULTS

The MN frequency in the groups was significantly lower than that in the positive control group (tetraconazole) (p < .05). NDI values decreased with increasing concentration (p < .05). Bio MTA+ and NeoMTA showed decreased cell viability at all concentrations in 7-day cultures (p < .01). All materials increased BMP-2, FGF-2, and VEGF levels, with Biodentine and NeoMTA showing the highest levels of BMP-2 and FGF-2 on day 7. Biodentine displayed the highest VEGF levels on day 7. Biodentine and NeoMTA groups exhibited significantly higher ALP activity than the Bio MTA+ and MTA Cem groups by day 7.

CONCLUSION

Bio MTA+ and MTA Cem demonstrated no genotoxic or cytotoxic effects. Moreover, this study revealed bioactive potentials of Bio MTA+ and MTA Cem by enhancing the expression of angiogenic and osteogenic growth factors.

Influence of strontium containing fluorophosphate glass onto structural and mechanical behavior of MTA network

OBJECTIVE

This study aimed to evaluate the effect of incorporation of strontium based fluoro phosphate glass (SrFPG) 48P₂O₅-29CaO-14NaO-3CaF₂-6SrO on physico chemical and biological properties of mineral trioxide aggregate (MTA).

METHODS

Optimized SrFPG glass powder were prepared using planetary ball mill and incorporated into MTA in varying proportion (1, 5, 10 wt%) to obtain SrMT1, SrMT5, SrMT10 bio-composite respectively. The bio-composites were characterized using XRD, FTIR and SEM-EDAX before and after soaking for 28 days in stimulated body fluid (SBF) solution. To assess the mechanical properties and biocompatibility of the prepared bio-composite, density, pH analysis, compressive strength and cytotoxicity evaluation using MTT assay were done before and after soaking for 28 days in SBF solution.

RESULTS

A nonlinear variation in compressive strength and pH values was noted. Of the bio-composites, SrMT10 was evidenced with rich apatite formation in XRD, FTIR and SEM with EDAX analysis. MTT assay showed increased cell viability in all the samples before and after in vitro studies.

Photobiomodulation therapy does not depend on the differentiation of dental pulp cells to enhance functional activity associated with angiogenesis and mineralization

The purpose of this study is to analyze the influence of InGaAlP diode laser (660 nm) with or without an odontogenic medium (OM) in the functional activity of OD-21 cells. Undifferentiated OD-21 pulp cells were cultivated with or without OM and divided into four groups (n = 5): nonirradiated control (C -), nonirradiated + OM (C +), irradiated (L -), and irradiated + OM (L +). Laser application was performed in two sessions of a 24-h interval with an irradiance of 11.3 mW/cm2, energy density of 1 J/cm², and total cumulative energy/well of 4.6 J. Cell proliferation, VEGF-164 expression, mineralization, and expression of Alp, Runx2, and Dmp1 genes, as well as immunolocalization of RUNX2 and MEPE proteins, were evaluated. Data were analyzed by statistical tests (α = 0.05). All studied groups showed a similar increase in cell proliferation with or without OM. After 7 and 10 days, a significatively higher concentration of VEGF-164 in L - group when compared to C - group was observed. A significant increase in mineralized nodules in the L + was noted when compared to C + in the same conditions. Photobiomodulation upregulated significantly Runx2 and Dmp1 expression after 10 days in L - and after 7 days in L + , with downregulation of Dmp1 after 10 days in L + group. Immunolocalization of RUNX2 and MEPE was expressive after 7 days of culture in the cytoplasm adjacent to the nucleus with a decrease after 10 days, regardless of the presence of OM. Photobiomodulation enhances metabolism associated with angiogenesis, gene expression, and mineralization regardless of the odontogenic medium in OD-21 cells.

MTA Enhances the Potential of Adipose-Derived Mesenchymal Stem Cells for Dentin-Pulp Complex Regeneration

The aim of the current study was to investigate the effects of mineral trioxide aggregate (MTA) on the proliferation and differentiation of human adipose-derived mesenchymal stem cells (Ad-MSCs) as a surrogate cell source in futuristic stem-cell-based endodontic therapies. Human Ad-MSCs and mesenchymal stem cells derived from bone marrow (BM-MSCs) were isolated from liposuction waste adipose tissue and femur, respectively, and the effects of MTA-conditioned media on their viability, mineralization potential, and osteo/odontogenic differentiation capacity were subsequently evaluated. Alkaline phosphatase (ALP) activity, quantitative alizarin red S staining, and quantitative reverse transcription-polymerase chain reaction (qRT-PCR) analyses were performed to investigate and compare the osteo/odontogenic induction potential of MTA on the Ad/BM-MSCs. The results of cytotoxicity assay revealed that at different concentrations, MTA-conditioned medium was not only biocompatible toward both cell types, but also capable of promoting cell proliferation. ALP activity assay showed that 0.2 mg/mL was the optimal concentration of MTA-conditioned medium for osteo/odontogenic induction in Ad/BM-MSCs. The expression of osteo/odontogenic gene markers was increased in Ad/BM-MSCs treated with 0.2 mg/mL MTA-conditioned media. Our results indicated that MTA can efficiently enhance the osteo/odontogenic potential of Ad-MSCs, and thus they can be considered as a better cell source for dentin-pulp complex regeneration. However, further investigations are required to test these potentials in animal models.