Simulated lesion, human observer performance comparison between thin-section dedicated breast CT images versus computed thick-section simulated projection images of the breast

Utilization of an attentive map to preserve anatomical features for training convolutional neural-network-based low-dose CT denoiser

BACKGROUND

The purpose of a convolutional neural network (CNN)-based denoiser is to increase the diagnostic accuracy of low-dose computed tomography (LDCT) imaging. To increase diagnostic accuracy, there is a need for a method that reflects the features related to diagnosis during the denoising process.

PURPOSE

To provide a training strategy for LDCT denoisers that relies more on diagnostic task-related features to improve diagnostic accuracy.

METHODS

An attentive map derived from a lesion classifier (i.e., determining lesion-present or not) is created to represent the extent to which each pixel influences the decision by the lesion classifier. This is used as a weight to emphasize important parts of the image. The proposed training method consists of two steps. In the first one, the initial parameters of the CNN denoiser are trained using LDCT and normal-dose CT image pairs via supervised learning. In the second one, the learned parameters are readjusted using the attentive map to restore the fine details of the image.

RESULTS

Structural details and the contrast are better preserved in images generated by using the denoiser trained via the proposed method than in those generated by conventional denoisers. The proposed denoiser also yields higher lesion detectability and localization accuracy than conventional denoisers.

CONCLUSIONS

A denoiser trained using the proposed method preserves the small structures and the contrast in the denoised images better than without it. Specifically, using the attentive map improves the lesion detectability and localization accuracy of the denoiser.

High-resolution μ CT imaging for characterizing microcalcification detection performance in breast CT

Purpose: To demonstrate the utility of high-resolution micro-computed tomography ( μ CT ) for determining ground-truth size and shape properties of calcium grains for evaluation of detection performance in breast CT (bCT). Approach: Calcium carbonate grains ( ∼ 200    μ m ) were suspended in 1% agar solution to emulate microcalcifications ( μ Calcs ) within a fibroglandular tissue background. Ground-truth imaging was performed on a commercial μ CT scanner and was used for assessing calcium-grain size and shape, and for generating μ Calc signal profiles. Calcium grains were placed within a realistic breast-shaped phantom and imaged on a prototype bCT system at 3- and 6-mGy mean glandular dose (MGD) levels, and the non-prewhitening detectability was assessed. Additionally, the μ CT -derived signal profiles were used in conjunction with the bCT system characterization (MTF and NPS) to obtain predictions of bCT detectability. Results: Estimated detectability of the calcium grains on the bCT system ranged from 2.5 to 10.6 for 3 mGy and from 3.8 to 15.3 for 6 mGy with large fractions of the grains meeting the Rose criterion for visibility. Segmentation of μ CT images based on morphological operations produced accurate results in terms of segmentation boundaries and segmented region size. A regression model linking bCT detectability to μ Calc parameters indicated significant effects of μ Calc size and vertical position within the breast phantom. Detectability using μ CT -derived detection templates and bCT statistical properties (MTF and NPS) were in good correspondence with those measured directly from bCT ( R 2 > 0.88 ). Conclusions: Parameters derived from μ CT ground-truth data were shown to produce useful characterizations of detectability when compared to estimates derived directly from bCT. Signal profiles derived from μ CT imaging can be used in conjunction with measured or hypothesized statistical properties to evaluate the performance of a system, or system component, that may not currently be available.

Optical conductivity of triple point fermions

As a low-energy effective theory on non-symmorphic lattices, we consider a generic triple point fermion Hamiltonian, which is parameterized by an angular parameterλ. We find strongλdependence in both Drude and interband optical absorption of these systems. The deviation of theT2coefficient of the Drude weight from Dirac/Weyl fermions can be used as a quick way to optically distinguish the triple point degeneracies from the Dirac/Weyl degeneracies. At the particularλ=π/6 point, we find that the 'helicity' reversal optical transition matrix element is identically zero. Nevertheless, deviating from this point, the helicity reversal emerges as an absorption channel.

Sparse-view, short-scan, dedicated cone-beam breast computed tomography: image quality assessment

The purpose of this study is to quantify the impact of sparse-view acquisition in short-scan trajectories, compared to 360-degrees full-scan acquisition, on image quality measures in dedicated cone-beam breast computed tomography (BCT). Projection data from 30 full-scan (360-degrees; 300 views) BCT exams with calcified lesions were selected from an existing clinical research database. Feldkamp-Davis-Kress (FDK) reconstruction of the full-scan data served as the reference. Projection data corresponding to two short-scan trajectories, 204 and 270-degrees, which correspond to the minimum and maximum angular range achievable in a cone-beam BCT system were selected. Projection data were retrospectively sampled to provide 225, 180, and 168 views for 270-degrees short-scan, and 170 views for 204-degrees short-scan. Short-scans with 180 and 168 views in 270-degrees used non-uniform angular sampling. A fast, iterative, total variation-regularized, statistical reconstruction technique (FIRST) was used for short-scan image reconstruction. Image quality was quantified by variance, signal-difference to noise ratio (SDNR) between adipose and fibroglandular tissues, full-width at half-maximum (FWHM) of calcifications in two orthogonal directions, as well as, bias and root-mean-squared-error (RMSE) computed with respect to the reference full-scan FDK reconstruction. The median values of bias (8.6 × 10-4-10.3 × 10-4cm-1) and RMSE (6.8 × 10-6-9.8 × 10-6cm-1) in the short-scan reconstructions, computed with the full-scan FDK as the reference were close to, but not zero (P < 0.0001, one-sample median test). The FWHM of the calcifications in the short-scan reconstructions did not differ significantly from the reference FDK reconstruction (P > 0.118), except along the superior-inferior direction for the short-scan reconstruction with 168 views in 270-degrees (P = 0.046). The variance and SDNR from short-scan reconstructions were significantly improved compared to the full-scan FDK reconstruction (P < 0.0001). This study demonstrates the feasibility of the short-scan, sparse-view, compressed sensing-based iterative reconstruction. This study indicates that shorter scan times and reduced radiation dose without sacrificing image quality are potentially feasible.

Visual adaptation and the amplitude spectra of radiological images

We examined how visual sensitivity and perception are affected by adaptation to the characteristic amplitude spectra of X-ray mammography images. Because of the transmissive nature of X-ray photons, these images have relatively more low-frequency variability than natural images, a difference that is captured by a steeper slope of the amplitude spectrum (~ − 1.5) compared to the ~ 1/f (slope of − 1) spectra common to natural scenes. Radiologists inspecting these images are therefore exposed to a different balance of spectral components, and we measured how this exposure might alter spatial vision. Observers (who were not radiologists) were adapted to images of normal mammograms or the same images sharpened by filtering the amplitude spectra to shallower slopes. Prior adaptation to the original mammograms significantly biased judgments of image focus relative to the sharpened images, demonstrating that the images are sufficient to induce substantial after-effects. The adaptation also induced strong losses in threshold contrast sensitivity that were selective for lower spatial frequencies, though these losses were very similar to the threshold changes induced by the sharpened images. Visual search for targets (Gaussian blobs) added to the images was also not differentially affected by adaptation to the original or sharper images. These results complement our previous studies examining how observers adapt to the textural properties or phase spectra of mammograms. Like the phase spectrum, adaptation to the amplitude spectrum of mammograms alters spatial sensitivity and visual judgments about the images. However, unlike the phase spectrum, adaptation to the amplitude spectra did not confer a selective performance advantage relative to more natural spectra.

Effect of anatomical noise on the detectability of cone beam CT images with different slice direction, slice thickness, and volume glandular fraction

We investigate the effect of anatomical noise on the detectability of cone beam CT (CBCT) images with different slice directions, slice thicknesses, and volume glandular fractions (VGFs). Anatomical noise is generated using a power law spectrum of breast anatomy, and spherical objects with diameters from 1mm to 11mm are used as breast masses. CBCT projection images are simulated and reconstructed using the FDK algorithm. A channelized Hotelling observer (CHO) with Laguerre-Gauss (LG) channels is used to evaluate detectability for the signal-known-exactly (SKE) binary detection task. Detectability is calculated for various slice thicknesses in the transverse and longitudinal planes for 15%, 30% and 60% VGFs. The optimal slice thicknesses that maximize the detectability of the objects are determined. The results show that the β value increases as the slice thickness increases, but that thicker slices yield higher detectability in the transverse and longitudinal planes, except for the case of a 1mm diameter spherical object. It is also shown that the longitudinal plane with a 0.1mm slice thickness provides higher detectability than the transverse plane, despite its higher β value. With optimal slice thicknesses, the longitudinal plane exhibits better detectability for all VGFs and spherical objects.