The effect of normal load on polytetrafluoroethylene tribology

A Polytetrafluoroethylene-Based Solvent-Free Procedure for the Manufacturing of Lithium-Ion Batteries

Lithium-ion batteries (LIBs) have recently become popular for energy storage due to their high energy density, storage capacity, and long-term cycle life. Although binders make up only a small proportion of LIBs, they have become the key to promoting the transformation of the battery preparation process. Along with the development of binders, the battery manufacturing process has evolved from the conventional slurry-casting (SC) process to a more attractive solvent-free (SF) method. Compared with traditional LIBs manufacturing method, the SF method could dramatically reduce and increase the energy density due to the reduced preparation steps and enhanced electrode loading. Polytetrafluoroethylene (PTFE), as a typical binder, has played an important role in fabricating high-performance LIBs, particularly in regards to the SF technique. In this paper, the development history and application status of PTFE binder was introduced, and then its contributions and the inherent problems involved in the SF process were described and analyzed. Finally, the viewpoints concerning the future trends for PTFE-based SF manufacturing methods were also discussed. We hope this work can inspire future research concerning high-quality SF binders and assist in promoting the evolution of the SF manufacturing technology in regards to LIBs.

Tribochemistry: A Review of Reactive Molecular Dynamics Simulations

Tribochemistry, the study of chemical reactions in tribological interfaces, plays a critical role in determining friction and wear behavior. One method researchers have used to explore tribochemistry is “reactive” molecular dynamics simulation based on empirical models that capture the formation and breaking of chemical bonds. This review summarizes studies that have been performed using reactive molecular dynamics simulations of chemical reactions in sliding contacts. Topics include shear-driven reactions between and within solid surfaces, between solid surfaces and lubricating fluids, and within lubricating fluids. The review concludes with a perspective on the contributions of reactive molecular dynamics simulations to the current understanding of tribochemistry, as well as opportunities for this approach going forward.

Temperature control in molecular dynamic simulations of non-equilibrium processes

Thermostats are often used in various condensed matter problems, e.g. when a biological molecule undergoes a transformation in a solution, a crystal surface is irradiated with energetic particles, a crack propagates in a solid upon applied stress, two surfaces slide with respect to each other, an excited local phonon dissipates its energy into a crystal bulk, and so on. In all of these problems, as well as in many others, there is an energy transfer between different local parts of the entire system kept at a constant temperature. Very often, when modelling such processes using molecular dynamics simulations, thermostatting is done using strictly equilibrium approaches serving to describe the NVT ensemble. In this paper we critically discuss the applicability of such approaches to non-equilibrium problems, including those mentioned above, and stress that the correct temperature control can only be achieved if the method is based on the generalized Langevin equation (GLE). Specifically, we emphasize that a meaningful compromise between computational efficiency and a physically appropriate implementation of the NVT thermostat can be achieved, at least for solid state and surface problems, if the so-called stochastic boundary conditions (SBC), recently derived from the GLE (Kantorovich and Rompotis 2008 Phys. Rev. B 78 094305), are used. For SBC, the Langevin thermostat is only applied to the outer part of the simulated fragment of the entire system which borders the surrounding environment (not considered explicitly) serving as a heat bath. This point is illustrated by comparing the performance of the SBC and some of the equilibrium thermostats in two problems: (i) irradiation of the Si(001) surface with an energetic CaF(2) molecule using an ab initio density functional theory based method, and (ii) the tribology of two amorphous SiO(2) surfaces coated with self-assembled monolayers of methyl-terminated hydrocarbon alkoxylsilane molecules using a classical atomistic force field. We discuss the differences in behaviour of these systems due to applied thermostatting, and show that in some cases a qualitatively different physical behaviour of the simulated system can be obtained if an equilibrium thermostat is used.