Clove oil nanoemulsion showed potent inhibitory effect against Candida spp

Nanoemulsions of Clove Oil Stabilized with Chitosan Oleate-Antioxidant and Wound-Healing Activity

Clove oil (CO) is a powerful antioxidant essential oil (EO) with anti-inflammatory, anesthetic, and anti-infective properties. It can be therefore considered a good candidate for wound-healing applications, especially for chronic or diabetic wounds or burns, where the balance of reactive oxygen species (ROS) production and detoxification is altered. However, EOs require suitable formulations to be efficiently administered in moist wound environments. Chitosan hydrophobically modified by an ionic interaction with oleic acid (chitosan oleate, CSO) was used in the present work to stabilize CO nanoemulsions (NEs). The dimensions of the NE were maintained at around 300 nm as the volume distribution for up to six months, and the CO content did not decrease to under 80% over 4 months, confirming the good stabilizing properties of CSO. The antioxidant properties of the CO NE were evaluated in vitro by a 2,2-diphenil-2-picrylhydrazyl hydrate (DPPH) assay, and in fibroblast cell lines by electron paramagnetic resonance (EPR) using α-phenyl-N-tert-butyl nitrone (PBN) as a spin trap; a protective effect was obtained comparable to that obtained with α-tocopherol treatment. In a murine burn model, the ability of CO formulations to favor macroscopic wound closure was evidenced, and a histological analysis revealed a positive effect of the CO NE on the reparation of the lesion after 18 days. Samples of wounds at 7 days were subjected to a histological analysis and parallel dosage of lipid peroxidation by means of a thiobarbituric acid-reactive substances (TBARS) assay, confirming the antioxidant and anti-inflammatory activity of the CO NE.

Exploration of a W/O Nanoemulsion for Antibiofilm Activity against Cariogenic Enterococcus faecalis

A ciprofloxacin-loaded water-in-oil nanoemulsion (CPX-NE) was prepared and evaluated for the antimicrobial effect against oral biofilms produced by Enterococcus faecalis. CPX-NE was prepared by ultrasonication using functional excipients oleic acid (oil phase), Span 80 (surfactant), and Transcutol P (cosurfactant). Rheological parameters (viscosity = 20 ± 1.24 cp) confirmed optimum values for CPX-NE, a pH of 6.5 ± 0.23 suggested the simulation of CPX-NE with the pH of the mouth cavity, refractive index (1.46 ± 0.22), and % transmittance (92.34 ± 0.02) indicated the isotropic nature of the NE. The droplet size (72.19 ± 1.68 nm), polydispersity index (0.142 ± 0.02), and ζ potential (-28 mV) demonstrated a narrow size distribution and electrostatically stabilized NE. The morphology of the optimized formulation showed uniform spherical nanodroplets, as seen in fluorescence microscopy. In vitro drug release showed an initial burst effect followed by sustained release for 48 h, following Fick's diffusion. The minimum biofilm inhibitory and eradication concentration (MBIC/MBEC) was determined to compare CPX-NE with ciprofloxacin plain drug solution (CPX-PS) for their efficacy. CPX-NE demonstrated a significant inhibitory and eradication effect compared to CPX-PS. It was concluded that the developed CPX-NE has effective antibiofilm activity against E. faecalis and may be useful in the prevention and treatment of dental caries.

In Vitro and In Vivo Evaluation of a Nano-Tool Appended Oilmix (Clove and Tea Tree Oil) Thermosensitive Gel for Vaginal Candidiasis

The main objective of the proposed work was the development of a thermosensitive gel (containing clove and tea tree oil) for the management of vaginal candidiasis. Both oils have been recommended to be used separately in a topical formulation for vaginal candidiasis. Incorporating two natural ingredients (clove and tea tree oil) into a product give it a broad antimicrobial spectrum and analgesic properties. The two oils were mixed together at a 3:1 ratio and converted into o/w nanoemulsion using the aqueous titration method and plotting pseudo ternary phase diagrams. Further transformations resulted in a gel with thermosensitive properties. To determine the final formulation's potential for further clinical investigation, in vitro analyses (viscosity measurement, MTT assay, mucoadhesion, ex vivo permeation) and in vivo studies (fungal clearance kinetics in an animal model) were conducted. The current effort leveraged the potential of tea tree and clove oils as formulation ingredients and natural therapeutic agents for vaginal infections. Its synergy generated a stable and effective thermosensitive gel that can be utilized for recurrent candidiasis and other infections.

Antifungal Polymeric Materials and Nanocomposites

Rising global populations due to medicinal advancements increases the patient population susceptible to superficial and severe fungal infections. Fungi often implicated in these diseases includes the dermatophytes (Microsporum spp., Epidermophtyon spp., Trichophyton spp.) as well as species of the Candida spp., Aspergillosis spp. and Cryptococcus spp. genera. In addition, increasing global populations leads to increasing agricultural demands. Thus, fungal infections of preharvested crops and stored food by plant pathogens such as Magnaporthe oryzae and Fusarium oxysporum can have detrimental socioeconomic effects due to food insecurity. Current antifungal strategies are based mainly on small molecule antifungal drugs. However, these drugs are limited by poor solubility and bioavailability. Furthermore, antifungal resistance against these drugs are on the rise. Thus, antimicrobial polymers offer an alternative antifungal strategy. Antifungal polymers are characterised by cationic and hydrophobic regions where the cationic regions have been shown to interact with microbial phospholipids and membranes. These polymers can be synthetic or natural and demonstrate distinct antifungal mechanisms ranging from fungal cell membrane permeabilisation, cell membrane depolarisation or cell entry. Although the relative importance of such mechanisms is difficult to decipher. Due to the chemical properties of these polymers, they can be combined with other antimicrobial compounds including existing antifungal drugs, charcoals, lipids and metal ions to elicit synergistic effects. In some cases, antifungal polymers and nanocomposites show better antifungal effects or reduced toxicity compared to the widely used small molecule antifungal drugs. This review provides an overview of antimicrobial polymers and nanocomposites with antifungal activity and the current understanding of their antifungal mechanisms.

Croton cajucara Essential Oil Nanoemulsion and Its Antifungal Activities

The purpose of this study was to develop a stable nanoemulsion (NE) containing Croton cajucara 7-hydroxycalamenene-rich essential oil (NECC) with antifungal activity. The NECCs were prepared using an ultrasonic processor with Pluronic® F-127 as the aqueous phase. In order to evaluate the NECCs, the droplet size, polydispersity index (PdI), percentage of emulsification, and pH were determined along with a stability study. The NECC selected for the study had 15% surfactant, showed 100% emulsification, Pdl of 0.249, neutral pH, droplet diameters of about 40 nm, and remained stable over 150 days at room temperature. In addition, the NECC activity against some species of Zygomycetes and Candida, as well as the potential to inhibit fungal extracellular proteases, were assessed, and, finally, the hemolytic activity was evaluated. The best NECC antifungal activities were against Mucorramosissimus (Minimal inhibitory concentration (MIC) = 12.2 μg/mL) and Candida albicans (MIC = 25.6 μg/mL). The highest extracellular protease activities of M. ramosissimus and C. albicans were detected at pH 3 and 4, respectively, which were totally inhibited after NECC treatment. The NECC showed no hemolytic effect at the highest concentration tested (2 mg/mL).

Striking Back against Fungal Infections: The Utilization of Nanosystems for Antifungal Strategies

Fungal infections have become a major health concern, given that invasive infections by Candida, Cryptococcus, and Aspergillus species have led to millions of mortalities. Conventional antifungal drugs including polyenes, echinocandins, azoles, allylamins, and antimetabolites have been used for decades, but their limitations include off-target toxicity, drug-resistance, poor water solubility, low bioavailability, and weak tissue penetration, which cannot be ignored. These drawbacks have led to the emergence of novel antifungal therapies. In this review, we discuss the nanosystems that are currently utilized for drug delivery and the application of antifungal therapies.

Recent Advances in Nanomaterials for Dermal and Transdermal Applications

The stratum corneum, the most superficial layer of the skin, protects the body against environmental hazards and presents a highly selective barrier for the passage of drugs and cosmetic products deeper into the skin and across the skin. Nanomaterials can effectively increase the permeation of active molecules across the stratum corneum and enable their penetration into deeper skin layers, often by interacting with the skin and creating the distinct sites with elevated local concentration, acting as reservoirs. The flux of the molecules from these reservoirs can be either limited to the underlying skin layers (for topical drug and cosmeceutical delivery) or extended across all the sublayers of the epidermis to the blood vessels of the dermis (for transdermal delivery). The type of the nanocarrier and the physicochemical nature of the active substance are among the factors that determine the final skin permeation pattern and the stability of the penetrant in the cutaneous environment. The most widely employed types of nanomaterials for dermal and transdermal applications include solid lipid nanoparticles, nanovesicular carriers, microemulsions, nanoemulsions, and polymeric nanoparticles. The recent advances in the area of nanomaterial-assisted dermal and transdermal delivery are highlighted in this review.

Development, characterization and photobiological activity of nanoemulsion containing zinc phthalocyanine for oral infections treatment

Nanotechnology, when applied to PDT's, allows the encapsulation of ZnPc in nanocarriers, producing thus nanoemulsions that permit the use of ZnPc as photosensitizers. The Enterococcus faecalis and methicillin-resistant Staphylococcus aureus (MRSA) are microorganisms present in biofilms which can cause resistant endodontic infections. The objective of this work is the development and characterization of clove essential oil nanoemulsions containing ZnPc. The formulations were developed according to factorial experimental planning and characterized by the determination of the mean drop size, Polydispersity Index (PdI), content, organoleptic characteristics, stability, morphology, cytotoxicity in the dark and evaluation of the photobiological activity. The experimental planning was able to indicate the maximum amount of ZnPc that could be encapsulated in the nanoemulsion while maintaining droplet size <50 nm and PdI < 0.2. The surface plots for the response variables indicated a robust region for the combination of Pluronic® F-127 and clove oil factors. The result of this study was the choice of the nanoemulsion containing ZnPc solution at 5%, clove oil at 5%, Pluronic® F-127 at 10% and will be codified as ZnPc-NE. The nanoemulsion presented a mean diameter of 30.52 nm, PDI < 0.2 and a concentration of 17.5 μg/mL, as well as stability at room temperature for 180 days. TEM showed that the drops are spherical with nanometric size, which corroborates the results of dynamic light scattering. Concerning the photobiological activity, the ZnPc-NE exhibited MIC 1.09 μg/mL for Enterococcus faecalis and 0.065 μg/mL for MRSA (Methicillin-resistant Staphylococcus aureus). ZnPc-NE showed higher photobiological activity than free ZnPc. Besides, cytotoxicity studies showed that blank-NE (nanoemulsions without PS) showed good antimicrobial activity. Thus, clove oil nanoemulsion is an excellent nanocarrier to promote the photobiological activity of the ZnPc against pathogenic microorganisms.

Nanosystems against candidiasis: a review of studies performed over the last two decades

The crescent number of cases of candidiasis and the increase in the number of infections developed by non-albicans species and by multi-resistant strains has taken the attention of the scientific community, which has been searching for new therapeutic alternatives. Among the alternatives found the use of nanosystems for delivery of drugs already commercialized and new biomolecules have grown, in order to increase stability, solubility, optimize efficiency and reduce adverse effects. In view of the growing number of studies involving technological alternatives for the treatment of candidiasis, the present review came with the intention of gathering studies from the last two decades that used nanotechnology for the treatment of candidiasis, as well as analysing them critically and pointing out the future perspectives for their application with this purpose. Different studies were considered for the development of this review, addressing nanosystems such as metallic nanoparticles, mesoporous silica nanoparticles, polymeric nanoparticles, liposomes, nanoemulsion, microemulsion, solid lipid nanoparticle, nanostructured lipid carrier, lipidic nanocapsules and liquid crystals; and different clinical presentations of candidiasis. As a general overview, nanotechnology has proven to be an important ally for the treatment against the diversity of candidiasis found in the clinic, whether in increasing the effectiveness of commercialized drugs and reducing their adverse effects, as well as allowing exploring more effectively properties therapeutics of new biomolecules.