Detection of Tinuvin 770, A Light Stabilizer of Plastic Materials from Dialysis Membranes, by High-Performance Liquid Chromatographic Analysis

Hemodynamic Effects of the Light Stabilizer Tinuvin 770 in Dogs In Vivo

Introduction

Tinuvin 770 [bis(2,2,6,6-tetramethyl-4-piperidinyl) sebacate, Ciba-Geigy, Basel, Switzerland] is a UV light stabilizer that is a component of many plastic materials used world-wide in the medical and food industries. We report on the acute hemodynamic effects of Tinuvin 770 examined in dogs.

Materials and Methods

Tinuvin 770 was dissolved in a mixture of saline and ethanol (1:1 v/v) and was administered to 12 intravenously narcotized and respirated dogs in increasing doses (T1-T7: 1, 3.3, 6.6, 10, 33.3, 66.6 and 100 mg, respectively). The doses were given as bolus injections over a three minute period, and the effects were recorded for 12 minutes. The vehicle was used as a control. Hemodynamic parameters (heart rate, blood pressure, end-diastolic pressure, dp/dt, cardiac output) and ECG were monitored continously.

Results

At doses T1-T4, systolic and diastolic blood pressures, mean pressure and ventricular contractility were significantly decreased without significant changes in cardiac output, heart rate, or PQ interval. At doses T5 and T6, declines in blood pressure and myocardial contractility were observed. At doses T6 and T7, heart rate and PQ interval decreased substantially. Irreversible circulatory failure occured in one dog after administering dose T6 and in 8 dogs following dose T7.

Conclusion

Tinuvin 770 induces acute hemodynamic alterations. In lower doses, it causes peripheral vasodilatation, however at higher doses acute cardiac failure occured. Plastics containing Tinuvin 770 should be used with care in medical practice and the laboratory.

Advances in the determination of hindered amine light stabilizers - A review

Within this paper we discuss analytical strategies for the characterization and quantitation of hindered amine light stabilizers (HALS) an important sub-group of polymer additives. For the determination of monomeric HALS a range of mature and reliable techniques exists, allowing their determination in polymer extracts. If qualitative or semi-quantitative information suffices, certain techniques are capable of sampling directly from the polymer surface with limited or no sample preparation. Different strategies for the determination of complex oligomeric HALS in extracts from polymer samples are discussed. Here, approaches providing only a sum parameter including all HALS oligomers have been distinguished from more sophisticated technologies allowing the determination of single oligomers, their degradation and by-products. Particularly, the latter issue is facing increased interest as it provides important information for polymers aging studies. A tabulated overview provides comprehensive information on different analytical techniques suitable for HALS determination.

Determination of polyolefin additives by reversed-phase liquid chromatography

This article examines the contribution of liquid chromatography to the study of polyolefin additives commonly used to obtain improved environmental resistance (antioxidants, ultraviolet light stabilizers, antistatics, and so on) and appearance enhancements (e.g. colorants). Several reversed-phase liquid chromatographic methods are summarized, and a detailed description of different detectors is provided. In addition, ways of applying these methods to analyse food contact materials and plastic toys are emphasized. Finally, the potential use of these methods is addressed which complies with European health safety regulations.