TENORM aerosols in the Florida phosphate industry--assessment of lung fluid solubility and annual effective dose to workers

A novel two-step sequential bioaccessibility test for potentially toxic elements in inhaled particulate matter transported into the gastrointestinal tract by mucociliary clearance

A novel two-step sequential extraction has been developed to assess the bioaccessibility of As, Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn in airborne particulate matter following inhalation and transport into the human gastrointestinal tract by mucociliary clearance. A new artificial mucus fluid (AMF) was used to determine the bioaccessible potentially toxic element (PTE) fraction in the upper airways, in sequence with the simplified bioaccessibility extraction test (SBET) or the stomach phase of the unified bioaccessibility method (gastric fluid only) (UBMG). Filter dynamic measurement system TX40 filters smeared with soil reference material (BGS RM 102) were used as test samples. Analysis was performed by ICP-MS. Comparison between results obtained for soil alone and when the soil was supported on TX40 filters indicated that the presence of the substrate did not affect the extraction efficiency, although a large Zn blank was detected. The sequential AMF→SBET extraction liberated similar amounts of Fe, Mn, Ni and Zn to the SBET alone; but significantly less Cd; and significantly more As, Cr, Cu and Pb. The sequential AMF→UBMG extraction liberated similar amounts of Cd, Cr, Mn and Zn to the UBMG alone, but significantly less As, Fe and Ni; and significantly more Cu and Pb. Enhanced extractability was due to the greater quantities of exchangeable ions and complexing agents present. Adoption of a two-step sequential extraction (AMF followed by either the SBET or the UBMG) is recommended because it is more representative of biological conditions and avoids overestimation or underestimation of bioaccessible PTE concentrations.

Graphical Abstract

Radionuclides, trace elements, and radium residence in phosphogypsum of Jordan

Voluminous stockpiles of phosphogypsum (PG) generated during the wet process production of phosphoric acid are stored at many sites around the world and pose problems for their safe storage, disposal, or utilization. A major concern is the elevated concentration of long-lived (226)Ra (half-life = 1,600 years) inherited from the processed phosphate rock. Knowledge of the abundance and mode-of-occurrence of radium (Ra) in PG is critical for accurate prediction of Ra leachability and radon (Rn) emanation, and for prediction of radiation-exposure pathways to workers and to the public. The mean (±SD) of (226)Ra concentrations in ten samples of Jordan PG is 601 ± 98 Bq/kg, which falls near the midrange of values reported for PG samples collected worldwide. Jordan PG generally shows no analytically significant enrichment (<10%) of (226)Ra in the finer (<53 μm) grain size fraction. Phosphogypsum samples collected from two industrial sites with different sources of phosphate rock feedstock show consistent differences in concentration of (226)Ra and rare earth elements, and also consistent trends of enrichment in these elements with increasing age of PG. Water-insoluble residues from Jordan PG constitute <10% of PG mass but contain 30-65% of the (226)Ra. (226)Ra correlates closely with Ba in the water-insoluble residues. Uniformly tiny (<10 μm) grains of barite (barium sulfate) observed with scanning electron microscopy have crystal morphologies that indicate their formation during the wet process. Barite is a well-documented and efficient scavenger of Ra from solution and is also very insoluble in water and mineral acids. Radium-bearing barite in PG influences the environmental mobility of radium and the radiation-exposure pathways near PG stockpiles.