Changing from image intensifier to flat detector technology for interventional cardiology procedures: a practical point of view

Radiation exposure of the operator during cardiac catheter ablation procedures

Radiation exposure of the operator during cardiac catheter ablation procedures was assessed for an experienced cardiologist adopting various measures of radiation protection and utilised electroanatomic navigation. Chip thermoluminescent dosemeters were placed at the eyes, chest, wrists and legs of the operator. The ranges of fluoroscopy time and air kerma area product values associated with cardiac ablation procedures were wide (6.3-48.3 min and 1.7-80.3 Gy cm(2), respectively). The measured median radiation doses per procedure for each monitored position were 23.6 and 21.3 μSv to the left and right wrists, respectively, 25.3 and 30.4 μSv to the left and right legs, respectively. The doses to the eyes were below the minimum detectable dose of 9 μSv. The estimated median effective dose was 22.5 μSv. Considering the actual workload of the operator, the calculated annual doses to the hands, legs and eyes, as well as the annual effective dose, were all below the corresponding limits. The findings of this study indicate that cardiac ablation procedures performed at a modern laboratory do not impose a high radiation hazard to the operator when radiation protection measures are routinely adopted.

An audit of diagnostic reference levels in interventional cardiology and radiology: are there differences between academic and non-academic centres?

A wide variation in patient exposure has been observed in interventional radiology and cardiology. The purpose of this study was to investigate the patient dose from fluoroscopy-guided procedures performed in non-academic centres when compared with academic centres. Four procedures (coronary angiography, percutaneous coronary intervention, angiography of the lower limbs and percutaneous transluminal angioplasty of the lower limbs) were evaluated. Data on the dose-area product, fluoroscopy time and number of images for 1000 procedures were obtained from 23 non-academic centres and compared with data from 5 academic centres. No differences were found for cardiology procedures performed in non-academic centres versus academic ones. However, significantly lower doses were delivered to patients for procedures of the lower limbs when they were performed in non-academic centres. This may be due to more complex procedures performed in the academic centres. Comparison between the centres showed a great variation in the patient dose for these lower limb procedures.

Increases in patient doses need to be avoided when upgrading interventional cardiology systems to flat detectors

The aim of this study was to evaluate patient doses in two interventional cardiology laboratories over a period of 1 y in which the imaging devices were changed from image intensifier (II) to flat detector (FD). Dosimetric data from a total of 1040 coronary angiography (CA) procedures and 1087 percutaneous transluminal coronary angioplasty (PTCA) procedures were gathered. During the period studied with II imaging, median values of dose area product were 28 Gy cm(2) for CA and 57 Gy cm(2) for PTCA. In the first half of the year with FD imaging, median values were 37 Gy cm(2) for CA and 89 Gy cm(2) for PTCA. A significant increase in patient doses was noticed in the early stages of use of FD technology for imaging IC procedures, while fluoroscopy time and number of images remained similar. A careful setting of the X-ray systems, after upgrading the imaging system, is essential to avoid unjustified increases in patient doses.

Does a flat panel detector reduce the patient radiation dose in interventional cardiology?

An internal audit has been performed to evaluate the patient radiation dose in the clinical use of X-ray cardiac flat panel detector (FPD) systems. Fluoroscopy and image acquisition (cine mode) programs are optimised for low-dose settings. The diagnostic and therapeutic interventional cardiac procedures are performed at 6 pulse s(-1) for fluoroscopy and 15 frames s(-1) for image acquisition. The FPD entrance dose is configured for 29 nGy pulse(-1) in the fluoroscopy mode and 0.10 microGy frame(-1) in the cine mode. From the data collected, the following local reference levels for coronary angiography and angioplasty have been obtained: kerma-area products 23 and 44 Gy cm(2), cumulative doses 376 and 776 mGy, fluoroscopy times 5 and 15.5 min and cine images 617 and 1163 images.