Optical properties of scandium thin films

Selective Separation and Preconcentration of Scandium with Mesoporous Silica

Separation and preconcentration of scandium (Sc) were successfully achieved using a mesoporous silica support that showed good selectivity for this element. Unmodified mesoporous silica materials were used as an extracting medium in a solid-liquid extraction (SLE) process. Selectivity, extraction capacity, kinetics of extraction, and reusability under acidic conditions were investigated. The results demonstrate the potential of unmodified mesoporous silica materials for the selective separation and preconcentration of Sc. As no chelating ligand was grafted on the silica surface, which is often the case for most solid-phase extraction media for metal-ion separation, the experimental data allow us to hypothesize that the accessible silanols on the material surface are responsible for the selective Sc extraction. This interesting feature would drastically decrease the cost of solid-liquid extraction systems by using unmodified mesoporous silica materials. Moreover, a leachate solution obtained from a real rare-earth element ore was used to determine the performances of the proposed materials in a packed column configuration. The maximum Sc adsorption on the silica material surfaces is moderate (1 mg/g), but it is balanced by a great concentration factor (more than 100 times). The extraction performances are potentially promising, both in terms of selectivity and preconcentration, under the acidic conditions tested.

A review of the optical properties of alloys and intermetallics for plasmonics

Alternative materials are required to enhance the efficacy of plasmonic devices. We discuss the optical properties of a number of alloys, doped metals, intermetallics, silicides, metallic glasses and high pressure materials. We conclude that due to the probability of low frequency interband transitions, materials with partially occupied d states perform poorly as plasmonic materials, ruling out many alloys, intermetallics and silicides as viable. The increased probability of electron-electron and electron-phonon scattering rules out many doped and glassy metals.

Determination of optical constants of scandium films in the 20-1000 eV range

The transmittance of thin films of Sc deposited by evaporation in ultrahigh vacuum conditions has been investigated in the 20-1000 eV spectral range. Transmittance measurements were performed in situ on Sc layers that were deposited over grids coated with a C support film. Transmittance measurements were used to obtain the extinction coefficient of Sc films at each individual photon energy investigated. These data, along with the data available in the literature for the rest of the spectrum, were used to obtain the refractive index of Sc by means of the Kramers-Krönig analysis. Sum-rule tests indicated an acceptable consistency of the data.

Optical properties of scandium films in the far and the extreme ultraviolet

The optical properties of thin Sc films deposited in ultrahigh-vacuum conditions have been investigated in the 6.7-174.4-nm spectral range. We measured transmittance and multiangle reflectance in situ in the 53.6-174.4 nm spectral range and used these measurements to obtain the complex refractive index of a Sc film at every individual wavelength investigated. Transmittance measurements were made of Sc samples that were deposited over grids coated with a support C film. The transmittance and the extinction coefficient of Sc films at wavelengths shorter than 30 nm were measured ex situ. The ex situ samples were protected with an additional top C film before their removal from vacuum. To our knowledge, these are the first optical measurements of Sc films reported in the spectral ranges cited.